Sharp EL-2902E User manual

EL-2902E
ELECTRONIC PRINTING CALCULATOR
DRUCKENDER TISCHRECHNER
CALCULATRICE IMPRIMANTE ÉLECTRONIQUE
CALCULADORA IMPRESORA ELECTRÓNICA
CALCOLATRICE ELETTRONICA STAMPANTE
ELEKTRONISK SKRIVANDE OCH VISANDE RÄKNARE
ELEKTRONISCHE REKENMACHINE MET AFDRUK
OPERATION MANUAL
BEDIENUNGSANLEITUNG
MODE D’EMPLOI
MANUAL DE MANEJO
MANUALE DI ISTRUZIONI
BRUKSANVISNING
GEBRUIKSAANWIJZING
ENGLISH ............................................................ Page 1
CALCULATION EXAMPLES .............................. Page 50
DEUTSCH........................................................... Seite 8
RECHNUNGSBEISPIELE .................................. Seite 50
FRANÇAIS .......................................................... Page 15
EXEMPLES DE CALCULS ................................. Page 50
ESPAÑOL ........................................................ Página 22
EJEMPLOS DE CALCULOS ........................... Página 50
ITALIANO ........................................................ Pagina 29
ESEMPI DI CALCOLO .................................... Pagina 51
SVENSKA ............................................................ Sida 36
GRUNDLÄGGANDE RÄKNEEXEMPEL ............. Sida 51
NEDERLANDS ................................................ Pagina 43
REKENVOORBEELDEN ................................. Pagina 51
®
EL-2902E(AC7)-Cover 1

1
ENGLISH
INTRODUCTION
Thank you for your purchase of the SHARPelectronic calculator, model EL-2902E.Your
SHARPcalculatorisspeciallydesignedtosaveworkandincreaseefficiencyinallbusiness
applications and general office calculations. Careful reading of this manual will enable
you to use your new SHARP calculator to its fullest capability.
CONTENTS
Page
• OPERATING CONTROLS .................................................................................. 2
• PAPER ROLL REPLACEMENT .......................................................................... 5
• INK ROLLER REPLACEMENT........................................................................... 5
• ERRORS............................................................................................................. 6
• SPECIFICATIONS .............................................................................................. 7
• CALCULATION EXAMPLES............................................................................... 50
• EURO CONVERSION ........................................................................................ 62
OPERATIONAL NOTES
To insure trouble-free operation of your SHARPcalculator, we recommend the following:
1. The calculator should be kept in areas free from extreme temperature changes,
moisture, and dust.
2. Asoft, dry cloth should be used to clean the calculator. Do not use solvents or a wet
cloth.
3. Since this product is not waterproof, do not use it or store it where fluids, for example
water, can splash onto it. Raindrops, water spray, juice, coffee, steam, perspiration,
etc. will also cause malfunction.
4. Ifserviceshouldberequired,use only a SHARPservicingdealer,aSHARPapproved
service facility or SHARP repair service.
5. Ifyoupull outthepowercordto cutelectricitycompletely,the presentlystoredexchange
rate will be cleared.
EL-2902E(AC7)-Eng 00.11.7, 2:15 PM1

2
OPERATING CONTROLS
POWER SWITCH; PRINT / ITEM COUNT MODE SELECTOR:
“OFF”: Power OFF
“•”: Power ON. Set to the non-print mode.
“P”: Power ON. Set to the print mode.
“P•IC”: Power ON. Set to the print and item count mode.
For addition or subtraction, each time
+
is pressed, 1 is added to
the item counter, and each time
–
is pressed, 1 is subtracted.
•The count is printed when the calculated result is obtained.
•Pressing of ,
CCE
CCE
clears the counter.
* The built-in LCD backlight turns on when the calculator’s power is on
and turns off when the power is off.
Note: The counter has a maximum capacity of 3 digits (up to ±999). If the
count exceeds the maximum, the counter will recount from zero.
DECIMAL / ADD MODE SELECTOR:
“3, 2, 1, 0”: Presets the number of decimal places in the answer.
“F”: The answer is displayed in the floating decimal system.
“A”: Thedecimalpointinaddition andsubtractionentries isautomatically
positioned to the 2nd digit from the lowest digit of entry number.
Use of the add mode permits addition and subtraction of numbers
without entry of the decimal point. Use of , and will
automaticallyoverridethe addmodeanddecimally correctanswers
will be printed.
ROUNDING SELECTOR:
Set Decimal Selector to 2.
4 ÷9 = 0.444 ... , 5 ÷9 = 0.555 ...
OFF ON •P•ICP
F 3 2 1 0 A
Note: The decimal point floats during successive calculation by
the use of or .
Ifthedecimalselectorissetto“F”thentheanswerisalwaysrounded
down ( ).
4 9 5 9
5/4 0.44 0.56
0.44 0.55
5/4
EL-2902E(AC7)-Eng 00.11.7, 2:15 PM2

3
GRAND TOTAL MODE SELECTOR:
“GT”: This selector will accumulate the following:
(“ + “will be printed.)
1. Addition and subtraction totals obtained with .
2. Product and quotient totals obtained with
+
or
–
.
3. Answers obtained with
%
or
MU
.
“•”: Neutral
PAPER FEED KEY
LAST DIGIT CORRECTION KEY
GRAND TOTAL KEY:
Prints and clears the “GT”memory contents.
NON-ADD / SUBTOTAL KEY:
Non-add —When this key is pressed right after an entry of a number in the Print
mode, the entry is printed on the left-hand side with “#”.
This key is used to print out numbers not subjects to calculation
such as code, date, etc
Subtotal —Used to get subtotal(s) of additions and/or subtractions. When
pressed following
+
or
–
, the subtotal is printed with “ ” and the
calculation may be continued.
CLEAR / CLEAR ENTRY KEY:
Clear —This key also serves as a clear key for the calculation register and
resets an error condition.
Clear entry —When pressed after a number and before a function, clear the
number.
TOTAL KEY:
When pressed after
+
or
–
, prints the total of addition and subtraction with “∗”.
EQUAL KEY:
Gives the results of multiplication and division and performs repeat calculation
with a constant.
Multiplication:
The calculator will automatically remember the first number entered (the
multiplicand) and instruction.
Division:
Thecalculatorwillautomaticallyrememberthesecond numberentered(thedivisor)
and instruction.
#
GT
CCE
GT •
EL-2902E(AC7)-Eng 00.11.7, 2:15 PM3

4
MU
M
M
STR
CHANGE SIGN KEY:
Changes the algebraic sign of a number (i.e., positive to negative or negative
to positive).
MARKUP KEY:
Used to perform mark-ups, percent change and automatic add-on/discount.
RECALL AND CLEAR MEMORY KEY
RECALL MEMORY KEY
STORE KEY:
This key is used to store an exchange rate.
•Amaximum of 6 digits can be stored (decimal point is not counted as a digit).
•Only one rate can be stored. If you enter a new rate, the previous rate will be
cleared.
CONVERSION KEY (TO A NATIONAL CURRENCY)
CONVERSION KEY (TO THE EURO CURRENCY)
M : Memory symbol
Appears when a number is in the memory.
– : Minus symbol
Appears when a number is negative.
E : Error symbol
Appears when an overflow or other error is detected.
G : Grand total memory symbol
Appears when a number is in the grand total memory.
: National Currency symbol
Appearswhenanenteredvalueisconverted topresentnationalcurrency.
This symbol also appears when an exchange rate is stored.
: Euro Currency symbol
Appears when an entered value is converted to Euro currency.
This symbol also appears when an exchange rate is stored.
DISPLAY SYMBOLS:
+–
EL-2902E(AC7)-Eng 00.11.7, 2:15 PM4

5
PAPER ROLL REPLACEMENT
DO NOT PULL PAPER BACKWARDS AS THIS MAY CAUSE DAMAGE TO
PRINTING MECHANISM.
Never insert paper roll if torn. Doing so will cause paper to jam.Always cut leading
edge with scissors first.
1) Insert the leading edge of the paper roll into the opening. (Fig.1)
2) Turn the power on and feed the paper by pressing . (Fig.2)
3) Lift the attached metal paper holder up and insert the paper roll to the paper holder.
(Fig.3)
Fig. 1 Fig. 3Fig. 2
INK ROLLER REPLACEMENT
If printing is blurry even when the ink roller is in the proper position, replace the roller.
Ink roller: Type EA-781R-BK (Black)
Type EA-781R-RD (Red)
WARNING
APPLYING INK TO WORN INK ROLLER OR USE OF UNAPPROVED INK
ROLLER MAY CAUSE SERIOUS DAMAGE TO PRINTER.
1) Set the power switch to OFF.
2) Remove the printer cover. (Fig. 1)
3) Remove the ink roller by turning it counterclockwise and pulling it upward. (Fig. 2)
4) Install the correct color new ink roller and press it in the correct position. Make sure
that the ink roller is securely in place. (Fig. 3)
5) Put back the printer cover.
EL-2902E(AC7)-Eng 00.11.7, 2:15 PM5

6
Cleaning the printing mechanism
If the print becomes dull after long time usage, clean the printing wheel accord-
ing to the following procedures:
1) Remove the printer cover and the ink roller.
2) Installthepaperroll andfeedituntilit comesoutofthefront oftheprintingmechanism.
3) Put a small brush (like a tooth brush) lightly to the printing wheel and clean it by
pressing .
4) Put back the ink roller and the printer cover.
Notes: •Do not rotate the printing mechanism manually, this may damage the printer.
•Never attempt to turn the printing belt or restrict its movement while printing.
This may cause incorrect printing.
Fig. 2Fig. 1 Fig. 3
Red Black
There are several situations which will cause an overflow or an error condition. When
this occurs, “E”will be displayed. The contents of the memory at the time of the error are
retained.
If “0 •E”is displayed at the time of the error, “– ––––––” will be printed in red and
CCE
must be used to clear the calculator.
Error conditions:
1. When the integer portion of an answer exceeds 12 digits.
2. When the integer portion of the contents of the memory exceeds 12 digits.
(Ex.
M
999999999999 M+1 M+)
3. When any number is divided by zero. (Ex. 5 0 ).
ERRORS
EL-2902E(AC7)-Eng 00.11.7, 2:15 PM6

7
SPECIFICATIONS
Operating capacity: 12 digits
Power supply: AC: 220-230V, 50Hz
Calculations: Four arithmetic, constant multiplication and division, power,
add-on, repeat addition and subtraction, reciprocal, grand
total, item count calculation, markup, memory, conversion
between a national and the euro curreny, etc.
PRINTING SECTION
Printer: Mechanical printer
Printing speed: Approx. 3.0 lines/sec.
Printing paper: 57 mm (2-1/4”) –58 mm (2-9/32”) wide
80 mm (3-5/32”) in diameter (max.)
Operating temperature: 0°C –40°C (32°F - 104°F)
Power consumption: 33 mA
Dimensions: 200 mm (W) ×251 mm (D) ×62 mm (H)
(7-7/8”(W) ×9-7/8”(D) ×2-7/16”(H))
Weight: Approx. 910 g (2.01 lb.)
Accessories: 1 paper roll, 2 ink rollers (installed), and operation manual
.,1234567890 gkg
.,1234567890 gkg
.,1234567890 gkg
.,1234567890 gkg
.,1234567890 gkg
.,1234567890 gkg
.,1234567890 gkg
EL-2902E(AC7)-Eng 00.11.7, 2:15 PM7

8
DEUTSCH
EINLEITUNG
Wir freuen uns, daß Sie sich zum Kauf des elektronischen Rechners Modell EL-2902E
von SHARP entschieden haben. Der Rechner ist speziell für leistungsintensiven,
arbeitssparendenBetriebentworfen. UmalleFunktionendieses neuenSHARPRechners
invollemUmfangnutzen zu können, lesenSiebittedieseBedienungsanleitung sorgfältig
durch.
INHALT
Seite
• BEDIENUNGSELEMENTE................................................................................. 9
• AUSTAUSCHDERPAPIERROLLE .................................................................... 12
• AUSTAUSCHDERTINTENROLLE .................................................................... 12
• FEHLER.............................................................................................................. 13
• TECHNISCHE DATEN ........................................................................................ 14
• RECHNUNGSBEISPIELE .................................................................................. 50
• EURO-UMRECHNUNG ...................................................................................... 62
HINWEISE ZUM BETRIEB
Um den störungsfreien Betrieb dieses SHARP Rechners sicherzustellen, beachten Sie
bitte folgende Punkte:
1. DenRechnernichtanOrtenaufbewahren,woerextremhohenTemperaturschwankungen,
Feuchtigkeit oder Staub ausgesetzt ist.
2. Zum Reinigen des Rechners verwendet man ein trockenes, weiches Tuch. Keine
Lösungsmittel oder feuchte Lappen verwenden.
3. Da dieses Produkt nicht wasserdicht ist, sollten Sie es nicht an Orten benutzen oder
lagern,dieextremer Feuchtigkeitausgesetztsind. SchützenSiedas GerätvorWasser,
Regentropfen, Sprühwasser, Saft, Kaffee, Dampf, Schweiß usw., da der Eintritt von
irgendwelchen Flüssigkeit zu Funktionsstörungen führen kann.
4. Sollte eine Reparatur dieses Gerätes erforderlich sein, wenden Sie sich nur an einen
SHARP-Fachhändler, eine zugelassene SHARP-Reparaturwerkstatt oder an eine
SHARP-Kundendienststelle.
5. Wenn Sie das Netzkabel von der Steckdose abtrennen, um die Stromversorgung
vollständig zu unterbrechen, wird der aktuell gespeicherte Wechselkurs gelöscht.
EL-2902E(AC7)-Ger 00.11.7, 2:16 PM8