semble Aventos HK User manual

Assemble the Carcass: Idenfy the two gables.
Each gable has two locang holes
drilled on the top forward face: this
will allow you to align the li mecha-
nism locang lugs before screw xing
to the gable.
3
Idenfy the back: insert dowels into the holes—then
join this back with one of the gables… Be sure to secure
this join by inserng screws in the small holes from the
outside.
4
Now place carcass on end. Insert dowels into the top &
boom … and insert these into the gable.
Aventos Li UP: With AVENTOS HK, each door swings up
and stays out of the way no maer where stopped. Be-
cause of its unique opening acon, it is ideal for all sorts of
design applicaons and cabinets ...
AVENTOS HK components
are easy to assemble. Once
the li mechanism has been
precisely adjusted to the
weight and size of the front,
AVENTOS HK will open, close
and hold with reliable ease.
You are now ready to assemble the LIFT mechanism:
….. Open the Aventos Hardware boxes and idenfy the 2 x
Door Mounng plates. These can be screwed to the door by pressing in
securely and then screwing the four screws down rmly with a cordless
drill. For now place the door to one side.
1
The top & boom of your carcass are dowelled into the back &
the gable so ensure these are correctly located.
5
Almost there: place the last gable on to the carcass en-
suring the dowels are aligned. Then secure with screws in
the remaining holes.
AVS:
Aventos HK Lift-up Cabinet (800mm)
2
Standard throughout the Semble
range is the 3-hole adjustable shelf
allowing ne adjustment to maximize
your storage / display opons.
6

Clip on the Door: Take the door and with the Door
Mounng plates seat them into the rear of the Lever Arm and
then press down on front of the Lever Arm to clip them in.
(you may choose to install the carcass on the wall before clipping the
door and proceeding with nal adjustments)
Adjust the Springs . Using a cordless driver you can ad-
just the tension on each spring to funcon with the correct
weight of the door…
The ideal balance point is when the door will sit naturally at a 45 degree
opening angle .
Adjust the Door posion. The Lever Arms oer in-
nite adjustment in 3 planes so you can ensure they look
perfect in your design. Adjust and check repeatedly unl
you are happy with the nal t.
AVS:
Aventos HK Lift-up Cabinet (800mm)
5
You are now nished: Simply clip the cover caps on and
your ready to enjoy your Blum Aventos unit!
Please email [email protected] if you would like further instruc-
ons regarding removal of door and how to x the upper opening angle.
6
2 1
Take the LIFT mechanism & seat
the two locang lugs (small indents) on
the two pre-drilled holes.
Unlock the Mech with CARE! Idenfy the plasc locking clip—this is used to hold
the arm locked closed. Unclip this AND take care that the arm does not spring up caus-
ing injury. Once removed, carefully and deliberately open the Lever Arm ready for the
next step.
Pressing the unit rmly against the carcass you
can now screw the three xing screws. Repeat
for both sides.
Using the locang lugs will ensure the mecha-
nism is in the correct posion...
4
3