Page 10
PRODUCT MANUAL Password Voice Recorder : SB-VR8204
www.SafetyBasement.com Phone: 877-345-2336 Fax: 888-236-2524
SET PASSWORD..continued
CHANGING PASSWORD (continued):
11. On the next screen you will be asked for a SECOND PASS-
WORD, which is really asking you to conrm your password by
entering it again. Do it on this screen.
Re-enter password then press MODE to conrm it.
12. You will see WRITE OK! Which means your new password
has been conrmed to match your rst one and you now have a
new password.
PLEASE WRITE THIS PASSWORD SOMEWHERE INCASE
YOU FORGET IT
REMEMBER:
1. At any point while you are setting up your recorder, use the DEL button to go back one level.
2. If your recorder turns o HOLD the REC button to turn it back on.
3. Aer you have done your settings, dont turn it o using system power switch. Instead let it turn
o by itself or press and hold the REC button to turn it o. is way you wont lose your settings.
Turning unit o via ON/OFF switch will also make you lose all your custom settings and you will
have to do it over again! Not fun if you did a lot of custom settings!
Screen/Backlight turn o time:
You may have noticed that the screen light turns o pretty quickly aer about 10 seconds. is
could be a bit annoying. Here is a way to extend that turn o time to atleast 30 seconds:
1. Turn device on. If screen is o press any button once or if it is totally o pres and hold the
REC button unitl screen turns on.
2. Aer enterign password (if it is enabled), press and hold the MODE button until the for set-
ting icons appear.
3. highlight and select the SETTING MODE
4. Use NEXT or PREV buttons to scrol o and highlight BACKLIGHT. Press MODE to select.
5. Use the PREV or NEXT button to select he number of seconds you want the backlight to stay
on before turning o. en press MODE to go back one. You are all set. Now your screen light
will stay on a little longer especially during set up!
