Extron electronics CTL120-3 User manual

68-940-01, Rev.A
12 04
CTL120-3 Remote Control
This IR remote (Extron part #70-371-01) is to be used with the
SWP123 Presentation Switcher.
To switch to a new input group and input device using the CTL120-3
remote control:
1. Press and release the SWP SWITCHER button.
2. Press and release the numeric button (1, 2, 3, or 4) on the remote control
unit that corresponds to the desired input group (VGA, S-video, Video,
or Audio, respectively).
3. Press and release the numeric button (1, 2, 3, or 4) on the remote control
unit that corresponds to the desired input device within the selected
group that you want to connect to the output.
4. Press and release the ENT (ENTER) button to execute the switch.
Switching input devices
Extron Electronics, USA
1230 South Lewis Street
Anaheim, CA 92805
USA
714.491.1500
Fax [phone]
Extron Electronics, Europe
Beeldschermweg 6C
3821 AH Amersfoort
The Netherlands
+31.33.453.4040
Fax [phone]
Extron Electronics, Asia
135 Joo Seng Road, #04-01
PM Industrial Building
Singapore 368363
+65.6383.4400
Fax [phone]
Extron Electronics, Japan
Kyodo Building
16 Ichibancho
Chiyoda-ku, Tokyo 102-0082 Japan
+81.3.3511.7655
Fax [phone]
www.extron.com

Resetting the component code
If, for any reason, the component device code is erased, reset the code with
the following instructions:
1. Press and release the S(set) button.
2. Press and release the SWP SWITCHER button.
3. Enter the component’s three digit code number using the numeric
buttons: 001.
4. Press and release the ENT (ENTER) button to store the code.
Other CTL120-3 functions
The following button functions are also included for the SWP123.*
•MIC — + (increase) and –(decrease) microphone volume adjustment
•VOL — +(increase) and –(decrease) Master Audio ouput adjustment
•Talk Over — activate the microphone mixer for microphone talk over
•Mute — mute/unmute Master Audio output
•Blank — suppress the video/audio input to the selected A/V group
*The remaining buttons do not apply to the SWP123 operation.