Santec PIANA I 4565HN10 User manual

TOWEL BAR &
TOILET PAPER HOLDER

PARTS BREAKDOWN
0 1
TOWEL BAR OR TOILET PAPER HOLDER
SET SCREWS (2)
L E F T
BAR POST
RIGHT
BAR P O S T
ACCESSORIES INSERT ( 2 )
MOUNTING HARD WARE POSTS ( 2 )
D R Y WA L L S C REWS ( 4 )
D R Y WA L L T O GGLES ( 4 )
ALLEN KE Y
SOLID WA L L A NCH O RS (4)

0 2
TOWEL BAR & TOILET PAPER HOLDER
Installing On Drywall
Remove the Mounting Hardware Post from the Bar Posts
by unscrewing it from the adapter and use them as
references for positioning. Make sure that the Bar is
level and the Bar Post positions are correct.
Installing On Wooden Sur face
For wooden sur face, the Mounting Hardware
Posts can be secured by threading the
Screws directly into the wall.
Mark the four screw hole positions by using the Mount-
ing Hardware Post.
Using a drill, pre-drill holes for the Dry Wall Toggles.
Fold the Dry Wall Toggle’s leg and insert it into the wall.
The Mounting Hardware Posts can be secured by screwing
the Screws into the Toggles.

Installing On Solid/Hard Surface
Measuring the Mounting Hardware Posts
Measure the dimensions carefully, mark the four screw hole positions by using
the Mounting Hardware Post.
Using a drill, pre-drill the holes.
Insert Anchors into the wall.
Secure the Mounting Hardware Posts by tightening the Screws into the An-
chors.
After assembling the first mounting Hardware Post at the desired height, slip one side
of the towel Bar into the Mounting Hardware Post and the second post on the wall.
mark above ,below, right, and left of the post with a pencil and remove the towel bar
assembly. Connect the two lines to find the center.
Place the center of the other Mounting Hardware Post over the mark and check with a
level to make sure the height of both is the same. When level and centered, mark the
screw hole positions.
0 3
TOWEL BAR & TOILET PAPER HOLDER

Securing In Position
Using the allen key provided, loosen the set screws.
Set the bar posts apart from each other onto a flat surface with
openings facing each other .
Position the flange on the mounting post hardware.
Screw the mounting hardware adaptor to the post hardware.
screw the mounting post to the flange.
Insert the towel bar into both left and right unsecured bar posts.
Make sure the towel bar assembly is fitted together securely.
Lift the towel bar assembly to the wall and align with the mounting posts.
Slip the towel bar assembly over the left and right mounting hardware posts.
Adjust the bar posts if necessary and secure by firmly tightening the
set screws with the provided allen key.
0 4
TOWEL BAR & TOILET PAPER HOLDER