
GB│IE│NI │ 7 ■
SSC6 320 A1
Preparations
Before first use
Before the first use, you should thoroughly clean all parts to remove any produc-
tion residues. Proceed as described below:
ƇClean all parts as described in the section "Cleaning".
ƇPlace the appliance base 3on a level, stable and heat-resistant surface
close to an easily accessible power outlet.
ƇInsert the ceramic pot 2into the appliance base 3.
ƇMake sure that the dial is set to “ ” and plug the power plug into a wall
outlet.
ƇFill the ceramic pot 2 with 0.5 litres of water.
ƇPlace the glass lid 1 on the ceramic pot 2.
ƇSet the dial 5 to " ". The control lamp 4 lights up, the appliance starts to
heat up.
NOTE
► During initial use, a small amount of smoke and a slight odour may occur
due to production residue. This is normal and dissipates after a short time.
Ensure sufficient ventilation, for example, by opening a window.
ƇSwitch off the appliance after 60 minutes by turning the dial 5back to " ".
ƇRemove the plug from the mains power socket.
ƇAllow the appliance to cool down sufficiently, pour the water away and clean
all parts again as described in the section "Cleaning".
Setting up the appliance
NOTE
► If you are using the appliance for the first time, proceed as described in the
section "Before first use".
ƇPlace the appliance base 3on a level, stable and heat-resistant surface
close to an easily accessible power outlet.
ƇInsert the ceramic pot 2into the appliance base 3.
ƇMake sure that the dial is set to " " and plug the power plug into a wall
outlet.
The appliance is now ready for use.
IB_340046_SSC6320A1_LB6.indb 7 11.02.2020 10:18:27