1/8” (3.2mm)
08-071619
Slide the Cable Gland cover
onto the plastic base making
sure that all four bolt holes
line up.
Slide the Cable Gland cover
over the electronic cable.
Apply marine adhesive
sealant to the four allen
head screws and tighten.
Wrap the tapered plug
around the electronic cable.
Insert the electronic cable
and tapered plug into the
plastic base.
Remove the Cable Gland
cover and tapered plug.
Using a sharp razor blade
or knife, cut the tapered
plug from the cable hole
outward.
Remove the four screws
using a 2.5 mm allen wrench.
• Make sure that you do not drill
within 1/8” (3.2mm) from the
edge of the tapered plug.
• A slightly larger drill bit is
needed for drilling the rubber.
TIP#1
8
6A
12 13 14
7910
11
800-655-7922
www.seaviewglobal.com
Insert drill tube into drill motor, and leave enough length to
get through the tapered plug.
1 2
Take one of the four drill tubes
(included with the Cable Gand).
Double check to make sure the
tube is the right diameter for
your installation.
Apply small amount of
soapy water to the tube and
slowlydrill the Cable Gland.
3
If using the a drill bit, the drill
should be run repeatedly
through the rubber.
6B
