SignWarehouse PrismJET VJ-54 Setup guide

800-899-5655
www.signwarehouse.com •SignWarehouse, Inc. • 2614 Texoma Drive, Denison, TX 75020
•Toll Free Phone: [phone] •Local Phone: [phone] •Fax: [phone]
REV 01/17/2019
PrismJET VJ-54 Take Up System Guide Set Up
2) Add mounts to alinged brackets and secure with
4 small screws with washers. The long screws will be
used in other steps.
4) Instert one steel bar through le and right reels.
They are labeled with white sckers.
1) Align L-Brackets onto front legs of stand
3) Add larger screws on inside and outside of legs. Tighten
using hex wrench. If you want more space for the motors to
move. Take noce of the placement of the screws.
NO. NO.Name Name
2
3
Leg Brackets (x2)
Rod End Caps (x4)
1 5
6
8
Le and Right Motor L-Brackets (x4)
Hex Screws (x20)
Hex Wrench4
7
Plug Adapter
Motor Fix Knobs (x2)
1 2 3
4
5
6 7
8
*Not pictured* Rods (x2)
Comes in two boxes, all the parts and accessories in one and the rods in another.
12 Long Screws
8 Short Screws

800-899-5655
www.signwarehouse.com •SignWarehouse, Inc. • 2614 Texoma Drive, Denison, TX 75020
•Toll Free Phone: [phone] •Local Phone: [phone] •Fax: [phone]
5) Space to insert reels' plasc anges into opposing ends of
54" cardboard core. Save the cores from old rolls of media.
7) Adjust the steel bar for the center of the brackets and
secure by the motor x knobs.
9) Add screws to outer mount brackets to secure both steel
bars.
6) Slide assembled system through front collar of le mount
and then right/
8) Add second steel bar through mount and onto reel's back
half collar.
10) Add caps to end steel bars.