SIIG CE-MT1X12-S1 User manual

1
Full Motion Easy-Adjust
Universal Tablet Mount
Installation Guide
04-1030B
Introduction
TheFull Motion Easy-Adjust Universal Tablet Mount
enables you to mount smartphones or tablets
onto desktops or other smooth surfaces easily
and quickly.
Specifications
• Product weight: 1.10 lbs
• Device holder adjustment: 4.7" to 8.2"
• Loading weight capacity: <= 2.20 lbs
• C-clamp adjustment: 0.27" to 1.49"
• Height (from base to center of holder): 18"
LOT Number Sticker
Forfutureproductreturn orexchange, thisLOT number
is required. Please keep it for your reference.
LOT Number Part Number

2
Key Features and Benefits
• Full motion articulating tablet desktop
mount frees your hand from holding the
devices and maximizing the conveniences
while reading or watching videos
• Retractable holding bracket expands up to
8.2" with side openings allows easy device
installing/removing and cable connection
• Fits most 7" to 12" tablets, including iPad,
iPad Mini, iPad Air and Samsung Tab series
• Supports multi- direction 360°rotate,swivel,
and tilt for the best ergonomic viewing
position
• Articulating aluminum arm allows up to
13" height adjustment
• Includes both C-clamp and heavy-duty
suction cup for easy and secure installation
onto most surfaces without drilling
Conveniently located C-clamp knob
accessible from the top for easy setup
• Protective pads fully integrated into device
holder and clamp protects device from
scratching, falling or slipping

3
Figure 1: Full Motion Easy-Adjust Universal Tablet Mount
Package Contents
•Full Motion Easy-Adjust Universal Tablet
Mount - Black/White
• C-clamp
• Suction cup
• Wire clip (x4)
• 3-in-1 allen key
• Installation Guide
Layout
6.89"
9.92"
4.53" 3.94"
11.61"
4.72"~8.27"

4
Installation Instructions
C-clamp Mount
1. Position the C-clamp to the desktop and
adjust it according to the thickness of the
desktop by turning the clamp screw.
2. Tighten the C-clamp to the desktop by
turning the clamp screw clockwise.
Figure 2
clamp screw

5
Suction Cup Mount
1. Disconnect the wall stand from the C-clamp
by releasing the bolt.
2. Connect the wall stand into the hole of
suction cup.
3. Use the included bolt and fasten it.
4. Place the wall stand on a smooth flat surface
and press the semi-circle locker to secure
the mount.
Figure 3

6
Figure 4
Adjustment & Cable Management
Rotation
Adjust to the desired position using the included
3-in-1 allen key.
3mm
230o
180o
300o
360o
360o
180o
3mm
2.5mm
2.5mm
2.5mm
3-in-1 allen key
4mm

7
Device Holder
Adjust the width to fit your tablet or smartphone.
Figure 5
Cable Management
Arrange the cables into the cable covers and
down the tube using the included wire clips.
Figure 6

8
Maintenance
After a period of time, the suction cup will lose
holding strength due to the accumulation of dirt
and dust. It is recommended to remove and clean
the suction cup with cold water every 2 months
to maintain proper holding strength.
Figure 7
12
3

9
Notice
• DO NOT assemble/disassemble the Tablet
Mount by yourself
• DO NOT wash with hot water
• DO NOT place the suction cup on a rough
surface or one prone to vibration or
movement, as these conditions may cause
the mount to fall unexpectedly
• Keep out of reach of children

10
Blank Page