Sensio TRIOTONE SE21100 User manual

TRIOTONE
TM
COLOUR
SELECTABLE
SURFACE/RECESS
LIGHT
CODE: SE21100
1 x SE21100 1 x Fitting Instructions
2 x Screws Pencil 10mm
Drill Bit
PZ1 Screw Bit Power Drill
ø 60mm hole opener

4
Plug the white connector on the end of the cable into the 24V
LED driver distributor block. Beware not to exceed the wattage
of the LED driver, the max wattage will be displayed on the 24V
LED driver and the tting’s wattage requirement will be stated
on the item.
5
Drill an installation hole of 60mm ø Choose the required colour temperature. Then feed the attached
cable through the cut hole.
Insert the tting into the cut hole and push until secure in
place.
Measure and mark the desired positioning of your light tting.
If you wish to completely hide the wire then create a small
hole in the mounting board for the wire to feed through.
Ensure the wire for the tting is placed through the wire feed
or through the cut hole in the mounting board. Then using the
screws, x the mounting bracket to the mounting surface as
shown above.
Select the required colour temperature then carefully push the
light tting into the mounting bracket until it clips into place.
The driver is to be situated at the top of
the kitchen wall cabinet and all ttings
are to be individually connected back to
the distribution ports on the driver.
COLOUR SELECTABLE SURFACE/RECESS LIGHT
- Recessing
- Surface Mounting