SILENT KNIGHT 5865-3 Technical manual

5865-3 and 5865-4 LED Annunciator
Product Installation Document
PN 151088:D 03/12/2018 ECN 18-0103
1.1 Description
The 5865-3 and 5865-4 are LEDAnnunciators that provide you with 30 programmable LED’s (15 red, 15 yellow). 5865 connects to the panel via
the SBUS.
1.1.1 Specifications
1.2 Mounting the 5865-3
The 5865-3 mounts into a standard 3-gang electrical box. Follow these steps to mount the 5865-3:
1. Make sure that the 5865-3 is properly wired to the control panel. See Figure 1.2.
2. Place the 5865-3 into the 3-gang electrical box. See Figure 1.1.
Figure 1.1 : 5865-3 Mounting
3. Place cover plate over the top of the 5865-3 and align the holes. See Figure 1.1.
4. Insert the six cover plate screws into six screw holes on the 3-gang electrical box.
5. Screw the six cover plate screws all the way in until the cover plate fits firmly against the 5865-3 and the electrical box. Do Not over tighten.
1.3 Mounting the 5865-4
The 5865-4 mounts into a standard 4-gang electrical box. Use the same procedure as used for mounting the 5865-3.
Max. Line Resistance 50
Max. Alarm Current 145mA
Standby Current 35mA
Max. Voltage 24VDC
Operating Temperature 0° to 49° C
(32° to 120° F)
Indoor Use Only
NOTE: The 5865-4 uses 8 cover plate screws.
cover plate
5865-3
3-gang
electrical box
cover
plate
screw

2 5865-3 / 5865-4 Installation Document - P/N 151088:D 03/12/2018
1.4 Wiring the 5865-3 or 5865-4
Terminate the wiring as shown in Figure 1.2. Also refer to Table 1.1 for wire connections.
Figure 1.2 5865-3 or 5864-4 Connection to the FACP
1.5 Setting the Device Address
Refer to Figure 1.3 to set the DIP switches to the desired address.
Figure 1.3 Setting the Device Address
NOTE: Installation and wiring of these devices must be done in accordance with NFPA 72 and local ordinances.
5865-3 & 5865-4
Terminals FACP Terminals
Label
BB
AA
S+ +
S- -
Table 1.1 Wire Connections
supervised
power limited