Saxby Lighting Prism Pendant Manual

• Rotate the ceiling cover clockwise over the fixing
brackettosecureinplace.SeeFig.3overleaf.
• It is recommended to secure product cable to
suspensioncablesusingcableties.
• Ensuretheweightoftheproductissupportedonthe
steelcablesandnottheelectricalflex.
• Replace fuse or circuit breaker and switch on. Your
lightisnowreadyforuse.
• TheLEDmoduleinthisfittingisnon-replaceable.
Commissioning
Fitting/replacing bulbs
Instructionleaflet
Prism Pendant
70426
www.saxbylighting.com
Live Voltages may be present in this unit even when turned off or when completely disconnected.Foryoursafety,
alwaysswitchoffthesupplybeforechanginglightbulbs,orcleaning.
Wasteelectricalproductsshouldnotbedisposedofwithhouseholdwaste.Pleaserecyclewherefacilities
exist.CheckwithyourLocalAuthorityorretailerforrecyclingadvice.
Recycling advice
Safety information
SaxbyLightingLtd.BH233PE
Werecommendcleaningwithasoftdrycloth.
Donotusesolventsorabrasivecleanersasthesecoulddamagethefinish.
Iss.123062016

Thankyouforpurchasingthislightfitting.Pleasereadtheinstructionscarefullybeforeusetoensuresafeand
satisfactoryoperationofthisproduct.Pleaseretaintheseinstructionsforfuturereference.
Warning
This is a Class 1 product and must be earthed.
Pleasereadtheseinstructionscarefullybefore
commencinganywork.
Thisunitmustbefittedbyacompetentandqualified
electrician.
InstallinaccordancewithIEEWiringregulationsand
currentBuildingRegulations.
Topreventelectrocutionswitchoffatmainssupply
beforeinstallingormaintainingthisfitting.Ensure
otherpersonscannotrestoretheelectricalsupply
withoutyourknowledge.Ifyouareinanydoubt,
pleaseconsultaqualifiedelectrician.
Ifreplacinganexistingfitting,makeacarefulnoteof
theconnections.
Wasteelectricalproductsshouldnotbedisposedof
withhouseholdwaste.Pleaserecyclewherefacilities
exist.Checkwithyourlocalauthorityorretailerfor
recyclingadvice.
ThisproductisratedatIP20.
Thislightfittingcontainsnon-replaceablepartsand
cannotbeserviced.
Ifdamageoccursthepartshouldbediscarded.
Thisproductisnotdimmable.
Theinstallationofthisfittingwillbemucheasierwith
thehelpofanassistant.
Specification
Voltage: 240V50Hza.c.
Lamp: 14WLEDModule(4000K/1060lm) 
IPrating: 20
Layout
• Ensuretheceilingiscapableofholdingtheweightof
theproduct.
• Planthedesiredlayoutofthisfittingcarefully,
ensuringthecableswillreachthedistancebetween
thejunctionboxandlightfitting.
• Themainssupplycablemusthaveaminimumcross
sectionalareaof1.0mm2.
Existingfittingsmustbecompletelyremovedbefore
installationofanewproduct.Before removing the
existing fitting, carefully note the position of each set
of wires.
• SeeFig.1.Thisproducthastwoouterceilingfixing
points.Checkandmeasurethedistanceforthefixing
holessothefixingcableshangvertically.Optimum
distancebetweensuspensioncablesis1100mm.
Ensuretheceilingiscapableofholdingtheweightof
theproduct.Takecaretoavoiddamaginganywiringor
pipes.Drilltheholesandfitthesuppliedwallplugs.
• SeeFig.1.Attachthesuspensioncablestotheceiling
byunscrewingthetopcablefixing(1)andplacingthe
screwthroughthehole.Screwintowallpluginthe
ceiling.Reattachthebottomsection(2)ofthetopcable
fixingandtightentosecureinplace.
•SeeFig.2.Fitthesuspensioncablestotheproduct
byattachingthelowercablefixing(3)inplace.Simply
screwthelowercablefixingontothethreadedrodsat
eachendofthependant.Toadjusttheheightofthe
fitting,depressthebutton(4)locatedonthelowercable
fixing.Pleaseensurethesuspensioncableprotrudes
atleast10mmfromthelowercablefixing.Ensurethat
bothsuspensioncablesareadjustedtothesamelength
sotheproducthangslevel.
• SeeFig.3.Decideonthelocationofthefixingbracket.
Markthepositionofanddrillthefixingholes.Takecare
toavoiddamaginganywiringorpipes.Attachthefixing
brackettotheceilingwiththesuppledwallplugsand
screws.
• Wireasdetailedbelow.
Installation
Wiring
Check that...
• Youhavecorrectlyidentifiedthewires
• Theconnectionsaretight
• Noloosestrandshavebeenleftoutoftheconnection
block.
Havingcorrectlyidentifiedthewiringfromyourexistinglightfitting,connecttotheconnectionblockinsidethe
productinthefollowingway:
Fig. 1
Fig. 2 Fig. 3
1
2
3
4