SDI E-CLIK User manual

SDI-IM-2051005.v2 E-CLIK Jeep ALL User Guide Page 1of 2
User Guide for E-CLIK Switches Controlled
1. Power On
a. Turn on the vehicle ignition.
b. Wait until LEDs light up on both Front and Rear Shock Adjustment Switches.
The E-CLIK System is on.
2. LED Lighting
a. LED lights on the Front and Rear Shock Adjustment Switches will be lit once the E-CLIK system
is on.
b. Blinking LED lights on the Front and Rear Shock Adjustment Switches indicate an error
occurring on the E-CLIK system:
oEach blinking sequence corresponds to a type of error, please refer to the Error Code Chart
below (page 2) and follow instructions.
oNote: When an error is occurring, the E-CLIK system error mode sets all Front and Rear
shocks to a firm setting for safety until the error is fixed, and the E-CLIK System is rebooted.
3. Front Shock Adjustment Switch (F)
Make sure vehicle is stopped before operating switches.
a. Front Shock Adjustment Switch in “Sport” or “Firm” position (F1)
sets front shocks to a firm setting.
b. Front Shock Adjustment Switch in “Medium” position (F2)
sets front shocks to a medium setting.
c. Front Shock Adjustment Switch in “Comfort” or “Soft” position (F3)
sets front shocks to a soft setting.
4. Rear Shock Adjustment Switch (R)
Make sure vehicle is stopped before operating switches.
a. Rear Shock Adjustment Switch in “Sport” or “Firm” position (R1)
sets rear shocks to a firm setting.
b. Rear Shock Adjustment Switch in “Medium” position (R2)
sets rear shocks to a medium setting.
c. Rear Shock Adjustment Switch in “Comfort” or “Soft” position (R3)
sets rear shocks to a soft setting.
F1
F2
F3
R1
R2
R3
F
R

SDI-IM-2051005.v2 E-CLIK Jeep ALL User Guide Page 2of 2
5. Error Code Chart