SEW-Eurodrive MOVIDYN Operating instructions

MOVIDYN®Bracket for Heat Sink Edition
10/2001
Addendum to the Operating Instructions
1053 5217 / EN

2
Addendum to Operating Instructions – MOVIDYN
®
Bracket for Heat Sink
Connection Bracket for Heat Sinks in Multi-Axis Applications
1 Connection Bracket for Heat Sinks in Multi-Axis Applications
Application range The connection bracket is used when the following factors coincide:
•MOVIDYN
®multi-axis applications (power supply module and an axis module or
several axis modules)
• Use of more than one heat sink
• Mounting back wall with poor conductivity
Installation The connection brackets should connect the heat sinks so that no EMC problems can
arise. A pair of connection brackets, part number 815 841 X, is supplied with every
power supply module.
The connection brackets can be used with heat sink types DKE, DKS and DKF.
05287AXX
Fig. 1: Installation of the connection bracket

Addendum to Operating Instructions – MOVIDYN
®
Bracket for Heat Sink
3
Connection Bracket for Heat Sinks in Multi-Axis Applications
The connection brackets are fastened at the top and bottom with the existing bolts that
are used for bolting the units onto the heat sinks.
05288AXX
Fig. 2: Correctly installed bracket on the underside

SEW-EURODRIVE GmbH & Co · P.O. Box 3023 · D-76642 Bruchsal/Germany · Phone [phone]
Fax [phone] · http://www.sew-eurodrive.com · [email protected]