Rock-N-Roller Multi-Cart R14G User manual

R14G Model Specifications Your RocknRoller Multi-Cart shipping box should
contain a frame and the following parts: Recommended Tools For Assembly
Length (Compact) 42” 2 x ½” lock nuts
Length (Extended) 60” 2 x ½” at washer Channel Lock Pliers
(not included)
Width (Frame Bed) 15” 2 x 1/8”x 1 ¼”cotter pins
Width (Rear Wheels) 20” 2 x 20mm flat washers
Height (Folded) 10” 2 x 8"x 3" (200mm x 75mm) rear wheels
Height (Unfolded) 38” 2 x 6"x 3" (150mm x 75mm) stem casters
Front Casters 6” x 3” 1 x Flat Wrench
Rear Wheels 8” x 3” 1 x Assembly/instruction sheet
Weight 36 lbs.
Load Capacity 700 lbs.
1. Installing Rear Wheels
Gently slide wheel over axle as shown.
Do not force wheels onto axle. It is
recommended to lubricate axles with light
grease before installing. Install cotter pins
and bend ends outward.
2. Installing Front Swivel Casters
Attach front swivel casters as shown. While tightening lock nuts, grip
bearing cap with channel lock pliers or pipe wrench to prevent threaded
stem from turning. Tighten lock nuts rmly, but not excessively tight.
Check lock nut tightness on caster stems periodically.

Extending Frame
Loosen wingbolts 1/4 turn. Step on
rear axle and push in extension
stop button. Pull up on frame as
shown until stop button engages.
Retighten wingbolts.
Raising Foldable Sides
Firmly press down on release cable
while raising other end of foldable
side as shown.
Repeat with other side.
Solid Deck Cable/headphone
hanger Laptop Shelf Flex Straps