SHURflo LVPO F-1 User manual

94-399-00
94-470-01
94-470-02
Installation and Operation Manual
Specifications
Temperature Range: 40-100°F (4.4-37.8°C)
Pressure Range: 20-125 psi (1.4-8.62 bar)
The LVPO F-1 System is Tested and
Certied by NSF International against
NSF/ANSI Standard 42 for the reduction
of Chlorine Taste & Odor.
The LVPO F-2 is Tested and Certied
by NSF International against NSF/ANSI
Standard 42 for Nominal Particulate
Class III.
United States and foreign patents pending.
Gray Latch
(Inlet)
NOTE: Ball valve with gray
handle install in lter opening
with gray latch (inlet)
Ball valve with blue handle
installs in lter opening with
blue latch (outlet)
911-760 Rev D NO09
LVPO F-1, LFVO-F2, LVPO F-3
11" x 8.5" folded to 5.5" x 8.5"
Prints Black • updated 22 October 2009
Blue Latch
(Outlet)
911-760d LVPO F-1 F-2 F-3 IO NO09.indd 1 12/1/09 8:16:43 AM

Performance Data
Important Notice: Read this performance data and compare the capabilities of this system with
your actual water treatment needs. It is recommended that, before installing a water treatment
system, you have your water supply tested to determine your actual water treatment needs.
This system has been tested according to NSF/ANSI 42 for the reduction of the substances listed
below. The concentration of the indicated substances in the water entering the system was reduced
to the concentrations less than or equal to the permissible limit for water leaving the system, as
specied in NSF/ANSI 42.
Model Number LVPO F-1
Substance
Influent
Challenge
Concentration
Maximum
Permissible
Product Water
Concentration
Reduction
Requirements
Minimum
Reduction
Average
Reduction
Standard 42 Aesthetic Effects
Chlorine 2.0 mg/L +/- 10% ≥50% 90.6%
Flow Rate = 3.0 gpm (11.4 lpm) Capacity = 6,000 Gallons (22,714 liters)
Test Conditions Operating Requirements
Flow Rate = 2.0 gpm (7.6 LPM) Pressure = 20-125 PSI (1.4-8.62 bar)
Inlet Pressure = 60 +/- 3 PSI (4.1 bar) Temperature = 40-100° F (4.4-37.8° C)
pH = 7.5 +/- 1
Temperature = 68°F +/- 5°F (20°C +/- 2.5°C)
Testing was performed under standard laboratory conditions, actual performance may vary.
Model Number LVPO F-2
Substance
Influent
Challenge
Concentration
Maximum
Permissible
Product Water
Concentration
Reduction
Requirements
Minimum
Reduction
Average
Reduction
Standard 42 Aesthetic Effects
Particulate
5 to <15 μm
Class III
at least 10,000
particles/ml ≥85% 98.1%
Flow Rate = 3.0 gpm (11.4 lpm)
Test Conditions Operating Requirements
Flow Rate = 3.0 gpm (11.4 lpm) Pressure = 20-125 PSI (1.4-8.62 bar)
Inlet Pressure = 60 +/- 3 psi (4.1 bar) Temperature = 40-100° F (4.4-37.8° C)
pH = 7.5 +/- 1
Temperature = 68°F +/- 5°F (20°C +/- 2.5°C)
Testing was performed under standard laboratory conditions, actual performance may vary.
911-760d LVPO F-1 F-2 F-3 IO NO09.indd 2 12/1/09 8:16:43 AM

Inline Water Filtration System
Installation Recommendations
The LVPO F-1, LVPO F-2 and LVPO F-3 Series Inline lters are only1.
effective when water ow is consistent with the directional ow
arrow identied on the lter. Install the lter with the water ow
following the direction of the arrow on the label.
Install in a location convenient for lter replacement.2.
Inline lter life depends upon the water volume used and3.
the substances present in the water source. Manufacturer
recommends changing the lter every 6 to 12 months.
Installation Instructions
Turn the water off.1.
Disconnect the existing lter or cut the cold water tubing where2.
the lter will be installed.
Note: Cut the tubing square and cleanly. Tubing that is not cut square may
leak. Remove all score marks and burrs from the tubing. Install SHURo
SHURt™ style ttings into tubing.
Verify water ow matches the direction of the ow arrow on3.
the lter.
Connect the inlet and outlet ttings to lter.4.
See Figures 1 and 2. (Connect water supply line to inlet)
When installing any lter, ush the lter by holding it, outlet end5.
down, over a bucket or pan. Turn the water on for 5 minutes, turn
the water off. Repeat this process till the water runs clear.
Connect the outlet water line to the appliance inlet.6.
Carefully turn on the water and check for leaks.7.
Recheck for leaks at intervals for several hours following the8.
installation.
Insert SHURt™
ttings into lter
Unlocked latch position
for installation
Slide latch into locked
position and conrm tting
is secured in location.
Figure 1
Figure 2
911-760d LVPO F-1 F-2 F-3 IO NO09.indd 3 12/1/09 8:16:43 AM

SHURflo, LLC
5900 Katella Avenue
Cypress, CA 90630
(800) 854-3218
(532) 795-5200
Fax (562) 795-5200
www.shurflo.com
911-760 Rev D NO09 ECO# 15375
©2009 SHURflo, LLC All Rights Reserved.
Precautions
Warning
Do not use with water that is microbiologically
unsafe or of unknown quality without adequate
disinfection before or after this system.
Note For operating, parts, installation or
maintenance assistance call (800) 854-3218.
Caution
Filter must be protected against freezing,
which can cause cracking of the lter and
water leakage.
Note:
Substances reduced are not necessarily
in your water. Filter must be maintained
according to manufacturer’s instructions,
including replacement of lter cartridge.
Caution
Install this lter on cold water lines only. Do not
use on water lines exceeding 100°F (37.2°C).
Minimum water pressure of 20 psi (1.4 bar) and
a maximum water pressure of 125 psi (8.62 bar)
is required.
Note:
Keep this unit clean with soap and water.
Do not spray cleaners or insecticides near
this unit.
Caution
When installing behind an appliance use
ample amount of tubing to allow removal of
the appliance to prevent damage to the tubing,
lter or ttings. Damage to tubing, lter or
ttings could cause leakage and damage.
Note
Note
Do not install lter close to a heat source
or on a water line with temperatures outside
the operational temperature range as stated
above.
Comply with all state and local laws
and regulations.
Inline Water Filter System (LIMITED WARRANTY)
SHURo Inline Water Filter Systems are warranted to be free of defects in material and workmanship,
under normal use, for a period of one (1) year from the date of manufacture OR one (1) year of use, with
proof of purchase. This limited warranty will not exceed two (2) years, in any event.
The limited warranty will not apply to Inline Water Filter Systems that were improperly installed,
misapplied, or incompatible with uids or components not manufactured by SHURo. Inline Water Filter
System failure due to foreign debris is not covered under the terms of this limited warranty. SHURo
will not warrant any Inline Water lter System which is modied outside the SHURo factory.
Returns are to be shipped postage prepaid to either service center; SHURo Cypress, CA or
Hanover Park, IL. SHURo shall not be liable for freight damage incurred during shipping.
SHURflo reserves the right to update specifications, prices, or make substitutions.
911-760d LVPO F-1 F-2 F-3 IO NO09.indd 4 12/1/09 8:16:43 AM
This manual suits for next models
5
Popular Water Filtration System manuals by other brands

Pentair
Pentair EVERPURE ENDURANCE EV943730 Installation, operation, maintenance guide

Antunes
Antunes WATER WRO-50-R owner's manual

Husqvarna
Husqvarna C 3000 Operator's manual

LifeSource
LifeSource ScaleSolver SSC-4025 Installation, operation and maintenance manual

Aquatek
Aquatek ATAIOIF Series Operation & maintenance manual

Eriez
Eriez HMDA Installation, operation and maintenance instructions