Shark Rocket DELUXEPRO User manual

Please be sure to read the enclosed Shark® Owner’s Guide prior to using your unit.
ASSEMB LY
A Handheld Vacuum
B Motorized Floor Nozzle
C Wand
D Onboard Storage Clip
E 30 cm (12”) Crevice Tool
WHAT’S INSIDE STORAGE
MAINTENANCE
UV425CCO_QSG_EN_REV_Mv2
QUICK START GUIDE
ULTRA-LIGHT UPRIGHT
2
(Click)
1
(Click)
G
Option 1: Onboard Hook
For compact, convenient storage, hang the handheld
vacuum on the hook on the bottom of the wand, and wrap
the power cord around the cord hooks. The unit stores
easily in a closet or along a wall.
Option 2: Wall Mount
Please see included instruction sheet for wall mount
installation information.
Handheld
Vacuum Catch
Handheld Vacuum
Storage Hook
Empty the dust cup every
time debris reaches the
MAX fill line.
TIP: Wash filters every
month to keep
the suction strong.
Bottom of Floor Nozzle Maintenance
1Use a coin to unlock the three locks on the bottom of
the floor nozzle.
2A portion of the base is removable to allow for better
access to the brushroll and exposure to the airway.
Shine a flashlight from the bottom to check for possible
blockages in the airway.
3Remove any string, carpet fibers, or hair that may be
wrapped around the brushroll. There is a groove along
the brushroll that allows a pair of scissors to cut across
it to loosen up debris.
4To reassemble, replace base by lining it up along the
front of the nozzle. Push down to snap into place until
you hear a click. Lock the three locks.
D
I
E
F
F Dusting Brush
G Wall Mount
H Upholstery Tool
I Dust-Away™ Hard
Floor Attachment
H
DELUXEPRO
A
B
C
Empty
DustCup
Release
STEP 2 STEP 4
STEP 3STEP 1

VERSATILE FLOOR-TO-CEILING CLEANING
@sharkcleaning
2Choose Setting
The Rocket®DeluxePro Ultra-Light has a 2-speed Power
slider switch on the handle. Slide the Power switch to
appropriate speed setting (I or II) and start cleaning.
1Plug In Vacuum
Then place your foot
gently on the floor nozzle
and tilt the handle back.
FLOOR CLEANING ABOVE-FLOOR CLEANING
NOTE: For deep cleaning per
ASTM F 608 (embedded dirt in
carpets) please set to High Pile
Carpets (II).
Setting II
High Pile Carpets
The brushroll spins faster
to pick up debris below the
surface ofyour carpets.
Setting I
Bare Floor, Area Rugs
The brushroll spins slowly
to clean bare floors and
delicate arearugs.
Press the Release button
on the top of the wand
to disconnect it from the
handheld vacuum.
1 Stand the vacuum upright.
Step on the foot pedal
and pull the wand up to
disconnect it from the
motorized floor nozzle.
2Attach desired cleaning accessory.
NOTE: Use Setting I
for all above-floor
accessories.
OR
Floor Nozzle
Release
Wand Release
For questions or to register your product, visit us online at sharkclean.com
©2018 SHARK and ROCKET are registered trademarks of SharkNinja Operating LLC.
DUST-AWAY is a trademark of SharkNinja Operating LLC.
Wand
Release