Serialio Scanfob 4000n User manual

SCANFOB® 4000n
Quick Start Guide
715 Discovery Bl vd. Ste 510
Ceda r Park, TX 78613
Tel: [phone]
Fax: [phone]
For sales inquiries:
sales @s erialio.com
For technical support:
support@seri a l i o.com
BluetoothMode
Bluetooth-SPP
(Serial Port Profile - SSP)
Bluetooth - HID
(Huma n Interface Device –SSP)
Defaults
iOS Mode
Reset Defaults
Apple iOS Keyboard Mode
(also enables keyboard toggle)
*Unit must be disconnected from host device to
activate this setting
USB Communications
USB Enabled
USB Disabled
*iOS Apps s upporting MFi mode
-Gri d-In-Ha nd® Mobi l e Grid
-Order-In-Ha nd® Mobi l e Order
-Li s t-In-Ha nd® Mobi l e List
-iScanBrows er
Reset Defaults

Setting up Scanfob® 4000 in SPP mode for use with SerialMagic or SerialMagic Gears
Android Mobile Device or Windows PC:
1. Charge –Connect the Scanfob® 4000 to a powered USB port for about 4 hours, or until LED shows green. Only
charge the Scanfob® 4000 with approved charging devices. Use of non-approved charging devices can damage the
battery and void the warranty.
2. Install SerialMagic –Seri alMagic is available at https://goo.gl/q4srnb.
Download & install SerialMagic for your platform.
Android users should visit the Google Play Store for SerialMagic Gears.
3. Set Scanfob® 4000 to SPP mode –Scan the “Bluetooth SPP”barcode on Pg 1 to set the scanner’s Bluetooth mode.
4. Put Scanfob® 4000 in Discoverable Mode –Hold the Function Key down on the scanner for approximately 5 seconds
until a bl ue blinking light appears in the Feedback LED.
5. Open SerialMagic Gears –Once application is open on your Android device, hit the connect button. Select Scanfob
device from avai lable devices by tapping on the scanner name.
Congratulations! The Scanfob® 4000 is now connected! For instructions on scanning into third party applications,
Android users should visit serialio.com/support/SerialMagic/Android/SMKeys_Setup.php
Setting up Scanfob® 4000 in SPP mode for use in HID Mode (like a Bluetooth Keyboard)
iOS Instructions:
Charge –Connect the Scanfob® 4000 to a powered USB port for about 4 hours, or until LED shows green. Only1.
charge the Scanfob® 4000 with approved charging devices. Use of non-approved charging devices can damage the
battery and void the warranty.
2. Set Scanfob® 4000 to HID mode –Scan the “Bluetooth - HID” barcode on Pg 1 to set the scanner’s Bluetooth mode.
3. Put Scanfob® 4000 in Discoverable Mode –Hold the Function Key down on the scanner for approximately 5 seconds
until a bl ue blinking light appears in the Feedback LED.
4. Open Bluetooth Settings –Once Scanfob® 4000 is blinking blue, open your Bluetooth Settings menu on your iOS
device. Select Scanfob device from avai lable devices by tapping on the scanner name to connect.
Congratulations! The Scanfob® 4000 is now connected! To toggle keyboard on or off, scan “Apple iOS Keyboard Mode”
barcode found on page one.