Security Camera King PWR-POE-16 User manual

16/24-Port PoE Switch Web Config Manual
V1.0.1

Important Safeguards and Warnings
Please read the following safeguards and warnings carefully before using the product in order to avoid
damages and losses.
Attentions:
Do not expose the device to lampblack, steam or dust. Otherwise it may cause fire or electric shock.
Do not install the device at position exposed to sunlight or in high temperature. Temperature rise in
device may cause fire.
Do not expose the device to humid environment. Otherwise it may cause fire.
The device must be installed on solid and flat surface in order to guarantee safety under load and
earthquake. Otherwise, it may cause device to fall off or turnover.
Do not place the device on carpet or quilt.
Do not block air vent of the device or ventilation around the device. Otherwise, temperature in
device will rise and may cause fire.
Do not place any object on the device.
Do not disassemble the device without professional instruction.
Warning:
Please use battery properly to avoid fire, explosion and other dangers.
Please replace used battery with battery of the same type.
Do not use power line other than the one specified. Please use it properly. Otherwise, it may cause
fire or electric shock.
Special Announcement:
This manual is for reference only.
All the designs and software here are subject to change without prior written notice.
Always follow the instructions listed on the manual. We are not liable for any problems caused by
unauthorized modifications or attempted repair.
All trademarks and registered trademarks are the properties of their respective owners.
If there is any uncertainty or controversy, please refer to the final explanation of us.
Please visit our website for more information.

Regulatory Information
The regulatory information herein might vary according to the model you purchased. Some information is
only applicable for the country or region where product is sold.
FCC Information
CAUTION
Changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment.
FCC conditions:
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions:
This device may not cause harmful interference.
This device must accept any interference received, including interference that may cause undesired
operation.
FCC compliance:
This equipment has been tested and found to comply with the limits for a digital device, pursuant to part
15 of the FCC Rules. This equipment generate, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the guide, may cause harmful interference to radio
communication.
For class A device, these limits are designed to provide reasonable protection against harmful
interference in a commercial environment. Operation of this equipment in a residential area is
likely to cause harmful interference in which case the user will be required to correct the
interference at his own expense.
For class B device, these limits are designed to provide reasonable protection against harmful
interference in a residential installation. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV technician for help.

Table of Contents
1Overview..........................................................................................................................- 6 -
1.1 Product Introduction.....................................................................................................................- 6 -
1.2 Product Features ...........................................................................................................................- 6 -
2Device Structure..............................................................................................................- 7 -
2.1 Structure of Switch.......................................................................................................................- 7 -
2.1.1 24 Ports Switch Front Panel...................................................................................................... - 7 -
2.1.2 16 Ports Switch Front Panel...................................................................................................... - 7 -
2.1.3 Rear Panel................................................................................................................................. - 8 -
3Log in Switch...................................................................................................................- 9 -
3.1 Switch Login.................................................................................................................................- 9 -
3.2 WEB Interface Introduction .........................................................................................................- 9 -
3.2.1 Port Info Display Section........................................................................................................... - 9 -
3.2.2 Navigation Bar ........................................................................................................................ - 10 -
3.2.3 Config Display Section ............................................................................................................ - 10 -
4System Config................................................................................................................ - 11 -
4.1 System Config Overview............................................................................................................- 11 -
4.1.1 System Info ............................................................................................................................. - 11 -
4.1.2 Current Time........................................................................................................................... - 12 -
4.1.3 CPU Usage .............................................................................................................................. - 12 -
4.2 Network Config..........................................................................................................................- 12 -
4.3 DHCP .........................................................................................................................................- 13 -
4.4 Software Upgrade.......................................................................................................................- 14 -
4.5 Password Change........................................................................................................................- 14 -
4.6 Restore Default...........................................................................................................................- 15 -
4.7 System Reboot............................................................................................................................- 15 -
4.8 Log Information..........................................................................................................................- 16 -
5Port Management..........................................................................................................- 17 -
5.1 Port Config .................................................................................................................................- 17 -
5.2 Port Mirroring.............................................................................................................................- 18 -
5.3 Port Statistics..............................................................................................................................- 20 -
5.4 Port Speed Limit.........................................................................................................................- 21 -
5.5 Broadcast Storm Control ............................................................................................................- 23 -
5.6 Long Distance Transmit..............................................................................................................- 25 -
6Device Management......................................................................................................- 28 -
6.1 Ring Network .............................................................................................................................- 28 -
6.1.1 STP Definition ......................................................................................................................... - 28 -

6.1.2 Basic Concepts of STP............................................................................................................. - 28 -
6.1.3 STP Bridge Settings ................................................................................................................. - 30 -
6.1.4 STP Port Settings..................................................................................................................... - 30 -
6.2 VLAN Settings...........................................................................................................................- 31 -
6.2.1 VLAN Definition ...................................................................................................................... - 31 -
6.2.2 VLAN Function ........................................................................................................................ - 31 -
6.2.3 VLAN Based on the port ......................................................................................................... - 31 -
6.3 Link Aggregation........................................................................................................................- 33 -
6.3.1 Static Aggregation Mode ........................................................................................................ - 34 -
6.3.2 LACP Mode ............................................................................................................................. - 35 -
6.4 QoS Settings...............................................................................................................................- 36 -
6.4.1 Network Congestion ............................................................................................................... - 36 -
6.4.2 Congestion Settlement ........................................................................................................... - 37 -
6.4.3 Queue Scheduling................................................................................................................... - 37 -
6.4.4 Priority Mode.......................................................................................................................... - 38 -
6.4.5 QoS Based on Port/802. 1p/DSCP .......................................................................................... - 38 -
6.4.6 TCP/UDP Port.......................................................................................................................... - 41 -
6.5 Security.......................................................................................................................................- 43 -
6.5.1 MAC Address List.................................................................................................................... - 43 -
6.5.2 Port MAC Binding ................................................................................................................... - 43 -
6.5.3 Port Mac Filtering ................................................................................................................... - 44 -
6.6 SNMP Settings............................................................................................................................- 45 -
6.6.1 SNMP ...................................................................................................................................... - 46 -
6.7 802.1x.........................................................................................................................................- 49 -
6.7.1 802.1x Networking Structure ................................................................................................. - 49 -
6.7.2 802.1x Authentication Controlled/Uncontrolled Port ............................................................ - 50 -
6.7.3 Trigger Mode of 802.1x Authentication ................................................................................. - 50 -
6.7.4 Port Authorized Status............................................................................................................ - 50 -
6.8 IGMP Snooping..........................................................................................................................- 51 -
6.8.1 IGMP Snooping Theory........................................................................................................... - 51 -
7PoE..................................................................................................................................- 52 -
7.1 PoE Settings................................................................................................................................- 52 -
7.2 PoE Events..................................................................................................................................- 54 -
7.3 Green PoE...................................................................................................................................- 55 -
8AppendixⅠTechnical Specifications...........................................................................- 57 -

1 Overview
1.1 Product Introduction
The product is a type of managed switch, it provides 16/24*10/100M PoE Ethernet port and 2 uplink
Combo 1000M ports, supports layer 2 network management and PoE management functions based on
Web, which helps to realize high speed data forwarding. It can be widely applied in places like security
surveillance, network management and so on.
1.2 Product Features
Provide web-based layer 2 network management.
Support 250 meters long distance transmission.
Support 2*1000M Combo ports.
Support 16/24*10/100M self-adaptive RJ45 ports.
Support one Console port.
Conform to IEEE802.3, IEEE802.3u, IEEE802.3ab/z and IEEE802.3X standards.
Standard 802.1Q VLAN(Access/Trunk/Hybrid)
All ports auto adapt to MDI/MDIX mode.
MAC auto learning and aging, MAC address list capacity is 4K.
IEEE802.3X full duplex flow control and Backpressure half duplex flow control.
SupportAC 100~240V power supply.
Conform to IEEE802.3af and IEEE802.3at standards, both port 1 and port 2 support Hi-PoE 60W.
Support PoE power consumption management.
Support SNMP V1/V2/V3 network management.
Support STP/RSTP ring network protocol.
Support manual aggregation and static LACP.
Support many-to-one mirroring.
Support port MAC binding.
Excellent isolated circuit protection.
Lightning protection up to level 4.

2 Device Structure
2.1 Structure of Switch
2.1.1 24-Port Switch Front Panel
1 2 3 4 5 6 7 8
9
Figure 2-1
Refer to table 2-1 for the front panel description of 24 Ports Switch.
SN
Parameter
Note
1
RJ45 port
Ethernet port, support 10/100M self-adaptation
2
Combo port
Ethernet port, support 10/100/1000M self-adaptation,
Fiber port supports 1000M.
3
Reset button
Long press the button to reset the device and recover
default configuration.
4
Console serial port
Device debugging port
5
PoE power usage
indicator
Current power consumption display
6
Downlink indicator light
Current port link status and PoE status.
7
Combo port indicator
light
Combo port indicate link/act
8
System indicator light
System status.
When device is booting up, the light is flashing
quickly.
When device is working properly, the light is
flashing slowly.
9
Power indicator light
Device current power status.
Table 2-1
2.1.2 16-Port Switch Front Panel
1 2 3 4 5 6 7 8
9
Figure 2-2
Refer to table 2-2 for more details.
SN
Parameter
Note
1
RJ45 port
Ethernet port, support 10/100M self-adaptation

2
Combo port
Ethernet port, support 10/100/1000M self-adaptation,
Fiber port supports 1000M.
3
Reset button
Long press the button to reset the device.
4
Console serial port
Device debugging port
5
PoE power usage
indicator
Current power consumption display
6
Downlink indicator light
Current port link status and PoE status.
7
Combo port indicator
light
Combo port indicate link/act
8
System indicator light
System status.
When device is booting up, the light is flashing
quickly.
When device is working properly, the light is
flashing slowly.
9
Power indicator light
Device current power status.
Table 2-2
2.1.3 Rear Panel
123
Figure 2-3
Refer to table 2-3 for the description of rear panel.
SN
Parameter
Note
1
Power switch
Control device power on and off
2
Power socket
Support AC 100～240 V
3
Ground terminal
Ground wire
Table 2-3

3 Log in Switch
3.1 Switch Login
It needs to log in switch first before configuring the switch, users can intuitively manage and maintain
Ethernet switch via Web network management.
IP
network
PC Device
Figure 3-1
It can get access to switch via Web browser, please make sure your computer has connected to the
network where the switch is located. It needs no extra config if it is the first time to use switch, now you
can use Web to visit.
1. Modify the IP address and subnet mask of your computer network adapter into 192.168.1.50 and
255.255.255.0 respectively.
2. Open Web browser, input 192.168.1.110 in the address bar, and please note that 192.168.1.110 is
the default management address of the switch.
3. Input user name and password in the login verification dialog box, the initial user name and
password is admin and admin respectively. Please be aware of the capital and small letters.
It will display the switch system info interface in the browser if it is successfully verified.
3.2 WEB Interface Introduction
Figure 3-2
As it is shown in Figure 3-2, the whole WEB management interface is divided into several parts which
includes device info display section, navigation bar, and config section etc.
3.2.1 Port Info Display Section
It is shown in Figure 3-3 that port info display is divided into WAN port state display and LAN port state
display. It is able to display the current port Link state, port speed, duplex mode and so on.

Figure 3-3
3.2.2 Navigation Bar
The navigation bar control what is displayed in the config section. The contents in navigation bar is
Displayed in the form of list, and it is divided by category. Please click the group name first if it needs to
configure some item, click the sub items after the list is unfolded. For example, please click Port
Management first if it needs to check the flow of the current port, and then click Port Statistics, refer to
Figure 3-4 for more details.
Figure 3-4
3.2.3 Config Display Section
The config section will display the contents which are selected from the navigation bar, and it can be