Signature SRB3000A++X User manual

SRB3000A++X
REFRIGERATEUR REFRIGERATOR

-1-
-3-
-4-
-6-
-7-
-8-
-10-
Consignesdesécuritéimportantes

1
�
Silecâbled’alimentationestendommagé,ildoitêtreremplacé
parlefabricant,sonserviceaprèsventeoudespersonnesde
qualificationsimilaireafind’évitertoutdanger.
�
L’eaucontenuedanslesalimentsoudansl’airàl’intérieurdu
réfrigérateurenouvrantdesportespeutformerunecouchede
givreàl’intérieur,celavaaffaiblirlefonctionnementduréfrigérateur
lorsquelegelestépais.Quandilestdeplusde2mmd’épaisseur,
vousdevezdégivrerleréfrigérateur.
�
Ilestdéconseillédegratterlaglaceetlegelouséparerles
alimentsducontenantquiontétécongeléensembleavecunoutil
tranchantoulesbarresenbois,demanièreànepasendommagerle
cadreintérieuroulasurfacedel’évaporateur.
�
CetappareilsatisfaitauxdirectivesCE,ilaétécontrôléd’après
touteslesdirectiveseuropéennes,actuelles,applicables,tellesquela
compatibilitéélectromagnétique(EMC)etlabassetension(LVD).
Cetappareilaétéconçuetfabriquéenrespectantdesdernières
réglementationsetprescriptionstechniques,enmatièredesécurité.
CONSIGNESDESECURITEIMPORTANTES
1.CONSIGNESDESECURITEIMPORTANTES

2
CONSIGNESDESECURITEIMPORTANTES
1.CONSIGNESDESECURITEIMPORTANTES

3

4
INSTRUCTIONSD’INSTALLATION

5
INSTRUCTIONSD’INSTALLATION

6

7

8

9
thermostatthermostat
prise de
courant
prise de
courant
jaune/vertjaune/vert
jaune/vertjaune/vert
jaune/vertjaune/vert
marronmarron blancblanc
PhasePhase
TerreTerre
NeutreNeutre
KlixonKlixon
relaisrelais
compresseurcompresseur
Schéma de circuit électrique

SRB3000A++X
AC 220-240V
0.45A
50Hz
85W
310 L
R600a(86g)
0.580kW.h/24h
CLASSE I
70kg
CYCLOPENTANE
10
ST

7. Technical Specifications
6. Troubleshooting
5. Cleaning and Maintenance
4. Operation
3. Instructions for Installation
2. Structure Illustration
1. Safety Precautions -1-
-3-
-4-
-6-
-7-
-8-
-10-
TABLE OF CONTENTS
TABLE OF CONTENTS

1. SAFETY PRECAUTIONS
Water contained in food or getting into air inside the refrigerator by
opening doors may form a layer of frost inside, It will weaken the
refrigerator when the frost is thick, while it is more than 2mm thick,
you should defrost.
Defrosting in freezer chamber is operated manually. Before defrosting,
take the food, the ice tray and the shelf out into the cold storing
chamber temporarily then set the knob of the temperature regulator
to position"0"(where the compressor will stop working)and leave the
door open until ice and frost dissolve thoroughly deposited at the
bottom of the freezer chamber, wipe off the water with soft cloth.
In the case of speeding up the defrosting, you may put a bowl of
warm water (about 50 C )into the freezer chamber, and be sure to
set the knob of the temperature regulator to original position after
defrosting.
It's inadvisable to heat the freezer chamber directly with hot water
or hair dryer while defrosting to prevent deformation of the inner case.
It's also inadvisable to scrape of ice and frost or separate food from
the containers which have been congealed together with the food
with sharp tool or wooden bars, so as not to damage the inner
casing or the surface of the evaporator.
If the supply cord of this appliance is damaged, it must only be
replaced by a repair shop appointed by the manufacturer, be
cause special purpose tools are required.
1
Check that the voltage of the wall socket in your home is same
as the voltage shown on the rating label of this product.
THIS PRODUCT IS FOR HOUSEHOLD USE ONLY!
Please read these instructions carefully before the first use of
this product and save this manual for your future reference.

1. SAFETY PRECAUTIONS
Children should be supervised to ensure that they do not play
with the appliance.
This appliance is not intended for use by persons (including
children) with reduced physical, sensory or mental capabilities,
or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the appliance
by a person responsible for their safety.
To prevent the risk of electrical shock, this appliance is
equipped with an earthing plug and should be connected
to a grounded socket.
If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified persons to
avoid a hazard.
It is recommended to check regularly the supply cord for any
sign of possible deterioration, and the appliance should not be
used if the cable is damaged.
The appliance is not intended to be operated by means of an
external timer or a separate remote control system.
2

2. STRUCTURE ILLUSTRATION
Thermostat
Drain Port
Crisper Cover
Crisper
Freezing Drawer
Drain hose
(Back)
Compressor
(Back)
Leveling Feet
Upper bracket
Lower bracket
Gasket
Shelf
3

3. INSTRUCTIONS FOR INSTALLATION
Ensure that the appliance is connected to the
correct power supply-(230V~50Hz)
Good Ventilation
Power Supply
Power Line Cord
Protection from Moisture
There is need of good ventilation around the refrigerator
for easy dissipation of heat, high efficiency of refrigeration
and low power consumption. For this purpose, sufficient
clear space should be need around the refrigerator. Its
back is at least 100mm away from the wall, its sides at
least have a space of 100mm separately and the height
from over its top is not less than 200mm. A clear space
should be left to open its doors to 160
The cord should be neither lengthened nor folded
into coil during operation. Moreover, it is forbidden
that cord is kept close onto the compressor at the
back of the refrigerator, the surface temperature
of which is quite high when operating. Touching
with it would deactivate the insulation or cause
leakage for electricity.
Avoiding placing the refrigerator in a place where
heavy moisture is present so as to minimize possibility
of rusty for its metal parts. Still more, the refrigerator is
forbidden to be directly sprayed by water, otherwise,
poor insulation and current leakage would occur.
4

3. INSTRUCTIONS FOR INSTALLATION
Protection from Heat
Fixing Stable
Keep Away from Danger
Moving
Floor on which refrigerator will be placed must be
flat and solid. It should not be laid on any soft
material such as foam plastic, etc. If the refrigerator
is not onthe same level, adjust the screws suitably.
The refrigerator should not be placed near anything
which may echo.
It is inadvisable that the refrigerator is placed near
any volatilizable or combustible such as gas, petrol,
alcohol, lacquer and banana oil, etc. The above-
mentioned objects can not be stored in the
refrigerator.
When fixed or moved, the refrigerator can not be
set horizontally or declined to more than 45 or
upside-down.
The refrigerator should be far away from any
heat source or direct sunshine.
5

1. When operating the refrigerator for the first time, set the
thermostatic dial at 3, connect the electric wire and run it
without loading any food. Usually this takes 2 or 3 hours. Then
set the thermostatic dial at the desired setting and place
foods into the refrigerator .
The temperature of the refrigerator can be adjusted by turning
the thermostatic dial. setting of the thermostatic dial at 3~4 is
the most suitable for general operation. The thermostatic dial
number higher the refrigeration capabilitystronger .
When you set it to 0, the refrigerator will stop.
2.
4. OPERATION
Do not put too many foods in the refrigerator .
Open the door lesser in order to maintain the
temperature of the refrigerator and save
electric consumption.
3.
Defrost the freezer whenever the layer of frost on the surface
reaches 3 or 4 mm . When defrosting , remove all foods and
appendix, set the thermostat at 0 position and open the door.
After the frost has melted , discard the water and dry up the
interior of the refrigerator ,The refrigerator can then be restarted
by turning its thermostat to the desired setting .
5.
Frost in fridge room can defrost automatically and the water can
flow to the water collection pan which is over the compressor.
The condensate water will evaporate by the heat of compressor.
4.
When the ambient temperature is less than 10 C, turn on the
compensate switch in order to avoid the compressobeing in off
for long time. When the ambient temperature is over 10 C, please
turn off the compensate switch teave energy.
This is an optional function only for some models.
6.
6

5. CLEANING AND MAINTENANCE
The refrigerator should be cleaned and maintained once a month.
When performing maintenance, make absolutely sure that the
power plug is first disconnected from the power outlet.
Wipe the inner and outer surface of the refrigerator and its
accessories with wet cloth. If they are too dirty, scrub them with
neutral detergent, and then clean them with water and dry them
with clean cloth. After this, a small quantify of glass wax is
recommended to polish the refrigerator surface with a flannelette.
For cleaning, don't use hot water, diluent, petrol, alcohol,
kerosene, washing powder, cleanser, aikailinous detergent, acid,
Chemical cloth, etc. So as not to damage the lacquer coat and
plastics. It is forbidden than the refrigerator is directly sprayed with
water. Otherwise, it would cause rusty or weaken the insulation.
Be careful to upkeep the sealing rubber bars of the doors. They
should always be cleaned.
If the plastic parts in refrigerator remain contaminated for a long
time by oil (animal or vegetable), they will be easy aged and
possibly cracked. The drain pan gets dirty very easily if it is not
cleaned regularly, bad odours will be produced, get into the
habit of cleaning this pan regularly.
7