Scheer LV 660A User manual

MP-000068 - A
1
Serial Number:
Model:
INSTRUCTION MANUAL FOR LV 660A
Operator/Tech Manual:
Local Sales & Service Agent:
Proline Equipment
Unit T1/25 Narabang Way,
Belrose NSW 2085
Australia
Ph. [phone]
Email. [e-mail]
Scheer Churrasqueiras e Acessórios Ltda
Fone: [phone] ou [phone]
Roque Callege Street, 133 –B: Universitário.
95041-440 –Caxias do Sul –RS –Brazil
[email protected]om.br
scheer.com.br

MP-000068 - A
2
WARNING: Improper installation, adjustment, alteration, service or maintenance can cause
property damage, injuryor death. Read the installation, operating and maintenance instructions thoroughly
before installing or servicing this equipment. Maintenance and servicing must be authorized by the
manufacturer who will advise correct service company.
WARNING FOR YOUR SAFETY: Do not use or store gasoline or other flammable vapors or
liquids in the vicinity of this or any other appliance.
WARNING: Do not spray aerosols or combustible oils in the vicinity of this appliance while it is
in operation.
SCHEER CHURRASQUEIRAS E ACESSÓRIOS
CONGRATULATIONS!
You have just purchased a product with the latest technology, performance and design.
Now, it will be much easier and faster for you to prepare your roasts. SCHEER
CHURRASQUEIRAS E ACESSÓRIOS LTDA thank you for your choice.
So that your Roasting Equipment may reach its best performance, read this manual
carefully and follow the instructions correctly. Should you have any doubts and/or
suggestions contact Scheer Churrasqueiras. Highly skilled professionals will be at your
disposal.
Scheer Churrasqueiras e Acessórios Ltda
Phone: [phone] or USA Office Cell: [phone]
Roque Callege Street, 133. Universitário. Zip Code 95041-440
Caxias do Sul –RS –Brazil
[email protected]
scheer.com.br

MP-000068 - A
3
CONTENT
IMPORTANAT INFORMATION.............................................................................4
INTRODUCTION TO OPERATOR..........................................................................4
SAFETY RULES........................................................................................................5
TRANSPORT.............................................................................................................5
REMOVING FROM ITS PACKAGE........................................................................7
DESCRIPTION ..........................................................................................................8
INSTALATION..........................................................................................................9
PLACE OF INSTALATION....................................................................................10
LV 660A:..................................................................................................................11
PILOTS/BURNERS LIGHTING PROCEDURE ....................................................11
WATER AND GAS INSTALATION......................................................................12
LAVA ROCK INSTALATION ...............................................................................13
ADJUSTS AND CHECKING..................................................................................14
PLACING THE GRILLS .........................................................................................15
PREVENTIVE MAINTANACE..............................................................................17
REMOVING BURNERS .........................................................................................17
CHANGING THERMOCOUPLES .........................................................................18
ACCESSING THE BACK SIDE .............................................................................18
BACK VIEW............................................................................................................19
ELETRICAL DIAGRAM ........................................................................................19
CLEANING..............................................................................................................20
EXTRA INFORMATION........................................................................................21
WARRANTY ...........................................................................................................22
MAINTANACE .......................................................................................................23
PROBLEMS FOUND: .............................................................................................23

MP-000068 - A
4
SCHEER CHURRASQUEIRAS E ACESSÓRIOS
IMPORTANAT INFORMATION
•Keep this manual for future information in an easily accessible location;
•Installation of the product is the responsibility of the buyer. The installation must be
carried out in accordance with the manufacturer's instructions and carried out by
qualified and competent persons;
•In the case of repairs, use only service authorized by the manufacturer and ask for
original or quality spare parts;
•Failure to operate this equipment could endanger the product and the operator of the
equipment;
•For technical assistance nearest you, contact a trusted distributor or directly with the
manufacturer;
•The manufacturer reserves the right to change this manual at any time;
•This equipment must be installed in accordance with the local regulations and codes
of the destination;
•Keep this product out of the reach of children especially after use when the grill is
cooling;
INTRODUCTION TO OPERATOR
•This manual contains technical information for the correct installation and operation
of this equipment. The operator of the equipment has the duty and responsibility to
follow the correct instructions;
•Before using this equipment, it is necessary to consult this manual. We recommend
strict reading and that the instructions are strictly followed. Keep the manual in
perfect condition;

MP-000068 - A
5
•This manual is part of the equipment and should be stored in a location that is easily
accessible and known to all operators and is also available to anyone responsible for
maintenance;
SAFETY RULES
•Read and understand all instructions in this Manual before operating your LV 660A;
•The LV 660A Grill is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or by persons lacking experience
and knowledge, unless instructed to use the appliance or Supervision of a person
responsible for their safety;
•Always use the equipment with care and attention.
•The power cord should be examined regularly to detect possible damage. If it is
damaged, it must be replaced by the manufacturer, authorized agent;
TRANSPORT
•Check for any signs of knocks, drops or malfunctions check with the persons
responsible for the transport and contact the Scheer sales department;
•The risks of transportation are the customer's responsibility. Any claim for damages
during transportation must be made at the time you receive the product, it must be
communicated to the carrier and also to the manufacturer of the product;
•As soon as you remove the product from the packaging, make a visual inspection to
check for possible damage during transportation;
•We recommend special care during this inspection to identify possible damage
during transport;

MP-000068 - A
6
ilustrative image only

MP-000068 - A
7
REMOVING FROM ITS PACKAGE
The unit must be unloaded in a flat and firm place can be started the removal of the
barbecue from the packaging. After removing the top, side, front and rear cover, remove the
machine from the pallet, we recommend the use of a forklift.
Ilustrative image only
Remove the top part
Remove the sides,
front and back parts

MP-000068 - A
8
DESCRIPTION
Parts & Accessories:
• 1 unit;
• 1 manual;
Characteristics:
• Stainless steel AISI304 brushed or AISI430 brushed (as requested) and carbon steel;
• AC input 240V 50Hz;
• Water protection: IPX 1
• Motor 24 VCD
• 100-240VAC -1 A Power 25W
• Semiautomatic firing;
•Stainless steel or carbon steel Grills;
Types of Gas Used:
LP or Natural Gas (as requested);
Gas consumption (m³ / h):
• Gas: Each burner consumes 0.3125 (m³ / h) of gas per hour at a pressure of 0.8 kPa
Natural Gas or 2.6kPa for LPG measured at the manifold test point (see location of this test
point on page14 detail D).
Rated Power per Burner:
• 16.880 MJ/h;
Energy consumption:
• Electrical power: 0,01 kWh -100-240VAC

MP-000068 - A
9
INSTALATION
• This installation must conform according local codes (AS/NZS 5601). In the
absence of local codes, the installation must conform to the National Fuel Gas Code, ANSI
Z223.1, Natural Gas Installation Code, CAN/CGA-B149.2, or the Propane Installation Code,
CAN/CGA-149.2. For installation under ventilation hood only. The manufacturer is not
responsible for installation. After all connections and installation is in conformity with this
manual, starting pilot/burners lighting procedure;
• Remove the Gas Barbecue from the packaging;
• The Gas Barbecue should be installed under a vented hood and need air circulation;
• Make sure the Gas Grill is levelled;
• The up and down grill motor requires 240 volt power. (Check that the voltage is
correct);
• Make sure all removable components are properly secured: burners, pilot, protective
cover, bars, stones, manifold. Pressure in 0.8kpa Natural Gas or 2.6kPa for LPG measured at
the manifold test point (see location of this test point on page14 detail D);
• Gas installation should be done taking into account the number of burners in the Gas
Barbecue. Each burner consumes 0.3125 (m³/h) of natural gas. Therefore, the gas battery
must be made according to the flow capacity required by the burners (0.3125 (m³ / h);
• Each burner corresponds to: 16.880 MJ/h;
• For installation a gas regulator gas valves must be used; for units with 1 meters there
is one gas inlet so just one valves will be used and for larger than 1 m units two gas inlets
will have in your unit so it is necessary two gas pressure regulator valves;
Natural Gas
• Consult the technical specifications of the barbecue and call a technician specialized
in gas; (Preferably the same as the contracted gas company);
• The natural gas cannot be strangled from the pressure gauge (clock) to the entrance
of the machine;

MP-000068 - A
10
• Before turning the machine on, fill the water tank with approximately 10 cm from
the bottom of the tray.
PLACE OF INSTALATION
• The appliance should be installed 50mm clearances from other appliances &
combustible materials. Never obstruct the top, especially with furniture or any other material,
as the equipment will not function properly and there is a risk of fire;
• The appliance clearance is 50mm away from other appliances;
CAUTION: Do not use in outdoor locations. Do not install and use exposed to
weather.
• For electrical installation and recommended a separate electric circuit with a 5A
circuit breaker exclusive to the barbecue;
• Always seek the assistance of a qualified professional;
(Electrician) to make any kind of modification / adequacy in the electrical network;

MP-000068 - A
11
LV 660A:
Front pannel:
PILOTS/BURNERS LIGHTING PROCEDURE
1. Turn the gas control knob of the Pilot to OPEN/ON position;
2. Keep the red button pressed which open the gas flow through the Automatic Shut
off gas valve. Hold the red button down and press the Ignition button several times
until pilot is on;
3. Keep the red button for about 1 minute, this way the gas will take all air out from
tubes. When the gas knob in release, the pilot flame should continue to burn (If
not, repeat the above step);
4. Rotate the gas burners control knob to OPEN/ON position;
5. Allow 5 minute complete shutoff period before the appliance is relighted;

MP-000068 - A
12
WATER AND GAS INSTALATION
• All components for gas and hydraulic supply must be purchased separately by the
customer, the gas valve is attached to the grill and must not be removed or replaced with
another model;
Machine length up to 1m has one gas inlet, machines length bigger than 1m have
two gas inlets
Water
inlet ½ BSP
Eletric
al cord
Ga
s inlet ¾
BSPT
Ga
s inlet ¾
BSPT

MP-000068 - A
13
LAVA ROCK INSTALATION
• Distribute the lava rocks evenly over the grid covering the entire surface; Lava rocks
are best changed every 2-4 weeks or washed for 2nd use, when they start to break down &
crumble stop use.
Length
Qty Lava rock (kg)
1000
12
1200
14,4
1500
18
1800
21,6
2000
24

MP-000068 - A
14
ADJUSTS AND CHECKING
• To gain access to these set points remove the top front panels;
• In figure "A" Thermocouples are a factory fitted part in a fixed position 1cm above
the pilot tube & shall not be altered from the design position.
• In figure "B" is the adjustment of the air aeration of the burners considering
Universal LPG; this is the regulation provided by the manufacturer when you order Universal
LPG gas.

MP-000068 - A
15
• In figure "C" is the adjustment of the air aeration of the burners considering Natural
Gas; this is the regulation provided by the manufacturer when you order this unit for Natural
gas.
• Observe if the flame is totally blue this is the ideal point of burning and better
performance of your barbecue;
• If the flame is yellow this indicates that it is missing air for total gas burning that is
achieved by regulating the gas and air intake (figure "B",”C”). If the window is closed,
causing a small amount of air to enter, the flame obtained will be yellow, because it will have
little oxygen to carry out the complete combustion. If the regulation of the gas-air mixture is
adequate, we get a blue flame;
• See the table below for the characteristics of each:
Yellow flame
Blue Flame
Not enough air quantity (closed
window)
Satisfactory gas-air mixture
Uneven format
Even format
Cool flame
Hot flame
Carbon presence
Drack blue and light blue
It produces soot
It does not produce soot
• In figure "D" is the pressure test point Gameco TP06 of the gas circuit, the indicated
for natural gas is 0.8 kPa and for universal LG gas it is 2.6 kPa measured at the manifold test
point (see location of this test point on page14 detail D).
PLACING THE GRILLS
First place the upper grill after the lower grill and finally the fat collector.
NOTE: The amount of grille varies according to the size of the machine.
• Installer to fully test operation of the appliance after installation.

MP-000068 - A
16
•If all installation procedures have been followed & the appliance is not operating
correctly please contact the service agent (details on front page of manual).
Rest
vegetable grill
Main grill

MP-000068 - A
17
PREVENTIVE MAINTANACE
Gas System:
Check once a week if the burners do not show any irregularities such as:
• Not working or working partially;
• If there is a problem remove the burner and clean the burner with a needle;
• If the burner continues with the low flame check that the nozzle is not with the gas
outlet blocked and clean with a needle;
REMOVING BURNERS
• Wait for the machine to be completely cold remove the stones, bars from the large,
the grill holder and remove the burner;
Caution: The gas system malfunction may influence the taste of the meat.

MP-000068 - A
18
CHANGING THERMOCOUPLES
CESSING THE BACK SIDE

MP-000068 - A
19
BACK VIEW
ELETRICAL DIAGRAM

MP-000068 - A
20
CLEANING
Water tank:
• Drain (change the water) and clean every day.
• Cleaning of Volcanic Stones:
• The stones need to be changed every 2-4 weeks or washed for daily use or about
when they start to break.
• The stones should dry naturally after washing.
• Do not put wet stones in the machine.
• After the wash, replace the stones evenly over the grill and leave the grill working
for 10 minutes over low heat to make sure the stones are completely dry.
• It is recommended to wash the volcanic stones should be washed with warm water
and degreasing.