Sentern JC-82 User manual

ess
ating Instruction
Compressor Wine Cooler
Operating Instruction
JC-82
BEFORE USE, PLEASE READ AND FOLLOW ALL SAFETY RULES AND OPERATING INSTRUCTION.
*Wine Not Included.
Tel: [phone] Ext. 100
E-mail: [email protected]
Customer Service

IMPORTANT SAFETY INSTRUCTIONS
WARNING
To reduce the risk of fire, electrical shock, or injury
while using your wine cooler, please follow these
basic guidelines:

Read all instructions before using the APPLIANCE.
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or
similarly qualified person in order to avoid a safety hazard.
This appliance is not intended for users (including children) with reduced physical, sensory
or mental capabilities, or lack of experience and knowledge, unless they have been given
supervision or instruction concerning the use of the appliance by a person responsible for
their safety.
Children should be supervised to ensure that they do not play with the appliance.
WARNING: To avoid safety hazards due to instability performance, the appliance must be fixed
in accordance with the instruction.
-Save these instructions-
INSTALLATION INSTRUCTIONS
This appliance is designed to be free-standing only, and should not be recessed or built-in.
Make sure the floor where you place your unit is strong enough to support the unit when it is fully
loaded. To level your unit, adjust the leveling legs at the bottom of the unit.
This appliance is not designed to be installed inside of a cabinet where the front is covered by
any type of door.
Allow 10 cm of space between the top, the back and sides of the wine unit, which allows
proper air circulation to cool the compressor and condenser.
Store the unit away from direct sunlight and sources of heat (stove, heater, radiator, etc.). Direct
sunlight may affect the acrylic coating and the heat sources may increase energy consumption.
Extreme cold ambient temperatures may also influence the proper performance of the unit.
Avoid locating the unit in moist areas.
Plug the unit into an exclusive, properly installed grounded wall outlet. Do not under any
circumstances cut or remove the third (ground) prong from the power cord. Any questions
concerning power and/or grounding should be directed toward a certified electrician or an
authorized product service center.
After plugging the Wine Chiller into a wall outlet, allow the unit to cool down for 2-3 hours before
placing any items in the compartment.

NOTICE
Please remember to keep some water in the cabinet to keep the humidity.
Appliance should placed on a horizontal floor and keep the ventilation free. Don't try to replace or
repair any components by yourself. Contact customer service for help if necessary.
How to disposal of the appliance
To prevent possible harm to the environment or human health from uncontrolled waste
disposal, recycle it responsibly to promote the sustainable reuse of material resources. And
the disposal should only be done through public collection points.



paenl is activated.
You can select temperature display setting from Fahrenheit to Celsius degree by pushing button
for 2 second. The degrees will appear in blue color in the temperature display window.
When the control panel is active, push button and the LED temperature display will be off;
You have to push the button again and the LED temperature display will turn back on.
You can set desired temperature by pushing button . The temperature increases or decrease
1℉or 1℃ each time you press the button.
Energy Saving Tips
The unit should be located in the coolest area of the room. Keep it away from heat
producing appliances and out of direct sunlight.
Aluminum foil, wax paper or paper toweling should not be stored in the unit, which are
possible to block the air vent and increase the energy consumption.
or
OPERATING YOUR UNIT
Setting the Temperature Control
Your wine cooler has been equipped with an "automatic" control panel lock, that will activate
20 seconds after the last time a button has been touched.
Push button for 2 seconds to unlock the control panel. You will hear a beep sound if the control

POSSIBLE PROBLEMS WITH YOUR APPLIANCE
You can solve many common problems easily. Try the suggestions below to see if you can solve the
problem before contacting customer service.
TROUBLESHOOTING GUIDE
PROBLEM
POSSIBLE CAUSE
Unit does not operate. Not plugged in.
The circuit breaker tripped or a blown fuse.
Turns on and off frequently. The room temperature is higher than normal.
A large amount of food has been stored in the
unit.
The door has been opened too often.
The door is not closed completely.
The temperature control is not set correctly.
The door gasket does not seal properly.
The unit does not have the correct clearances.
Vibrations. Make sure the unit is placed on level ground.
The unit seems to make too much noise. The rattling noise may come from the flow of
the wine cooler, which is normal.
As each cycle ends, you may hear gurgling
sounds caused by the flow of wine cooler in
your unit.
Contraction and expansion of the inside walls
may cause popping and cracking noise.
The unit is not level.
The door will not close properly. The unit is not level.
The door was reversed and not properly installed.
The gasket is dirty or bent.
The shelves, bins, or baskets are out of position.
WIRING DIAGRAM