Sealey SB1 Operator's manual

SOUNDBAR WIRELESS RECHARGEABLE
MODEL NO: SB1
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY
1.1. GENERAL
9Read instructions before use
9Indoor use only
8DO NOT leave batteries in a discharged state. Before storage remove batteries.
1.2. BATTERY SAFETY
WARNING! To reduce the risk of burns or re:
8DO NOT attempt to open the batteries.
8DO NOT crush, puncture, short contacts or dispose of in re or water.
8DO NOT expose to temperatures above 60°C (140°F).
9Recycle or dispose of used batteries as stipulated by local regulation.
9 If the electrolyte in the batteries gets on your skin or in eyes, rinse thoroughly with cool water and seek immediate medical attention.
2. INTRODUCTION
Stylish and modern sound bar is nished in a nicely painted anthracite grey. Can play your favourite music easily from your smart phone
or tablet either by wireless technology, AUX in via an AUX cable (1mtr AUX cable supplied) or even takes a micro SD card. (Micro SD not
supplied). 2 Channel sound bar includes a pair of 2” speakers and 1 vibrating diaphragm for added sound quality. Base is mounted on 2 sturdy
feet with high grip foam pads which helps dampen any vibration. Charges from a USB cable. (USB cable included).
3. SPECIFICATION
Battery: ................................................................ 3.7V 1.5Ah
Charging Time:..................................................................2hr
Model No: ....................................................................... SB1
Nett Weight: ................................................................... 790g
Running Time (min):..........................................................4hr
Speaker Output:......................................................RMS: 6W
4. OPERATION
4.1. CONNECTIONS
4.2. WIRELESS CONNECTION
4.2.1. To pair the SB1 with your Smartphone or other Wireless
enabled device turn on the speaker. Enable the wireless
function on your smartphone or other wireless enabled device
and hit scan for SB1. When found choose it from the list.
If prompted to, input password, use password 0000. Once
successfully paired, select the SB1 from the list of paired devices
and select to connect.
g.2
g.1
g.3
Micro SD Card
SB1 Issue 2 (1) 04/04/19
Original Language Version
© Jack Sealey Limited
Refer to
instructions

4.3. AUX IN (FIG.4)
4.3.1. Use the provided AUX cable (3.5mm) to directly connect Smartphones,
tablets,and other music devices. Switch to line AUX IN by long
pressing (mode/play/pause) on the panel (g.1).
4.4. MICRO SD CARD INPUT (FIG.3)
4.4.1. Insert the Micro SD Card into the device, and then you can enjoy
music. The Micro SD Card will only go into the slot one way. DO NOT
force the card into the slot. Switch to Micro SD Card by long pressing
(mode/play/pause) on the panel (g.1).
4.5. INDICATOR LIGHT (FIG.1)
4.5.1. FAST BLINKING BLUE LIGHT; Pairing mode looking for Wireless
device.
4.5.2. BLUE SOLID LIGHT; Device successfully paired.
4.5.3. BLINKING BLUE LIGHT; Wireless play.
4.5.4. SOLID GREEN LIGHT AND BLINKING BLUE LIGHT; Micro SD Card
Mode.
4.5.5. GREEN SOLID LIGHT; Line IN Mode.
4.5.6. RED SOLID LIGHT; Charging state.
4.5.7. RED LIGHT GOES OUT; Charging completion
5. TROUBLESHOOTING
Issue Possible Causes Solution
No sound or distorted sound 1. Low battery
2. The volume is set to the minimum level.
1. Charge the device
2. Turn up the Volume
The buttons on the unit are not working or
the device doesn’t respond
Flat battery Charge the device
g.4
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500 01284 703534 [e-mail] www.sealey.co.uk
ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
WEEE REGULATIONS
Dispose of this product at the end of its working life in compliance with the EU Directive on Waste Electrical and Electronic Equipment
(WEEE). When the product is no longer required, it must be disposed of in an environmentally protective way. Contact your local solid
waste authority for recycling information.
Note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice.
Important: No Liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim.
SB1 Issue 2 (1) 04/04/19
Original Language Version
© Jack Sealey Limited