Shenzhen ATC Technology ATC-1000 User manual

QuickStart Guide
TCP/IP TO RS-232/422/485 CONVERTER
MODEL ATC-1000
1
1
1.Check Package Content
ATC-1000 unit 1Pcs
Printedversionof thisATC-1000Quick Start Guide
1Pcs
Software CD 1Pcs
Ext power adapter1Pcs
2
2.HardwareInstallation
Connect anEthernet cabletoATC-1000unit if connecting
toaswitch or cross-over direct to thePC asfigure1
Figure1
ATC-100010/100Port t connect toEthernet carduse
coss-Through Cable asfigure2
Figure2
RS-232Pinout：（DB9 Male）
RS-422/485 Pinout：（SixTerminal from left）
Terminal
No 1234
56
RS-422
T+ T-R+
R-
VIN
GND
RS-485
485+
485-
--
VIN
GND
Connect thepoweradapter toATC-1000 and other apply
power. Powerfromother device.(+9--+24V@500-100mA)
3
3.LED indication
LINK IndicationEthernet Link GreenonEthernet Link
established。
ACT Data Sending/Receivingbetween Serial andthe
Ethernet
PWRIndicationPower
4
4.SoftwareInstallation
Insert the software CD andsearchforsuchasF:/Driver/
ATC-1000 folder torun VCOMSETUP.
Note: Be sure youhaveadministrativerights&disable
firewallsin windows XP
5
5.Configure the ATC-1000
Usethissection to set upyour computer toassign it a static
IP address in the 192.168.2.2to192.168.2.254 range with a
subnet mask of 255.255.255.0. This isnecessary toensure
that your computer can communicate with yourATC-1000.
Your computer must haveanEthernet card andTCP/IP
installed. TCP/IP should alreadybe installedon computer
usingWindows98/2000/XP andlater operatingsystems.
Openyour web browserandtype http://192.168.2.1 in the
browser saddress box. Thisaddress isthe factory set IP
Address of your ATC-1000. Press “Enter”.
The Usernameand Passwordrequired”prompt boxwill
appear. Typing “admin”(default username) in theUsername
field and typing system”(default password) inthe Password
field. Click “OK”. Thesetup screenwill then appear.
（DB9Male）
Signal I/O
PIN2RXD IN
PIN3TXD OUT
PIN5GND -