Siemon LightStack UHD User manual

LightStack™ UHD Plug and Play Fiber
Enclosure Instructions
TOOL
1 Front Cable Manager
Note: Protruding
installation is not
compatible with Front
Cable Manager

LightStack™ UHD Plug and Play Fiber
Enclosure Instructions
3
Mounting holes for
Front
Cable Manager
Note: The edge of Front Cable
Manager should align with the
edge of Enclosure.
1
2
Protection tape(4 places)
etro Fit Front Cable Manager
Do not remove the protection tape before Front Cable Manager is securely
attached and the mounting screws have been tightened. (see step 3)

LightStack™ UHD Plug and Play Fiber
Enclosure Instructions
5
Remove front door by pulling
out the latches on both sides,
allowing full access to LC ports
in the front of the panel.
6Labeling
4a
Use push-pull feature to remove jumper
Use with Siemon LC BladePatch Jumpers 4b Use with Siemon FJ2/J2 LC Jumpers
Use a 3rd part extraction tool to remove jumper

Global Headquarters
Watertown, Connecticut USA
Tel: [phone]
For a complete li ting of our global office vi it our web ite
www.siemon.com
Comply with the following for safe installations:
A. Use caution when installing or modifying
telecommunications circuits.
B. Never touch uninsulated wire terminals unless
the circuit has been disconnected.
C. Never install this device in a wet location.
D. Never install wiring during a lightning storm.
© 0 1 Siemon Rev. A XX/XX 100.27670.00
LightStack™ UHD Plug and Play Fiber
Enclosure Instructions
9ear Cable Management
Mounting holes for
ear Cable Manager
Apply slight side pressure on
mounting tabs as inserted
into the mounting holes
Apply slight side pressure on
mounting tabs as removed
from the mounting holes
ear Cable Manager ear Cable Manager
7 8