Scale FR10A Instruction manual
SCALE
www.scale-tech.net
FR15A
FR12A
FR10A
QUICK START MANUAL
1. Connecting the loudspeaker
Make sure that the voltage of your power wall socket ts to the voltage requirements of the speaker
( + /- 10%) before switching on the system.
Connect the speaker only with the original power mains cable to the wall socket before switching
on the system. Disconnect the speaker from the wall socket/ mains supply, if the system has been switched o.
All other cables (XLR) should be connected or disconnected only if the speaker is switched o. Use shielded cables only.
Do not use damaged cables. Damaged or wrong type of cables could destroy parts or the whole system.
Check your cables before you use the system.
All cables should be connected internally as per following instructions to ensure a safe operation of the system:
Signal cable with XLR connectors
Cable for inputs and loop outputs.
Signal cable with
T
S jack connectors
Cable for inputs.
2. Technical specications
sow
T
° °
I
sow
T
° °
sow
T
° °
4. Connection panel and controls
NOCE:
The connection panel for FR12A and FR15A are the same.
FR10A has just 1 input, and no mix output.
T
INPUTS
MIX OUTPUT
DSP
DSPCONTROL
FR12A
s
SCALE
CE
E
E CK
SCALE
www.scale-tech.net
SCALE by ScaleNordic AS
Adress: Nedre Storgate 23, 3015 DRAMMEN, NORWAY
Phone: +47 32 20 83 30
Mail: info@scale-tech.net
Web: www.scale-tech.net
Limited liability on contents. Subjects to change without prior notice.
All rigAll rights reserved © 2019.
This manual suits for next models
2
Table of contents
Other Scale Speakers manuals
