Saveo Scan SAVEO-EMB-S12D User manual

SAVEO-EMB-S12D
Quick Setup Guide

Enter Configuration Exit Configuration
Command Barcodes
Scanning the Enter Setup Code can enable the engine to enter the setup mode. Then
you can scan a number of command codes to configure your scanner. To exit the
setup mode, scan the Exit Setup code.
Enter Setup Exit Setup
Important Notes:
All configurations need to go through below steps except Factory
Defaults. Scan “Enter Setup” → “Command Barcode” →”Exit Setup”
Restore Factory Default Configuration
Restore Factory Default Configuration

Enter Configuration Exit Configuration
Scanning Mode
Trigger Mode (Default)
Scanning this bar code will enable the scanner to enter manual trigger mode.
**Trigger Mode
Auto Sense Mode
Scanning this bar code will enable the scanner to enter auto sense mode.
Automatic Scanning Mode
Continuous Mode
This mode enables the engine to scan/capture, decode and transmit over and over
again.
Continuous Scanning Mode

Enter Configuration Exit Configuration
USB Interface (Optional)
USB HID-KBW
By default, the scanner is in HID mode as a Keyboard device. It works on a Plug and
Play basis and no driver is required.
**USB HID Keybord
USB COM Port Emulation
If you connect the scanner to the Host via a USB connection, the USB COM Port
Emulation feature allows the host to receive data in the way as a serial port does. A
driver is required for this feature
USB Virtual COM Port
Serial Port
Serial Port

Enter Configuration Exit Configuration
Serial Baud rate
9600(default)
19200
38400
57600
115200
230400

Enter Configuration Exit Configuration
Terminator Configuration
The scanner provides a shortcut for configuring the terminating character suffix to CR
or CRLF and enabl it by scanning the appropriate barcode below.
No terminator
CR/LF
**CR/Enter
Tab
Caps Lock
DisableEnable

Enter Configuration Exit Configuration
Same barcode reading
Do not re-read the same barcode
Interval reading
Arming Light
Enable when scanning
Enable Always
Disable