Simax Iron-M1 User manual

Version
Date
Author
Check
Remark
1.0
2020.4.22
Felix
Version Record
•Detailed user manual is stored in the SD card, please copy to your PC before using
the SD card.
•If you have any problems with the Quick Start Guide, please feel free to contact us,
we will reply to you ASAP!
•Email: [e-mail]
•If you are interested in translating our documents into the language you are familiar
with, please contact us and we will pay for this.
•Email: [e-mail]

1.Please follow step by step; otherwise, the quality of installation may be
somewhat affected.
2.Distinguish the type and length of the screws, if using wrongly, some type
may be lack while other type may be surplus.
3.The machine should be placed on a worktable while installing so that the
bottom of the machine could be flat.
4.Aluminum profile should be horizontal and vertical. And the connections
between them should be tight.
5.Pay attention to the direction of each parts, DO NOT REVERSE.
6.Thoroughly check below points after installation:
(1)if the screws fully tightened or not;
(2)if the bottom of the machine is flat or not;
(3)if the orbital motion of X/Y/Z-axis is smooth or not.
(4)if the plug is loose or not.
Attention

Step 1: Power on
The power socket is on the back
of the machine.
Plug in the power cord and turn
on the switch.

Step 2: Insert SD card
Insert the TF card into this location(Please pay
attention to distinguishing front and back.)

Step 3-1: Leveling the bed
when you use the printer first or you not use it
some time,please leveling the bed
you can use the hand
nut to leveling the
bed
It has four hand screw nut at the four
corners of the printer.
Please leveling it in order of 1, 2, 3，4.
12
43

Step 3-2: Leveling the bed
Please place an A4 paper
between the nozzle and
the bed,then turn the
hand screw nut to adjust
the tightening.
When you can pull A4
paper, and it has slight
resistance,this is
perfect,you can leveling
next point.

Step 3-3: Leveling the bed
We made a "leveling.gcode" to assist
in leveling.
You can click “Print”，Then click
"leveling.gcode" to start printing.
When it starts printing, it goes to
the first point,you can leveling it.
leveling.gcode

Step 3-4: Leveling the bed
When you have leveled a point, you can
click "continue", it will go to the next
point, you can level it.
Repeat this step until leveling is
complete.
0
0:0:40
27 0
27 0
0

Step 4-1: Load filament
In order to load the
filament better,please
cut the filament at an
oblique angle

Step 4-2: Load filament
Press here,then insert
the filament in the
direction of the arrow

Step 4-3: Load filament
Click "Utilities", "Filament", "Load Filament" in turn.
Then select the corresponding option according to your
filament

Step 5: Print your model
Similar to what we did in leveling,
you can click Print, and then
click the file you want to print to
start printing.
If you want to know how to
slice,please refer to ＂How to
slice by Cura＂
leveling.gcode

Congratulations
Now I think you already know how to use your 3D printer.
Enjoy it.
If you have any problems with the Quick Start Guide, please feel free to
contact us, we will reply to you ASAP!
Email: [e-mail]