SleepPhones Wireless Manual

Instruction Guide for SleepPhones® Wireless
How to Wear your SleepPhones®
3. Once the headband is on, you’ll want to adjust the
speakers so that they are positioned directly over your
ears. This will ensure great sound quality. Please note that
the speakers move inside of the headband, independently
of the headband.
2. Place the headband on your head. Note that the
SleepPhones® logo tag goes at the back of your head.
1. Holding the SleepPhones® in your hands, you’ll notice
the flat speakers - one on each side - inside of the
headband.
 
Pairing your SleepPhones® Wireless
1. Locate the Bluetooth® module in
the hook & loop opening at the back
of the headband. Hold down the
middle (power) button for 5 seconds to
put it into pairing mode. !
(May be helpful to refer to speaker
schematic on next page)
2. Go into your Bluetooth®-enabled
device and make sure Bluetooth® is
turned on. Look for the device,
‘ACOUSTICSHEEP’ and select to pair.
3. You should now be able to
play music through your
SleepPhones® Wireless
headphones. Great for listening
to audio books, nature sounds,
podcasts, etc!
!
1
2
3
1
2
3

Reinserting the Speakers
1. The right speaker will have red
stitching. The left speaker will have
green stitching. The softer gray
(fleece) side should be facing in
towards the ear and the coarse (felt)
side should face away from the ear.
2. Insert the speakers, one at a time,
about four inches from the hook &
loop opening on both sides of the
headband.
3. Then insert the Bluetooth®
module into the headband and close
the hook & loop opening.

Removing the Speakers
1. There is a hook & loop opening at
the back of the headband. Open to
reveal the speaker components inside
the headband.
2. Remove the Bluetooth® module
& then pull very gently on the cord to
remove the speakers, one at a time,
from the headband.
3. Once the speakers are removed,
you can machine-wash the headband.
!
1
2
3
1
2
3
Speakers
Check out the instructional video!