Sequiam Biometrics BioVault 2.0 User manual

BIOVaULT
Wall Mount Installation Instructions
Access Control at the Touch of a Finger

Sequiam Biometrics, the Sequiam logos, BioVault 2.0, the BioVault 2.0 logos are trademarks of Sequiam Corporation.
© 2006 Sequiam Corporation. All rights reserved.
Package Contents:
(1) Wall Mount
(6) Screws
(1) Instruction Manual
WALL MOUNT ASSEMBLY
1. Hold the BioVault 2.0 mounting bracket against a wall in its desired location. Secure
to the wall using the 6 screws included. We recommend you mount at least one side (3
screws) of the mounting bracket to a wall stud. Use the 6 screws (included) in the 6
outer holes, screwing them directly into the wall. (Figure A)
2. Once the wall mount is securely affixed to the wall, place the BioVault 2.0 unit onto
the wall mount by inserting the bottom supports of the wall mount into the holes located
at the bottom of the BioVault, as shown in Figure B.
3. Firmly press the BioVault 2.0 unit toward the wall unit you hear a click, this indicates the
BioVault is secure to the wall mount, as shown in Figure C (above).
Note: We recommend storing no more than 40 lbs in the BioVault 2.0 when it is wall
mounted.
1|BioVault 2.0Wall Mount Instructions

BioVault 2.0Wall Mount Instructions |2
WALL MOUNT DISASSEMBLY
1. Open the BioVault unit. (Figure D)
2. Pull the metal latch to the left to disengage the BioVault from the wall mount as shown in
Figure E.
3. As you are pulling the latch, it releases the unit from its locked position, lift the unit off
the wall mount as shown in Figure F.
Help
For additional information on your
BioVault 2.0 accessories, please visit
biovault.sequiam.com

For more great biometric products please visit www.sequiam.com