Silvercrest SKA 4.2 A1 User manual

USB CAR ADAPTOR SKA 4.2 A1
USB CAR ADAPTOR
Operating instructions
IAN 309596
KFZ-USB-LADEADAPTER
Bedienungsanleitung

GB/IE/NI Operating instructions Page 1
DE/AT/CH Bedienungsanleitung Seite 19
Before reading, unfold the page containing
the illustrations and familiarise yourself with all
functions of the device.
Klappen Sie vor dem Lesen die Seite mit den
Abbildungen aus und machen Sie sich anschlie-
ßend mit allen Funktionen des Gerätes vertraut.

SKA 4.2 A1 GB│IE│NI │1 ■
Contents
Introduction..................2
Information about these
operating instructions ................2
Notes on trademarks ................2
Intended use.......................3
Warnings and symbols used ..........3
Safety ......................5
Before use ...................7
Check package contents .............7
Description of components .....7
Use .........................8
Troubleshooting ..............9
Cleaning. . . . . . . . . . . . . . . . . . . . 10
Replacing the fuse ...........11
Storage when not in use ......12
Disposal....................12
Disposal of the device ..............12
Disposal of the packaging ...........13
Appendix...................14
Technical data ....................14
Kompernass Handels GmbH warranty .15
Service ..........................18
Importer .........................18

SKA 4.2 A1
■ 2
│GB│IE│NI
Introduction
Information about these
operating instructions
Congratulations on the purchase of your
new device.
You have selected a high-quality product.
The operating instructions are part of this
product. They contain important information
on safety, usage and disposal. Before using
the product, please familiarise yourself with
all operating and safety instructions. Use
the product only as described and for the
range of applications specified. Keep these
operating instructions as a reference and
store them near the product. Please pass
on all documentation incl. these operating
instructions to any future owner(s) if you sell
this product or give it away.
Notes on trademarks
USB is a registered trademark of USB
Implementers Forum, Inc.
The SilverCrest trademark and the retail
name are the property of their respective
owner.
All other names and products may be
trademarks or registered trademarks of
their respective owner.

SKA 4.2 A1 GB│IE│NI │3 ■
Intended use
This device is intended for charging and
operating mobile devices with a USB
sockets. It is only intended for vehicles with a
cigarette lighter whose negative pole is con-
nected to earth. Any other use or use going
beyond that described in these instructions
is considered to be improper use and can
lead to damage or injuries. The device is
only for private use and is not intended for
use in commercial or industrial environments.
No claims of any kind will be accepted for
damage arising as a result of incorrect use.
The operator bears sole liability.
Warnings and symbols used
The following warnings are used in these
operating instructions:
DANGER
A warning at this hazard level
indicates a potentially hazardous
situation.
Failure to avoid this hazardous situation
could result in serious injuries or even
death.
► Follow the instructions in this warning
notice to avoid the risk of serious
injuries or death.

SKA 4.2 A1
■ 4
│GB│IE│NI
CAUTION
A warning notice at this hazard
level indicates a risk of property
damage.
Failure to avoid this situation could result
in property damage.
► Follow the instructions in this warning
to prevent property damage.
NOTICE
► A note provides additional information
which will assist you in using the device.
The integrated Smart Fast
Charge technology enables
reduced charging times for
compatible devices. Compatible connected
devices automatically receive a signal to
draw the maximum available charging
current.
The E marking is a test mark for the
labelling of components requiring
approval in motor vehicles and states that
the necessary tests have been carried out
and that an ECE component approval has
been issued.

SKA 4.2 A1 GB│IE│NI │5 ■
Safety
To ensure safe operation of the device,
follow the safety guidelines set out below:
■ This device is not intended for use by
people (including children) with reduced
physical, sensory or mental abilities or
for those without experience and/or
knowledge, unless they are supervised
by a person responsible for their safety
or they have been instructed in its use.
■ Children must be supervised to ensure
that they do not play with the device.
■ Check the device for visible external
damage before use. Do not operate
a device that has been damaged or
dropped.
■ To avoid possible risks, arrange for
damaged cables or connectors to be
exchanged by an authorised specialist
or the Customer Service Department.
■ Never open the device, and never carry
out any repairs yourself.
■ Do not allow any liquids or moisture to
get into the device.

SKA 4.2 A1
■ 6
│GB│IE│NI
■ Never subject the device to extreme heat
or humidity. This particularly applies to
storage in a car. If the car is stationary
for extended periods and in hot weather
with direct sunlight, high temperatures
occur in the car interior and the glove
compartment. Remove electrical and
electronic devices from the vehicle.
■ Please also observe the operating instruc-
tions for your mobile device.
■ If you notice a burning smell or smoke
coming from your device, disconnect it
from the cigarette lighter immediately.
■DANGER Under no circumstances
should the smoke be inhaled as this could
be harmful to your health.
■ All of the applicable laws in your loca-
tion must be observed. Your hands must
always be free to operate the vehicle
safely when you are driving. Traffic safety
must always take priority whilst driving.
Use this cradle only if no hazard is likely
to occur in any driving situation. Repairs
to the device during the warranty period
may only be carried out by a customer
service department authorised by the
manufacturer. Otherwise, no warranty
claims will be accepted for any subse-
quent damage.

SKA 4.2 A1 GB│IE│NI │7 ■
Before use
Check package contents
♦ Remove all parts and the operating
instructions from the box.
♦ Remove all packaging material.
DANGER
► Do not allow children to play with
packaging materials. There is a risk
of suffocation.
The following components are included in
delivery:
▯ Car USB charging adapter
▯ These operating instructions
NOTICE
► Check the package for completeness
and signs of visible damage.
► If the delivery is incomplete or damage
has occurred as a result of defective
packaging or during transport, contact
the service hotline (see section Service).
Description of components
1Pull ring
2USB sockets (type A)

SKA 4.2 A1
■ 8
│GB│IE│NI
Use
CAUTION
► The maximum power output of the car
USB charging adapter is 4.2 A.
The maximum power output of each
USB socket 2 is 2.4 A. The maximum
power output of the two USB sockets
2 is 4.2 A. The power output is
distributed depending on the devices
connected to the USB sockets 2.
♦ Connect the car USB charging adapter
to your vehicle's on-board power supply
(cigarette lighter). The white LED in
the housing indicates that the car USB
charging adapter is ready for use.
Depending on the vehicle type, it is pos-
sible that the ignition has to be switched
on first.
♦ Connect the charging cable to one of the
USB sockets 2of the car USB charging
adapter and the USB socket of your
mobile terminal device. Charging starts
immediately and is indicated on the
display of the mobile device.
♦ After charging, remove the car USB
charging adapter from the cigarette lighter
by pulling on the pull ring 1. Disconnect
the charging cable from the USB socket 2
on the car USB charging adapter.

SKA 4.2 A1 GB│IE│NI │9 ■
CAUTION
► In vehicles in which the cigarette lighter
also works with the ignition switched
off, the mobile device must be discon-
nected from the cigarette lighter after
use. Otherwise, the vehicle battery
may be discharged over a long period
of time, since the device may also use
power when it is idle.
Troubleshooting
A connected device will not charge
(the white LED in the housing does not
light up).
♦ No connection to the car's cigarette
lighter socket. Check the connection.
♦ Depending on the vehicle type, it is pos-
sible that the ignition has to be switched
on first.
♦ Check whether the fuse of the car
USB charging adapter is defective and
replace this if necessary (see section
Replacing the fuse).
The white LED in the device housing
goes out when a device is connected.
♦ Check whether the fuse of the car
USB charging adapter is defective and
replace this if necessary (see section
Replacing the fuse).

SKA 4.2 A1
■ 10
│GB│IE│NI
NOTICE
► If you cannot solve the problem with
the above-mentioned solutions, please
contact the Service Hotline (see section
Service) .
Cleaning
CAUTION
► Always disconnect the device from the
cigarette lighter during cleaning and
when it is not being used.
CAUTION
Damage to the device!
► To avoid irreparable damage to the
device, ensure that no moisture enters it
during cleaning.
♦ If necessary, clean the device with a soft,
dry cloth.
♦ Use a lightly moistened cloth and a
mild detergent to remove stubborn dirt
residues.

SKA 4.2 A1 GB│IE│NI │11 ■
Replacing the fuse
There is a fuse in the car USB charging
adapter to protect the vehicle’s on-board
power supply. If the device stops working,
check the fuse and replace it if necessary.
♦ Open the car USB charging adapter
by turning the screw insert (C) carefully
anticlockwise and removing it.
♦ Remove the plug tip (B) from the fuse (A)
and pull out the fuse (A).
♦ Now insert a new fuse (A) of type
F4L/250V into the car USB charging
adapter. Place the plug tip (B) on the
slightly protruding end of the fuse (A)
and screw the previously removed screw
insert (C) back in.
DANGER
► Only ever use the same type of fuse.
Otherwise there is a risk of fire.
NOTE
If the device still does not work or if the
new fuse burns out immediately, the
device is defective. In this case, please
contact the Service Hotline (see section
Service).

SKA 4.2 A1
■ 12
│GB│IE│NI
Storage when not in use
CAUTION
► The temperatures inside the vehicle can
reach extreme values in summer and
winter. To prevent heat damage, do
not leave the device in the vehicle.
♦ Store the device somewhere clean, dry,
free of dust and out of direct sunlight.
Disposal
Disposal of the device
The symbol shown on the left of a
crossed-out dustbin means that this
device is subject to Directive
2012/19/EU. This directive states
that this device may not be disposed of in
normal household waste at the end of its
useful life, but must be taken to a specially
set-up collection point, recycling depot or
disposal company.

SKA 4.2 A1 GB│IE│NI │13 ■
This disposal is free of charge for
the user. Protect the environment
and dispose of this device properly.
Your local community or municipal
authorities can provide informa-
tion on how to dispose of the
worn-out product.
Disposal of the packaging
Dispose of the packaging in an
environmentally friendly manner.
Note the labelling on the
packaging and separate the
packaging material components for disposal
if necessary. The packaging material is
labelled with abbreviations (a) and numbers
(b) which have the following meanings:
1–7: plastics,
20–22: paper and cardboard,
80–98: composites.

SKA 4.2 A1
■ 14
│GB│IE│NI
Appendix
Technical data
Input voltage/
current
12/24 V (DC),
max. 2.6 A
Output voltage/
current for each
USB socket 2
5 V (DC),
max. 2.4 A
Total output voltage/
current
5 V (DC),
max. 4.2 A
USB sockets 2USB type A
Protection class III/
(Protection through
extra-low voltage)

SKA 4.2 A1 GB│IE│NI │15 ■
Kompernass Handels GmbH
warranty
Dear Customer,
This appliance has a 3-year warranty valid
from the date of purchase. If this product
has any faults, you, the buyer, have certain
statutory rights. Your statutory rights are not
restricted in any way by the warranty de-
scribed below.
Warranty conditions
The validity period of the warranty starts
from the date of purchase. Please keep your
original receipt in a safe place. This docu-
ment will be required as proof of purchase.
If any material or production fault occurs
within three years of the date of purchase
of the product, we will either repair or re-
place the product for you at our discretion.
This warranty service is dependent on you
presenting the defective appliance and
the proof of purchase (receipt) and a short
written description of the fault and its time of
occurrence.
If the defect is covered by the warranty, your
product will either be repaired or replaced
by us. The repair or replacement of a prod-
uct does not signify the beginning of a new
warranty period.

SKA 4.2 A1
■ 16
│GB│IE│NI
Warranty period and statutory
claims for defects
The warranty period is not prolonged by
repairs effected under the warranty. This
also applies to replaced and repaired com-
ponents. Any damage and defects present
at the time of purchase must be reported
immediately after unpacking. Repairs carried
out after expiry of the warranty period shall
be subject to a fee.
Scope of the warranty
This appliance has been manufactured in
accordance with strict quality guidelines and
inspected meticulously prior to delivery.
The warranty covers material faults or pro-
duction faults. The warranty does not extend
to product parts subject to normal wear and
tear or fragile parts such as switches, batter-
ies, baking moulds or parts made of glass.
The warranty does not apply if the product
has been damaged, improperly used or
improperly maintained. The directions in the
operating instructions for the product regard-
ing proper use of the product are to be
strictly followed. Uses and actions that are
discouraged in the operating instructions or
which are warned against must be avoided.

SKA 4.2 A1 GB│IE│NI │17 ■
This product is intended solely for private
use and not for commercial purposes. The
warranty shall be deemed void in cases of
misuse or improper handling, use of force
and modifications/repairs which have not
been carried out by one of our authorised
Service centres.
Warranty claim procedure
To ensure quick processing of your case,
please observe the following instructions:
■ Please have the till receipt and the item
number (e.g. IAN 12345) available as
proof of purchase.
■ You will find the item number on the type
plate, an engraving on the front page of
the instructions (bottom left), or as a stick-
er on the rear or bottom of the appliance.
■ If functional or other defects occur,
please contact the service department
listed either by telephone or by
e-mail.
■ You can return a defective product to us
free of charge to the service address that
will be provided to you. Ensure that you
enclose the proof of purchase (till receipt)
and information about what the defect is
and when it occurred.