SILYNX KEY FOB PTT User manual

1.866.325.1731 | [email protected] | [email protected]
www.silynxcom.com | 9901 Belward Campus Drive Suite 150 Rockville, MD 20850
*Information subject to change without notice
SEP 2015
KEY FOB PTT
User Guide - Pairing
Key FOB PTT
PTT A PTT B
PTT B
CLARUS
1. Power on CLARUS (Press and hold (+) for 5 sec).
2. Press PTT B quickly 5 times.
3. A slow beeping tone heard in the headset indicates the
CLARUS is in pairing mode. (As the pairing time runs out the
beeping will speed up)
4. Position the Key Fob PTT close to the CLARUS.
5. Press all three buttons on the Key Fob PTT (“lock”,
“unlock”, and “panic”) at the same time.
6. A short rapid beeping confirmation tone will indicate a
instructions
Note: Pairing must occur within 60 sec after powering on the
CLARUS

1.866.325.1731 | [email protected] | [email protected]
www.silynxcom.com | 9901 Belward Campus Drive Suite 150 Rockville, MD 20850
*Information subject to change without notice
SEP 2015
SMART PHONE CABLE
User Guide
PTT A
PTT B
1. Hold PTT A to transmit
2. Press PTT B to Answer / End calls
Connected Directly to the CLARUS
1. Hold PTT A to transmit
2. Tap PTT A to Answer / End calls
Connected to Dual Comms Splitter (Primary Lead)
1. Hold PTT B to transmit
2. Tap PTT B to Answer / End calls
Connected to Dual Comms Splitter (Secondary Lead)
PTT B
PTT A Primary Lead
PTT B
PTT A
Secondary Lead