SGS STC7200S User manual

USE AND CARE GUIDE
24 IN.STORAGE CABINET
Due to continuing improvements,
the actual product may differ slightly
from the product described herein.
WARNNING
Failure to follow these guidelines can result in property damage or personal injuries.
This product is not recommended for outdoor use.
Strongly recommend at least two adult people to assemble this unit.

Explosive Drawing
A
J
M
K
E
F
C
F
B
I
L
H
G
D
K
Part Description Quantity
A
B
C
D
E
F
G
I
J
K
L
M
N
Bottom panel
Left panel
Right panel
Top panel
Back bottom panel
Back middle panel
Back top panel
Shelf
Adjustable feet
Left reinforcement
Shelf bracket
Right reinforcement
1
1
1
1
1
2
1
4
4
16
1
1
HDoor 1
Round Head Bolt 1/4" X 14mm 54
12
Flat head bolt 5/32" X 8mm
O
O
N
TOOL REQUIRED ( NOT INCLUDED)
Phillips Screwdriver
Part Description Quantity
1

1INSTALL THE ADJUSTABLE FEET
Install the 4 pcs adjustable feet to the bottom panel,make sure that all the feet completely fit into the bottom panel.
J
X 4
2 ATTACH THE LEFT PANEL AND LEFT REINFORCEMENT TO THE BOTTOM PANEL
Attach the left panel and left reinforcement to the bottom panel with 8 pcs 1/4”X14 mm round head bolt.
A
J
Assembly Instructions
N
X 8
B
Note: Assemble on a flat surface.
A piece of cardboard is recommended to keep the product from being scrashed during assembly.
L
L
B
2

N
X 8
C
M
3ATTACH THE RIGHT PANEL AND RIGHT REINFORCEMENT TO THE BOTTOM PANEL
Attach the right panel and right reinforcement to the bottom panel with 8 pcs 1/4”X14 mm round head bolt.
M
Assembly Instructions
3

4 ATTACH THE BACK PANEL AND TOP PANEL
Attach the back panels to the back of the cabinet from bottom up with 27 pcs 1/4”X14mm round head bolt.
N
X 27
G
F
D
5 ATTACH THE TOP PANEL
Attach the back panels to the side panels and top back panel with 11 pcs 1/4”X14mm round head bolt.
F
N
X 11
E
Assembly Instructions
4

7INSTALL THE DOOR
Attach the door to the cabinet with 12 pcs 5/32”X 8mm flat head bolt.
6 INSTALL THE SHELVES
Isnsert 16 pcs shelf brackets into the slots on
the side panels at the desired heights.make sure
the 4 pcs brackets for each shelf are at the same height.
Place the Shelves over the shelf brackets,
and push them down onto the shelf brackets
Make sure the shelves are properly and safely locked
by the upright hooks on the shelf brackets
O
X 12
H
K
K
I
K
Assembly Instructions
5

1850 mm-1860 mm
72.8-73.2 in
60cm
23.6 in
46cm
18.1in
Care and Maintenance
1. Use a soft,clean cloth that will not scratch the surface when dusting.
2. Using solvents of any kind on your product may damage the finish.
3. Do not use any harsh abrasives or chemicals to clean
4. Any metal surfaces as it may damage the protective coating.
The cabinet can be reach to 1860 mm ( 73.2 inch) height , you can adjust the adjustable feet counterclockwise
to reach your desired height.
6