Savage MF-6 User manual

MULTIFLEX LIGHT STAND
USER MANUAL
ITEM: MF-6 / MF-10
Videndum Media Solutions
2050 S. Stearman Drive, Chandler, AZ 85286 USASavageUniversal.com

1
2
3
A
C
E F
B
D
6
4
5
8
7
GETTING STARTED
Your MultiFlex Light Stand features an innovative, patented leg design
that provides extended functionality whether in a studio or location
environment. Individually adjustable leg sections allow for multiple
unique congurations.
• A bubble level ensures the stand remains level and secure.
• A Velcro strap makes securing and transporting the stand simple.
SETUP
1Release the Velcro strap from the stand column.
2Carefully fold all legs downwards.
3Slide the leg collars upwards to the desired height, then tighten locking
handles.
USES
A CORNERS
To use in a corner, adjust the single leg section so it is nearly vertical
and against the stand body. Loosen the top handle on the single leg (4),
and ip open the lock located midway down the leg (5). Slide the leg up
and push leg toward center column so that it is ush against the center
column (6). Lock both the top and middle leg locks. Place this leg in the
corner. Adjust the double leg section to medium height, and extend lower
leg sections to ensure levelness (7). Check bubble level (8).
BSTAIRS
Adjust the double leg section to be at a medium-high height on the
center column, and the single leg to a medium-low height on the center
column. Extend the lower leg section to reach the bottom step. Extend
lower leg sections on all legs as needed to ensure levelness. Check
bubble level.
CUNEVEN TERRAIN
Set both single, and double leg sections to a medium height on the
center column. Extend lower leg sections individually as needed to
provide maximum stability. Check bubble level.
DUNDER FURNITURE & OBSTACLES
Set the singular leg to a low height on the center column to clear the
obstacle. Unlock the single leg middle lock and push the leg downward
to lower it as needed. Secure middle lock. Extend lower leg sections on
all legs as needed to provide stability. Check bubble level.
EEXTRA STABILITY
When extra stability, or a larger footprint is needed, adjust all leg sections
to a low height for a lower center of gravity, and wider footprint. Users
can utilize the wide, at stand base on the ground for added support as
well. Adjust all leg sections to a low height, and extend lower leg sections
until level. Secure handles when base is resting on the ground. Check
bubble level.
PRECAUTIONS
• Sandbag weights are recommended with heavier loads.
• Max load when fully extended: 8lbs (3.6kg).
• Always secure stand with velcro strap when transporting.
• Use included tool (F) to tighten ip leg locks if the metal ttings become
loosened over time.
SETUP USES