Sanotechnik N8100 User manual

INSTALLATION INSTRUCTIONS
N8100 / N8200 / N8400 / N8500

General Information
Please inspect the product immediately upon receipt for transit damage, missing packs/parts or manafactruing
fault. Damage reported later cannot be accepted. Please handle the product with care avoiding knocks and shock
loading to all sides and edges of the glass
Notes : Safety glass can not be re-worked.
Please read these instructions carefully before start of installation.
Specail care should be taken when drilling walls to avoid hidden pipes or electrical cabels.
Note : this product is heavy and may require two people to install.
Aftercare instrucions
After use, your shower should be cleaned with soap and water. This is particularly important in hard water distrcts
where insoluble lime salts may be deposited and allowed to build up.
Clearners of gritty or abraside nature should be used. Care should be taken to avoid contact with strong
chemicals such as organic solvents and strippers.
Glass cleaners can be used but with caution, if in doubt contact the manufacturer of the cleaner in question.
Please keep these instructions for aftercare and customer servies details.
Tools required
This product is heavy and may require two people to install.

Box contents
(1) Installation instruction
(2) 2 x brackets
2 x wall connect clips
2 x wall plugs
2 x screw M4x30
(3) 2 x wall plugs
2 x screw M4x25
2 x glass clips
(4) 1 x water deflector
(5) 1 x fixed panel

Assembly drawing
(1) 2 x brackets (5) 2 x screw M4x25
(2) 2 x wall connect clips (6) 1 x water deflector
(3) 2 x screw M4x30 (7) 2 x glass clips
(4) 1 x fixed panel (8) 4 x wall plugs

Installation steps

Ensure wall profile are plumb.
Adjust enclosure to be square and level.
Wheels should beadjusted to square the
doors and ensure smooth running.
Allow 24 hours for silicone to dry before use.