Digitus DC-40100 User manual

DVI to VGA
Conversion Box
(DC-40100)
USER MANUAL V1.0
DC-40100
Package Contents-
1 Digitus DC-40100
1 user manual
1 power adapter DC 9V/600mA
1 Digitus 1.2M cable (DVI-D Male to Male)
Any thing missed, please contact with your vendor.
Introduction
The DC-40100 Converter connect computer with DVI-D
connector to analog monitor or projector. The converter
changes your PC digital DVI signal to analog graphic signal,
so that analog display device or projector can be connected
to your PC digital output easily and conveniently.
Features
Use PanelLink digital technology
Compliant with the specification of DVI 1.0
Support high-resolution display up to UXGA
(25-165MHz)
Connect PC with DVI-D connector to analog monitor or
projector
Specifications
Function DC-40100
Video Input Connector
(DVI Female) 1
Video Output Connector
(VGAFemale) 1
Max. Resolution 1600x1200 60Hz
Cable Distance
(Single end) 12 m (Max.)
Input Signal Type Standard DVI Signal
Output Signal Type Standard VGA Signal
Power Adapter (Min.) DC 9V 600mA
Housing Metal
Weight 300g
Dimensions (LxWxH) 128x75x29 mm
Note:
Different cable qualify might effect upon the maximum
resolution and cable distance.
-1-
Technical Specifications
Input/Output Signal
Pin # Signal Pin # Signal
1 T.M.D.S Data 2- 16 Hot Plug Detect
2 T.M.D.S Data 2+ 17 T.M.D.S Data 0-
3 T.M.D.S Data 2/4 Shield 18 T.M.D.S Data 0+
4 T.M.D.S Data 4- 19 T.M.D.S Data 0/5 Shield
5 T.M.D.S Data 4+ 20 T.M.D.S Data 5-
6 DDC Clock 21 T.M.D.S Data 5+
7 DDC Data 22 T.M.D.S Clock Shield
8 Analog Vert. Sync 23 T.M.D.S Clock+
9 T.M.D.S Data 1- 24 T.M.D.S Clock-
10 T.M.D.S Data 1+
11 T.M.D.S Data 1/3 Shield C1 Analog Red
12 T.M.D.S Data 3- C2 Analog Green
13 T.M.D.S Data 3+ C3 Analog Blue
14 +5V Power C4 Analog Horz Sync
15 GND C5 Analog Ground
FRONT VIEW
1. “DVI In” Port
2. Input Power Jack
-2-

REAR VIEW
1. Power LED
2. “VGA Out” Port
Installation
1. Turn off the PC and monitor.
2. Connect the DVI male extension cable between the PC
and the “DVI In” port of DC-40100.
3. Connect the VGA male extension cable between the
monitor and the “VGA Out” port of DC-40100.
4. Connect the power cord and turn on the DC-40100.
5. Turn on the PC and analog monitor or projector.
Trademarks:
All the companies, brand names, and product names
referred to this manual are the trademarks or registered
trademarks belonging to their respective companies.
-3-