Sensio SE10152CW User manual

1 x GX53 TRIGON
LED TRIANGLE
SURFACE LIGHT
CODE: SE10152CW/WW
INSTALLATION
INSTRUCTIONS
IMPORTANT: Please read these instrucons before commencing installaon and retain for furture reference.
Waste Electrical & Electronic Equipment (WEEE)
The symbol on the product, or on the document accompanying the product, the crossed out wheelie
bin symbol, indicates that this product may not be treated as household waste.
Instead it shall be handed over to the applicable collecon point for the recycling of electrical and
electronic waste.
Components Tools required
1 x SE10152CW/WW LED Lamp, holder & Collar 2 X Screws 1 x instrucons 22mm Drill Bit Power Drill
Please read these instrucons carefully before aempng to install this
product. It is advisable to keep these instrucons in a safe place for
future reference.
We recommend that you consult a qualified electrician. All
electrical installaon must be carried out in accordance with
current IEE wiring regulaons (BS7671).
These p
These products must not be modified, if any modificaon are made, it
may invalidate the warranty and may render the product unsafe. These
LED lights operate at 240V.
This LED light fing can be connected directly to the mains.
For indoor use only.
Important Safety Informaon
Safety Instrucons
• If in doubt installaon must be carried out by a qualified
electrician.
• Install on smooth flat surface(s) only.
• Do not exceed or stretch the cable length of each LED wire.
• The collar can be removed from the fing if you wish to recess.
• The waage for each light is 2.8W.
4. Suitable for furniture lighng.
5. When the lamp expires the fing must be replaced.
1. Before commencing installaon or maintenance, isolate the main
electrical supply for the appropriate circuit at the fuse board.
2. This product is only suitable for connecng to a 240V 50Hz supply.
3. The lights should be mounted onto a secure surface.
Sensio House, Unit 7, Speedwell Road, Whitwood, Castleford, West Yorkshire, WF10 5PY
www.sensio.co.uk
Technical drawings for illustraon purposes only, Sensio had the right to change any informaon without
prior noce. Make sure you check all hole cut outs before work commences.
3W.

Installaon
Maintenance & Care
1 x GX53 TRIGON LED RECESSED/SURFACE LIGHT
Create an access hole 9-11mm for the cable
Fix the collar to the surface using the two
screws provided.
• Ensure that the power is disconnected prior to cleaning.
• To keep the finish of this product, wipe over with so cloth periodically.
• Do not use harsh chemical solvents, this may dis-colour or damage the finish.
Technical drawings for illustraon purposes only, Sensio had the right to change any informaon
without prior noce. Make sure you check all hole cut outs before work commences.
www.sensio.co.uk
Sensio House, Unit 7, Speedwell Road, Whitwood, Castleford, West Yorkshire, WF10 5PY
Making sure the cable is fed through the
access hole, twist into the collar as shown
above.
Wire the cable to a 13Amp plug and connect to
the mains.
The SE10152
22mm
SE11175
distributor block or wire
directly to the mains supply.