Milestone Global Headquarters • 6436 City West Parkway • Eden Prairie, MN 55344 USA
Milestone AV Technologies and its aliated corporations and subsidiaries (collectively, “Milestone”), intend to make this manual accurate and complete. However, Milestone makes no
claim that the information contained herein covers all details, conditions, or variations. Nor does it provide for every possible contingency in connection with the installation or use of this
product. The information contained in this document is subject to change without notice or obligation of any kind. Milestone makes no representation of warranty, expressed or implied,
regarding the information contained herein. Milestone assumes no responsibility for accuracy, completeness or suciency of the information contained in this document.
©2017 Milestone AV Technologies. All rights reserved. SANUS is a division of Milestone. 3M and Command are trademarks of 3M®.
“We’ll look so good on your Echo
™
Dot!”
At SANUS, we hold our products to the highest of safety and quality standards,
and we proudly stand behind every product we make.
Made in the USA
Show us where
you put your Echo™Dot:
# SANUSSpeakerMount
Removing the Echo™Dot Base
Hold base firmly,
then “rock” the dot
out of the base.
Install the Echo™Dot Into the Base Removing the Echo™Dot from the Base
Align the plug with the channel
Remove the base by lifting up at the bottom.
Grasp the end of the Command™Strip and pull
DOWN slowly, until the strip releases from the wall.
DO NOT pull the strip AWAY from the wall.
