Sharp PN-L862B User manual

PN-L862B Dismantle Instruction
1
Dismantle Instruction
LCD
MONITOR
MODEL
PN
-
L
86
2B

PN-L862B Dismantle Instruction
2
Table of contents
1. Scope .................................................................................................................. 3
2. Tools for dismantling ................................................................................................ 3
3. Dismantle Procedure ................................................................................................ 3
4. Back covers ........................................................................................................... 4
5. Printed circuit boards ............................................................................................... 5
6. Battery ................................................................................................................ 6
7. LCD Module ........................................................................................................... 7
8. Capacitors ............................................................................................................ 8
9. Parts List .............................................................................................................. 9

PN-L862B Dismantle Instruction
3
1. Scope
This document describes dismantling instruction according to Annex VII of Directive 2012/19/EU.
2. Tools for dismantling
Below tools are required to dismantle this product.
- Screw Driver
- Nipper
3. Dismantle Procedure
This product can be dismantled by below steps.
1. Remove Back covers (section 4)
2. Remove Printed circuit boards (section 5)
3. Dismantle LCD (section 7)
4. Remove Electrolyte Capacitors (section 8)

PN-L862B Dismantle Instruction
4
4. Back covers
Big back cover(x1),Middle back cover(x1),Right small back cover(x1) ,Left small back cover(x1)
Can be removed by screw driver.

PN-L862B Dismantle Instruction
5
5. Printed circuit boards
All PWBs can be removed by screw driver.
Main I/F PWB (1pcs) Power PWB (1pcs)
Temperature sensor PWB (1pcs) AC inlet PWB (1pcs) Wi-Fi module PWB (1pcs)
T-CON PWB (1pcs) Front Key PWB (1pcs)

PN-L862B Dismantle Instruction
6
6. Battery
Battery can easily be removed from the battery holder.

PN-L862B Dismantle Instruction
7
7. LCD Module
- LCD Dismantle procedure
After you have removed the PWB´s and dismantled the LCD Module please take out the cables from the
LCD module.
Due to direct bonding technology the front glass cannot be removed from the LCD.
LCD bonding

PN-L862B Dismantle Instruction
8
8. Capacitors
Electrolyte Capacitors which diameter/height is larger than 25mm is installed on Power PWB,
LED driver PWB and 5V Power PWB.
These capacitors can be removed by using nipper to cut the leads.
On Power PWB

PN-L862B Dismantle Instruction
9
9. Parts List
Parts described in Annex VII of directive 2012/19/EU are as below.
Parts Note
LCD 86inch LCD module
Printed Circuit Boards Main I/F PWB
Power PWB
Temperature sensor PWB
AC INLET PWB
Wi-Fi module PWB
T-CON PWB
Front Key PWB
Battery Battery (AAA) of remote control
Electrolyte capacitors
(height >25mm, diameter >25mm)
On Power PWB
External electric cables 2 kinds of Power Cord
- for EU
- for UK