Sherlock BBGC200S User manual

SILVAN AUSTRALIA PTY. LTD.
ABN 48 099 851 144
HEAD OFFICE
68 Atlantic Drive, Keysborough VIC 3173
www.sherlocklastlonger.com.au
FOR SERVICE SUPPORT PH 1300 745826
[email protected]
Assembly Instructions
MANBBGC200S2 - REV A 4/9/19
SHERLOCK STEEL GARDEN CART
BBGC200S

Page | 2
IMPORTANT SAFETY INSTRUCTIONS
 When inflating tyres, it is recommend using a bicycle or
foot pump to prevent over inflation. The maximum
pressure is 30psi. Never use air compressors as the risk
of over inflation and bursting is high.
 Do not allow children to use the cart without supervision,
it is not a toy.

Page | 3
PARTS LIST
HARDWARE LIST
Step 1: BOTTOM SUPPORT AND HANDLE BEAM
Assemble parts 𝐶 and 𝐷 together, use washer 6 and pin 7 to secure as shown
in the diagrams.
(1 PC) Bottom Support 𝐶
(1 PC) Handle Beam 𝐷
(1 PC) Washers 16mm 6
(1 PC) Pins 7

Page | 4
Step 2: BED AND AXLE BAR
Use assembled part from Step 1 for the front of the bed 𝐺, use bolts (4 PCS) 1,
(4 PCS) nuts 3 and washers 4 to fasten this to the bed. Use remaining nuts 3,
bolts 1 and washers 4 to fasten axle bar 𝐵 to the back of the bed.
(8 PCS) 8mm x 16mm Washer 4
(8 PCS) 8mm x 60mm Carriage Support Bolts 1
(8 PCS) Nuts 3
(1 PC) Axle Bar 𝐵
(1 PC) Bed 𝐺
Step 3: WHEELS
Connect the wheels to the axle bar at the front and back as shown. Use washers
6 and pins 7 to secure each wheel.
(4 PCS) Wheels 𝐸
(4 PCS) Washers 6
(4 PCS) Pins 7

Page | 5
Step 4: FRAME
Lock side fence 𝐹 to each side of the bed using assembly pins 5 as shown, use
remaining assembly pins 5 to secure the front and back fence 𝐻 to the bed.
(2 PCS) Side Fences 𝐹
(2 PCS) Front & Back Fences 𝐻
(8 PCS) Fence Assembly Pins 5