Satel XPRS Optimum User manual

SATEL XPRS Optimum IP radio router
•SATEL XPRS Optimum with encryption (YF0410)
•SATEL XPRS Optimum without encryption (YF0415)
Technical specification
Subject
Value
Frequency range
360 … 445 MHz
Tuning range
45 MHz (360 –405 / 400 –445)
Channel spacing
12.5 / 25 kHz selectable
Modulation
2, 4, 8, 16 QAM
Upgradable: 32 and 64 QAM
Interface
Ethernet, RS-232, RS-422/485
Operating voltage
+10.6 … +30 Vdc
Max. power consumption RX / TX
5.2 W / 15.8 W
Modulation/ Air speed / Sensitivity
(BER 10E-3)
4QAM: 40.3 kbps @ 25 kHz / -111 dBm
4QAM: 20.2 kbps @ 12.5 kHz / -113 dBm
16QAM: 80.6 kbps @ 25 kHz / -105 dBm
16QAM: 40.3 kbps @ 12.5 kHz / -106 dBm
Max. TX power (nominal)
37 dBm (5 W)
Mean: Average 30 dBm (1 W), max. 32 dBm (1.5 W)
PEP: Average 37 dBm (5W), max. 38 dBm (6.6 W)
Connectors
Power, RF (TNC female), ETH (RJ45), USB-A, USB-B,
2 x D9 female
Size RU+CU H x W x D (LED side view)
130 x 77.2 x 76.5 mm
Weight
940 g
Configuration of the technical parameters is easy with SATEL NETCO, centralized configuration
software.
NOTE! Web user interface for configuration and diagnostics is available only for standard SATEL
XPRS IP radios

LEDs
After powering the device Radio Unit starts ≤2.5 seconds and units STAT LED stops blinking. It takes
~2 minutes for the Central Unit to boot-up completely. During this time the STAT LED will blink at
the unit. The boot-up process can be viewed from the LCD user interface.
Typical setup
The figure below shows a typical setup when transferring data through the device. The
recommended minimum distance between the antenna and the central unit is 2 meters in order to
avoid degradation of the receiver sensitivity due to the radiated interference from the central unit.
LED Description
RX Receive data over radio
TX Transmit data over radio
RTS Request To Send, serial interface
CTS Clear To Send, serial interface
TD Transmit Data, serial interface
RD Receive Data, serial interface
STAT ON: power is on
PWR ON: power connected
LED Description
USB (for USB-A) Blinking: not connected. ON: connected
ETH Blinking: not connected. ON: connected
STAT ON: power is on. Blinking: unit starting
PWR ON: power connected

Pinning order for SATEL XPRS Optimum RS-232 interface
Pinning order for SATEL XPRS Optimum RS-485/422 interface
Pin nr
RS-485
RS422
Pin description
Pin name
Pin description
1
NC
-
-
2
NC
-
-
3
B
Receive/transmit data,
non-inverting
Transmit data, non-inverting
4
Y
-
Receive data, non-inverting
5
SGND
Signal ground, isolated
6
5V_TERM
Isolated 5 V for bus termination
7
NC
-
-
8
A
Receive/transmit data,
inverting
Transmit data, inverting
9
Z
-
Receive data, inverting
D9 SHIELD
-
Connected to device ground (non isolated)
Mounting options with installation parts
-WP0020 Installation parts for DIN rail, 2 pcs
-WP0019 Wall mount parts, 2 pcs
Pin nr
Pin name
Pin description
1
CD
Carrier Detected. See the radio unit user guide chapter 6.6.2
2
RD
Receive Data: data traffic from the RU to the DTE
3
TD
Transmit Data: data traffic from the DTE to the RU
4
DTR
DTR function is not in use in the RU
5
SGND
Signal Ground: the common voltage reference between the
DTE and the RU
6
DSR
Data Set Ready: an indication from the RU to the DTE that the
RU is powered on
7
RTS
Request To Send. See the radio unit user guide chapter 6.6.2
8
CTS
Clear To Send. See the radio unit user guide chapter 6.6.2
9
NC
Not Connected
D9 SHIELD
-
Connected to device ground

Product conformity
SATEL Oy hereby declares that SATEL XPRS Optimum IP radio router is in compliance with the
essential requirements (radio unit: radio performance, electromagnetic compatibility and electrical
safety / central unit: electromagnetic compatibility and electrical safety) and other relevant
provisions of Directive 2014/53/EU for radio unit and Directive 1999/5/EC for central unit. Therefore
the equipment is labelled with the following CE-marking.
Declaration of Conformity –certificates are available from the manufacturer’s web site:
www.satel.com
NOTE! This is a short form user guide for SATEL XPRS Optimum IP radio router. Complete user
guides for central and radio unit are available on SATEL web site.
SATEL Oy
Meriniitynkatu 17
FI-24100 Salo, Finland
Tel. [phone]
[email protected]
www.satel.com