SKEDCO SKED User manual

TO UNROLL SKED®STRETCHER AND LAY FLAT
1, REMOVE SKED®FROM PACK AND
PLACE ON GROUND.
3, BEND THE SKED®OVER YOUR FOREARM
AND BACK ROLL. REPEAT WITH OPPOSITE END
OF STRETCHER. IN COLD WEATHER, IT MAY BE
NECCESSARY TO REVERSE ROLL IT TWICE.
4, SKED®STRETCHER WILL NOW LAY
FLAT.
P.1
2, UNFASTEN RETAINER STRAP. STEP
ON FOOT END OF SKED®AND UNROLL
COMPLETELY TO OPPOSITE END.
*STEEL BUCKLES
*COBRA BUCKLES

ROLLING UP THE SKED®STRETCHER
1. LAY STRETCHER OUT FLAT WITH ALL
CROSS STRAPS CONNECTED.
**STEEL DOUBLE BAR BUCKLES: PLACE
RETAINER STRAP WITH INSIDE OF BUCKLE
FACING UP UNDER FOOT END OF SKED®.
(SEE PHOTO IN STEP 4)
2. STARTING AT THE HEAD END, ROLL
THE SKED®UP AS TIGHT AS POSSIBLE.
CONTINUE TO ROLL THE SKED®USING
KNEE TO KEEP THE ROLLED STRETCHER
SMALL.
3. WHILE HOLDING YOUR KNEE ON
THE ROLLED SKED®, FASTEN THE COBRA
BUCKLES OF THE FOOT END STRAPS TO
HOLD THE SKED®IN A TIGHT ROLL.
4. WHEN USING THE SKED®WITH STEEL
DOUBLE BAR BUCKLES, FASTEN THE PRE-
PLACED RETAINER STRAP TO BUCKLE AND
PLACE SKED®STRETCHER IN BACKPACK.
P.10