Shark STRATOS CLEAN SENSE IQ MultiFLEX IZ800... User manual

SHARK®CORDLESS STRATOS™IZ800 SERIES
IMPORTANT SAFETY INSTRUCTIONS
WARNING: TO REDUCE THE RISK OF INJURY, USER MUST READ INSTRUCTION MANUAL • HOUSEHOLD USE ONLY
WARNING When using an electrical appliance, to reduce the risk of fire, electric shock, injury, or
property damage, basic precautions should always be followed, including the following:
READ AND SAVE THESE INSTRUCTIONS
VISIT qr.sharkclean.com/iz800seriesmanual OR
SCAN HERE
FOR FULL INSTRUCTIONS & REPLACEMENT PARTS
© 2022 SharkNinja Operating LLC. DUOCLEAN, MULTIFLEX, and SHARK are registered trademarks of SharkNinja Operating LLC.
HAIRPRO, POWERFINS, and STRATOS are trademarks of SharkNinja Operating LLC.
IZ800_Series_QSG_MP_Mv13
1. This vacuum consists of a motorized nozzle, wand, and handheld
vacuum. These components contain electrical connections,
electrical wiring, and moving parts that potentially present risk to
the user. The floor nozzle, wand, and handheld vacuum contain
electrical connections.
2. Before each use, carefully inspect all parts for any damage. If a part is
damaged, discontinue use.
3. Use only identical replacement parts.
4. This vacuum contains no serviceable parts.
5. Use only as described in this manual. DO NOT use the vacuum for
any purpose other than those described in this manual.
6. With the exception of the filters and dust cup, DO NOT expose any
parts of the vacuum to water or other liquids.
7. Keep the appliance and its cord out of reach of children. DO NOT
allow the appliance to be used by children. DO NOT allow to be
used as a toy. Close supervision is necessary when used near children.
GENERAL USE
8. This appliance can be used by persons with reduced physical,
sensory, or mental capabilities or lack of experience and knowledge
if they have been given supervision or instruction concerning use of
the appliance in a safe way and understand the hazards involved.
Cleaning and user maintenance shall not be made by children.
9. Always turn o the vacuum before connecting or disconnecting any
current carrying hoses, motorized nozzles, chargers, batteries, or
other electrical or mechanical parts.
10. DO NOT handle plug or vacuum with wet hands.
11. DO NOT use without dust cup, HEPA and Pre-motor filter,
and soft roller in place.
12. Only use Shark® branded filters and accessories. Failure to do
so will void the warranty.
13. DO NOT put any objects into nozzle or accessory openings. DO
NOT use with any opening blocked; keep free of dust, lint, hair, and
anything that may reduce airflow.
14. DO NOT use if nozzle or accessory airflow is restricted. If the air
paths or the motorized floor nozzle become blocked, turn the vacuum
o. Remove all obstructions before you turn on the unit again.
15. Keep nozzle and all vacuum openings away from hair, face, fingers,
uncovered feet, or loose clothing.
16. DO NOT use if vacuum is not working as it should, or has been
dropped, damaged, left outdoors, or dropped into water.
17. Use extra care when cleaning on stairs.
18. DO NOT leave the vacuum unattended while powered on.
19. When powered on, keep the vacuum moving over the carpet
surface at all times to avoid damaging the carpet fibers.
20. DO NOT place vacuum on unstable surfaces such as chairs or tables.
21. DO NOT use to pick up:
a) Liquids
b) Large objects
c) Hard or sharp objects (glass, nails, screws, or coins)
d) Large quantities of dust (including drywall, fireplace ash, or
embers). DO NOT use as an attachment to power tools for
dust collection.
e) Smoking or burning objects (hot coals, cigarette butts,
or matches)
f) Flammable or combustible materials (lighter fluid, gasoline,
or kerosene)
g) Toxic materials (chlorine bleach, ammonia, or drain cleaner)
22. DO NOT use in the following areas:
a) Poorly lit areas
b) Wet or damp surfaces
c) Outdoor areas
d) Spaces that are enclosed and may contain explosive or toxic fumes
or vapors (lighter fluid, gasoline, kerosene, paint, paint thinners,
mothproofing substances, or flammable dust).
23. Turn o the vacuum before plugging in or unplugging the charger.
24. Turn o the vacuum before any adjustment, cleaning, maintenance or
troubleshooting.
25. During cleaning or routine maintenance, DO NOT cut anything other
than hair, fibers, or string wrapped around the brushrolls.
26. Allow all filters to air-dry completely before replacing in the vacuum
to prevent liquid from being drawn into electric parts.
27. DO NOT modify or attempt to repair the vacuum or the battery
yourself, except as indicated in this manual. DO NOT use the battery
or vacuum if it has been modified or damaged. Damaged or modified
batteries may exhibit unpredictable behavior resulting in fire,
explosion, or risk of injury.
28. Always turn o this appliance before connecting or disconnecting
motorized nozzle or hand tool.
BATTERY PACK
29. The battery is the power source for the vacuum. Carefully read and
follow all charging instructions.
30. To prevent unintentional starting, ensure the vacuum is powered
o before picking up or carrying the vacuum. DO NOT carry the
appliance with your finger on the power switch.
31. Use only Shark® charger DK024-288080H-U or YLS0243A-T288080
for single batteries and DK482-288080U or YLS0483A-T2880802
for dual battery packs. Use of an incorrect charger may result in no
charging, and/or unsafe conditions. A charger that is suitable for one
type of battery pack may create a risk of fire when used with another
battery pack.
32. Keep the battery away from all metal objects such as paper clips,
coins, keys, nails, or screws. Shorting the battery terminals increases
the risk of fire or burns
33. Under abusive conditions, liquid may be ejected from the battery.
Avoid contact with this liquid, as it may cause irritation or burns. If
contact occurs, flush with water. If liquid contacts eyes, seek
34. Battery should not be stored at temperatures below 3°C (37.4°F)
or above 104°F (40°C) to maintain long-term battery life.
35. DO NOT charge battery at temperatures below 5°C (40°F) or above
104°C (104°F). Charging improperly or at temperatures outside of the
specified range may damage the battery and increase the risk of fire.
36. Store the appliance indoors. DO NOT use or store it below 3°C (37.4°F).
Ensure the appliance is at room temperature before operating.
37. DO NOT expose the battery to fire or temperatures above 265°F
(130°C) as it may cause explosion.
38. Use appliances only with specifically designated battery packs.
Use of any other battery packs may create a risk of injury and fire.
39. Disconnect the battery pack from the appliance before making
any adjustments, changing accessories, or storing appliance. Such
preventive safety measures reduce the risk of starting the appliance
accidentally.
40. For the IZ800 Series use only with Shark battery pack XBATR725SL.
41. If the charging cord plug does not fit fully into the outlet, reverse
the plug. If it still does not fit, contact a qualified electrician. DO NOT
force into outlet or try to modify to fit.
42. To reduce the risk of shock and unintended operation, turn o power
and remove the Li-Ion battery before servicing.
ODOR
43. Observe the following when interacting with the odor neutralizing
cartridge:
a) DO NOT attempt to disassemble odor neutralizing cartridge.
b) Avoid direct contact with the fragrance pod in the cartridge.
c) DO NOT directly inhale from the odor neutralizing cartridge.
d) Keep away from children and pets.
e) Keep away from heat, sparks, and open flame.
f) DO NOT place in direct sunlight.
FRAGRANCE CARTRIDGE FIRST AID
a) Avoid contact with fabrics and finished surfaces.
b) Eye contact: Remove contact lenses if present. Rinse
continuously with water for several minutes.
c) Skin contact: Wash hands thoroughly after handling. If
irritation or rash develops, seek medical advice/attention.
d) Inhalation: Move person to fresh air if they are experiencing
any respiratory symptoms. If symptoms persist, seek medical
advice/attention.
e) Ingestion: DO NOT induce vomiting. Seek medical
advice/attention.

SETTING UP YOUR UNIT
ESSENTIAL MAINTENANCEESSENTIAL MAINTENANCE
SETTINGS
Please be sure to read and save the warnings on other side prior to using your unit.
QUICK START GUIDE
How to set up the Shark IZ800 Series Shark®STR ATOS™Cordless MultiFLEX®
Vacuum with DuoClean®, PowerFins™, HairPro™, and Odor Neutralizer Technology.
1. Insert Wand into Floor Nozzle.
2. Insert Handheld Vacuum into wand.
3. Remove Odor Neutralizer Technology Dial from
bag. Flip up the dial handle, align the teal arrows,
then insert the dial into the nozzle. Using the
handle, rotate the dial until it clicks into the desired
intensity setting.
4. After reading it, remove the sticker from the hand
vacuum's digital screen.
For proper operation, ensure all components are
completely connected and clicked into place.
MultiFLEX®
Wand
Handheld Vacuum with
Removable Battery
IZ800 Series
2.
(Click)
1.
(Click)
DuoClean® PowerFins™
Floor Nozzle
Press power button to turn vacuum
on or o.
Press the ( ) button to toggle
between ECO, Clean Sense IQ, and
Boost modes. To save battery power,
select ECO mode. For everyday
cleaning power, select Clean Sense
IQ mode. For an extra burst of power,
select Boost mode.
POWER ON/OFF
NOTE: The unit will not turn on if the charger is
connected. Unplug the charger before turning
on vacuum power.
The Clean Indicator visually confirms
when floors are clean. When the unit
senses heavy debris, suction will
increase for more cleaning power.
When the debris is cleared, suction will
decrease. The clean indicator displays
the level of debris detected. For best
results, continue cleaning until the
indicator returns to its lowest level
before moving to the next area.
CLEAN INDICATOR
CLEAN SENSE IQ CLEAN INDICATOR
Medium DebrisClean Heavy Debris
CLEAN INDICATOR
SUCTION POWER MODES
To install the dial, align the teal
arrow on the dial with the teal arrow
on the nozzle, then insert the dial
into the nozzle. Rotate the dial
counterclockwise until it clicks into
an intensity setting to engage. Rotate
further to change the intensity setting.
For IZ862H only
CLEANING THE FILTERS
Regularly rinse and replace the filters to maintain
your vacuum’s suction power and to maximize the
eectiveness of odor neutralization.
To clean filters, rinse them with water only. Allow
all filters to air-dry completely for up to 48 hours
before reinstalling to prevent liquid from being
drawn into electricparts.
Clean the pre-motor filters at least once a month and
post-motor filter at least once a year. Tap o loose dirt
between washes when needed. More frequent cleaning
may sometimes be necessary with heavy use.
IMPORTANT: DO NOT use soap when cleaning the filters. Use water
only. The vacuum will not have suction if the post-motor filter is not
installed. Ensure that all filters are installed before using.
CLEANING THE SENSORS
INSTALL ODOR DIAL IN NOZZLE
ODOR DIAL
SUCTION MODE DISPLAY LIGHTS
ECO
Clean Sense IQ
Boost
Make sure to clean the sensors
inside the hand vacuum regularly,
as hair and other debris may build
up and obstruct them. If the sensors
are partially obstructed, Clean
Sense IQ mode will not adjust suction levels as
expected. If the sensors are completely obstructed,
the F0 error code will appear and the Clean Sense
IQ icon will flash on the hand vacuum display panel.
To clean the sensors:
1. Turn o power and remove the hand vacuum.
2. Locate the sensors inside the nozzle of the hand
vacuum. The sensors are on the interior walls
of the nozzle, about 3 inches down the air path,
aligned with the IQ logos (Fig.2) on the exterior.
3. Gently wipe the sensors with a microfiber
cloth and remove all hair and debris.
4. Turn on power and verify that the unit is
functioning normally.
IQ logos-
both sides
Fig. 2
CLEAN SENSE IQ SENSORS
Hand Vacuum Display Panel
Dust cup
Air path
Fig. 1
Battery