Paper Replacement
Open the printer paper cover and remove
the remaining core of the old paper roll (if
necessary).
Install the new paper roll as shown, aligning
the paper roll correctly.
Pull the paper out and close the paper cover.
Press the FEED buon to test the paper
feeds correctly.
Paper Cover
Baery Removal & Replacement
To remove the baery, push the baery clip
down and move the baery away from the
printer casing as shown.
To replace the baery, install the baery in
the printer casing.
Push the baery into posion in the printer
casing. A clicking sound indicates the baery
is installed correctly.
Specicaons
Dimension:
106.5 (L) x 78 (W) x 47 (H) mm
Weight:
190 g (excluding roll paper)
Operang Temp:
0 °C to +40 °C (+32 °F to +104 °F)
Operang Humidity:
<95% RH
Storage Temp:
-20 °C to +60 °C (-4 °F to +140 °F)
Storage Humidity:
-10% to +90%
Part No.: SDH-BTP
Baery
DC7.4V, 1.5 A rechargeable Li-ion
baery 1500 mAh
Fully charged in two hours.
Standby me over 15 days
Part No.: SDH-BTP-BA
Low Power Alarm and
Auto Sleeping
If the baery charge is low during
prinng the power indicator will
turn RED to show that there is
sll data to be printed. If there is
no data to print, the printer will
move into a sleep mode aer two
seconds.
It will awaken if the FEED buon is
pressed or data is sent to it.
Bluetooth
Range: 20 m
Authorisaon Code: 0000
Power Unit
Model ABT015084
AC Voltage Input Range:
90 - 260 Vac
Input Frequency Range:
50 or 60 Hz
Rated Working Output:
DC Voltage 5.4 - 8.0 V
Rated Working Output:
DC Current 1.35 - 1.65 A
Charging condion from red light
to green light 0.08 A < Iin <0.2 A or
Vout > 8.45 V
Features over current and short
circuit protecon
Part No.: SDH-BTP-CH
Paper
Type:
Thermal Paper
Width:
58 mm
Roll Diameter (Maximum):
40 mm
Thickness:
60 - 80 µm
Part No.: SDH-BTP-PA
Power Supply Connecon
Connect the power cable to the printer
power cable port (as shown below).
Charge the printer baery as required.
Make sure the power cable end is orientated
correctly to the printer power port before
connecng.
NOTE: The USB connecon is not operaonal and
cannot be used with the instrument.
2 3
