4. Sensors directly control actuators
5. Actuators control other actuators
6. Remote controls send signals to static controllers to trigger scenes or other actions
7. Remote controls control other actuators.
There are two different role a controller can have. There is always one single primary controller that is managing the
network and including/excluding devices. The controller may have other functions - like control buttons - as well. All other
controllers don't manage the network itself but can control other devices. They are called secondary controllers. The
image also shows that its not possible to operate a sensor just from a remote control. Sensors only communicate with
static controllers.
Product description
The SSR302 is a wirelessly controlled double Relay switch to operate loads up to 3A / 230 V. It is used to
control warm water boilers or magnet valves. The device can be operated locally using two buttons. A LED
indicated the current switching status. The fashionable design of the device allows mounting it on visible
positions in the home. The device is IP 30 rated.
Batteries
The unit is operated by batteries. Use only batteries of correct type. Never mix old and new batteries in the
same device. Used batteries contain hazardous substances and should not be disposed of with household
waste!
Battery Type: 1 * CR2
Installation Guidelines
Installation and connection of the receiver should only be carried out by a suitably qualified person.
To remove the backplate from the receiver, undo the two retaining screws located on the underside; the
backplate should now be easily removed. Once the backplate has been removed from the packaging,
ensure the receiver is re-sealed to prevent damage from dust, debris etc. The backplate should be fitted with
the wiring terminals at the top and in a position which allows a total clearance of at least 50mm around the
receiver.
Direct Wall Mounting
The receiver should ideally be located near an existing power supply within an easy wiring location to the
items being switched. Offer the plate to the wall in the position where the receiver is to be mounted,
remembering that the backplate fits to the left hand side of the receiver. Mark the fixing positions through the
slots in the backplate, drill and plug the wall, then secure the plate in position. The slots in the backplate will
compensate for any misalignment of the fixings.
Wiring Box Mounting
(c) 2012 Z-Wave Europe GmbH, Goldbachstr. 13, 09337 Hohenstein-Ernstthal, Germany, All rights reserved, www.zwaveeurope.com - pp 2
