SEMAK BBDD Installation and operation manual

SEMAK BAR BLENDERS
MODELS BBDD, BBSS &BBPC
SEMAK AUSTRALIA:FACTORY 18, 87-91 HALLAM SOUTH ROAD,HALLAM VIC 3803
PH 03 9796 4583 FAX [phone] WEB WWW.SEMAK.COM.AU
OPERATION AND WARRANTY BOOKLET
BBPC BBDD BBSS

Page | 2
Table of Contents
IMPORTANT SAFETY INSTRUCTIONS.................................................................... 4
FEATURES OF THE BAR BLENDER ......................................................................... 5
BLENDER MODELS ............................................................................................... 6
SPARE PARTS FOR SEMAK BAR BLENDER............................................................. 6
OPERATING INSTRUCTIONS: BBSS, BBPC, BBDD .................................................. 7
CLEANING & MAINTENANCE INSTRUCTIONS....................................................... 8
SERVICE & MAINTENANCE ................................................................................... 8
SPARE PARTS........................................................................................................ 8
WARRANTY .......................................................................................................... 8
WARRANTY REGISTRATION.................................................................................10

Page | 3
RETAIN THESE SAFETY INSTRUCTIONS

Page | 4
IMPORTANT SAFETY INSTRUCTIONS
Please read all of the instructions before using the Semak Bar Blender and ensure
that other operators also read and understand all safety and operating instructions.
Save these instructions for Future reference.
Thank you for purchasing a Semak Bar Blender.
1. Important notice: Ensure that the power supply is switched off before connecting
to the electric outlet.
2. Use only on AC 220-240V –50 Hz only.
3. Do not use an extension cord.
4. To avoid risk of electric shock, do not immerse cord, plug or motor end of the
appliance in water or any other liquid. Never put the Blender or container in a
dishwasher.
5. Always switch off at the power outlet before removing the plug. Remove by
holding the plug - do not pull on the cord. When the appliance is not in use, or
prior to cleaning, always switch off the power and remove the plug.
6. Disconnect power cord from the electrical outlet when the blender is not in use.
7. The blender should not be used by children or infirm persons and care should be
taken when used near these persons. The blender should not be used outdoors.
Young children should be supervised to ensure that they do not play with the
appliance. Never leave the blender unattended.
8. Avoid physical contact with moving parts. The cutting blades are very sharp and
care is needed when handling cutting blades, and only when the Bar Blender is
disconnected from the power supply. Never attempt to touch the cutting assembly
when the blender is in operation.
9. Never operate the Bar Blender without the container securely in place. Never
operate the blender with an empty container.
10.Do not use on the stove or let the cord come in to contact with any hot surface.
11.Keep hands and utensils out of the container while using the blender to prevent
the possibility of severe injury to persons or damage to the unit.

Page | 5
12.WARNING: Blade is sharp. Please handle carefully
DO NOT try to remove blade while the container is sitting on the motor base.
DO NOT operate with loose, nicked or damaged blade replace immediately.
CAUTION Keep all utensils AWAY FROM the drive socket and blender blades during
operation. Metal utensils will damage blades.
DO NOT place container into drive socket if blender motor is operating.
DO NOT rock the blender during operation.
13.When blending liquids, especially hot liquids, ensure that the lid is on securely and
the lid insert is in place to reduce the risk of spillage and injury. Hot liquids build
up steam pressure and special care must be given when removing the container
and lid from the blender that the contents don’t splatter and burn the operator.
Keep hands, arms and face away from the lid insert to prevent possible scalding.
DO NOT start blending hot liquids on HIGH speed. Always start processing hot
liquids on LOW speed then increase while the machine is running.
14.Do not operate any appliance with a damaged cord or plug or after the appliance
malfunctions, is dropped or damaged in any way. Return the appliance to Semak
Australia. (Manufacturer) or its Authorised Service Agent for repair.
Do not attempt to repair the machine.
15.For Safety reasons and to avoid maintenance by unskilled persons, the appliance
should always be returned to Semak Australia. (Manufacturer) for adjustment or
repair if required.
WARNING –This appliance should be used according to the instructions.
MISUSE of this appliance will cause HAZARD.
FEATURES OF THE BAR BLENDER
-Stainless Steel Or Polycarbonate Container
-Stainless Steel Blades
-Self-Lubricating Bearing
-Heavy Duty Motor
-Variable Speed Control
-Self-Locking Container
-Rubber non-slip feet
-1 litre capacity

Page | 6
BLENDER MODELS
SPARE PARTS FOR SEMAK BAR BLENDER
Part Number
Description
Part Number
Description
B75-65
B75-46
B76-01
B75-30
B75-21
B75-25
B71-11
Speed Control
Speed Control Knob
Motor
Drive Clutch
Lead & Plug
Rubber Feet
Cross-Over Blade
B71-12
B71-13
B71-14
B73-54
B73-55
B71-224
B73-66
Cutting Blade Four Blade
Cutting Blade Lock Nut
Cutting Blade Washer
Rubber Ring Seal
Rubber Ring Steel
Sealing Bush & Bearing
Lid Insert
BBPC
Suited to
Smoothies, blending food stuffs, crushing biscuits…,
Sauces, mayonaise, sorbet…..
BBSS
Suited to
Smoothies, Cocktail Blending, Ice Drinks
BBDP & BBDS
Suited to
Smoothies, Cocktail Blending, Ice Drinks, High Volume Ice-creamery…..

Page | 7
OPERATING INSTRUCTIONS: BBSS, BBPC, BBDD
1. Make sure that the knob is in the “OFF” position.
2. Plug into a 220-240V AC power supply.
3. DO NOT place hands in container unless container is removed from the motor
base. Remember that the cutting blades are very sharp and great caution should
be exercised, especially when placing the ingredients into the container.
4. When mixing ice drinks add liquids first then ice. Ice may freeze onto the blades
and prevent the blades turning properly. This is less likely to happen if the liquids
are placed in the container first. Use ice that is suitable for the job, large chunks of
ice should be avoided, tube or cube ice is preferred. For very thick ice drinks, place
liquids in the container. Turn the blender on and feed ice gradually through the lid
until you obtain the desired texture.
5. Place container with the lid on onto the motor base. Using the locating pins as a
guide lock the container into place by turning it gently. Ensure that the container is
properly seated.
6. If cutting blades do not revolve when the blender is switched on. Remove the
container and adjust the contents by shaking the container or using a spatula. Try
blending again.
7. Never leave drinks in the blender after use and always clean the container and
blades after use.
8. NEVER run the blender when empty and DO NOT attempt to remove or replace
the container while the motor is running.
9. NEVER run the blender without the container in place and liquid inside. The
blender should not be run for longer than 3 minutes at a time.
10. Unplug the blender after use.

Page | 8
CLEANING & MAINTENANCE INSTRUCTIONS
1. ALWAYS turn off the appliance before cleaning.
2. Use a barely damp cloth to wipe the machine.
3. Place warm water and a little dishwashing detergent in the container and run for 15-30
seconds. Rinse in clean water and leave to dry.
4. DO NOT leave liquids in the container for long periods as this may dry out the self-
lubricating bearing.
5. Do not wash in a dishwasher.
6. DO NOT use caustic substances to clean the warmer and do not allow caustic substances
to make contact with any electrical components of the warmer.
SERVICE & MAINTENANCE
For Service and Repair, contact Semak for your nearest Authorised Service Agent
The Foodservice Industry is deemed a hostile environment within the scope of AS/NZS
3760:2003. Semak Bar Blenders MUST be routinely electrically tested for compliance with
this standard if used commercially.
It is recommended that a Food Safety program such as HACCP be employed and that
routine service and repair be undertaken at the time of electrical testing to ensure the
correct operation and function of all parts. The equipment MUST be serviced annually or
sooner depending of the hostility of the environment in which it is operated.
SPARE PARTS
Spare Parts, exploded views and wiring diagrams are available from our webpage. Go to
www.semak.com.au and locate the appliance in the product section for the above
information.
WARRANTY
Models BBSS, BBPC AND BBDD are Commercial Grade blenders suitable for commercial use.
This product is guaranteed for 2 Years from the date of purchase against mechanical and
electrical defects. If the fault is deemed caused by MISUSE/ABUSE the terms of the
warranty are invalidated.
If the product has been opened or tampered with (ie. In an attempt to repair it) the
warranty is invalidated. All warranty repairs should be undertaken by Semak Australia.
It is against company policy to authorize warranty repairs over the phone. Service Agents
will require a work order number from Semak to conduct warranty repairs.

Page | 9
SEMAKWARRANTY
THIS WARRANTY APPLIES ONLY TO PRODUCTS MANUFACTURED AND SOLD IN AUSTRALIA
The benefits conferred by this warranty are an alternative to all other rights and remedies
in respect of the product which the consumer has under the Trade Practices Act and similar
State and Territory Laws.
Semak Australia. Warrant each new SEMAK appliance manufactured by SEMAK to be free
from defects in materials or manufacturing process for a period of 2 Years from the date of
original purchase.
Should defects due to faulty materials or manufacturing process develop within the
warranty period, the appliance will be repaired without charge providing all conditions of
this warranty are observed.
1. Proof of Purchase and Warranty card must be retained and available on request.
2. This Warranty is void if the equipment has been damaged due to misuses neglect or is
used for a purpose for which it was not suited; and no repairs, alterations or
modifications have been attempted by other than Semak or its authorised Service
Agent.
3. Semak Australia. Reserves the right to reject a claim for warranty if service is required
due to misapplication, improper installation, inadequate wiring, and incorrect voltage
conditions. Under no circumstances shall SEMAK or its agents bear responsibility for
consequential damages of any kind.
4. Where required by Statute or local authority, equipment must be installed by qualified
person in accordance with all relevant regulations. Failure to do this will void product
warranty.
5. Cost of transport of any appliance or part to and from SEMAK or its Service Agent is to
be paid by the owner.
6. A charge will be made where failure is due to neglect, abuse or accidental damage on
the part of the operator, or when no fault can be found or the fault is due to causes
outside the control of Semak Australia.
7. The above does not preclude the purchaser from their Statutory rights as a consumer.
Semak Australia
Factory 18
87-91 Hallam South Road
HALLAM VIC 3803
Ph 03 9796 4583
Fax [phone]
Email techn[email protected]
Web www.semak.com.au

Page | 10
WARRANTY REGISTRATION
Retain for Future Reference
DO NOT SEND
Please complete one registration for each Semak appliance.
You may be required to provide this information when requesting after sales service. Please
staple your proof of purchase to this page.
Company Name: ________________________________________________
Company Address: ________________________________________________
Business Type: ________________________________________________
Contact: ________________________________________________
Phone: ________________________________________________
Fax: ________________________________________________
Email: ________________________________________________
Product: ________________________________________________
Serial Number: ________________________________________________
Date of Purchase: ________________________________________________
Place of Purchase: ________________________________________________

Page | 11

Page | 12
© Semak 2014