sensolus TRACK 1000 Operating and safety instructions

www.sensolus.com | [email protected]om
TRACK 1000 Battery replacement manual
Step 1
• Make sure that the serial number and logo are facing
the right way up.
• Then turn the tracker face down.
• Unscrew the 6 screws.
Tip: If using a power drill, use power seng 7, on low.
(Note: not all power drills have the same sengs!)
Step 2
• Remove the back plate and the 6 screws.
Step 3
• Remove the baeries - pull them out of the
connector.
Tip: place a nger on the sponge to hold it in place
Step 4
Place the chip so the connector is towards the holder.
Step 5
Insert new baeries. Posion the new baeries and make
sure the baeries are in the center (on top of the sponge)
- not too low or too high.
Step 7
Make sure that the seal is completely at/intact on the
back of the tracker.
Step 8
Close the case again by ghtening the 6 screws in the
corresponding holes. Be careful not to break the casing
when using a power drill.
Step 9
The green light on the front of the tracker will rapidly
ash green. From this moment, your asset tracker will
start sending acvity (movement) and GPS locaon.
This informaon will be visible in the Sensolus Plaorm
if you nd yourself in an area with Sigfox communicaon
network coverage.
Step 6
Make sure the connector is inside the holder and that the
cable is tucked to the le-hand side.

www.sensolus.com | [email protected]om
Indicate baery replaced in plaorm
When you replaced the battery in the tracker you have to indicate
thet in the platform.
• Go to the tracker details page in the general secon. You can
search for this tracker or nd in in the asset list or asset map.
• Click on the replace baery link to indicate you have replaced the
baery of that tracker.
• Conrm the update.