smartair SA600 User manual

Simple, no-nonsense clean air
Air Purifier

(Stuff OurLawyers Made Us Say)
READ AND SAVE THESE INSTRUCTIONS
This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning use of the appliance by a
person responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance.
WARNING – TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO
PERSONS, OBSERVE THE FOLLOWING:
• Read all instructions before using appliance.
• Use this unit only in the manner intended by the manufacturer. If you have questions,
contact the manufacturer.
• To protect against electrical hazards, DO NOT immerse it in the water or other
liquids. Do not use near wet area.
• Always unplug the air purifier before moving it. Change filters or clean the air purifier
when it is not in use. Be sure to pull by the plug and not the cord.
• NEVER drop or insert any object into any openings of this unit.
• DO NOT run cord under carpeting. Do not cover cord with throw rugs, runners, or
similar coverings. Do not route cord under furniture or appliances. Arrange cord away
from traffic area and where it will not be tripped over.
• DO NOT operate any appliance with a damaged cord or plug. Discard fan or return
to an authorized service facility for examination and/or repair
• Use appliance only for intended household use as described in this manual. Any
other use not recommended by the manufacturer may cause fie, electric shock or injury
to persons.
• DO NOT place anything on top of unit.
• DO NOT attempt to repair or adjust any electrical or mechanical functions on this
unit. Doing so will void your warranty. The inside of the unit contains no user
serviceable parts. All servicing should be performed by qualified personnel only.
This marking indicates that this product should not be disposed with other household
wastes throughout the EU. To prevent possible harm to the environment or human
health from uncontrolled waste disposal, recycle it responsibly to promote the
sustainable reuse of material resources. To return your used device, please use the
return and collection systems or contact the retailer where the product was purchased.
They can take this product for environmental safe recycling.
This appliance can be used by children aged from 8 years and above under supervision.
This appliance can be used by persons with reduced physical, sensory or mental
capabilities or lack of experience and knowledge if they have been given supervision or
instruction concerning use of the appliance in a safe way and understand the hazards
involved. Children shall not play with the appliance.
Cleaning and user maintenance shall not be made by children without supervision.
Correct Disposal of this product

Refined & Reliable Clean Air
When designingthe SA600, we wantedto make an
air purifier that can reliably keep large spaces like
classrooms, offices and living rooms safe and clean.
The SA600doubles up on filters to providemore
clean air at lower noise levels. Refinedthrough Smart
Air’s almost 10 yearsof research and experience, the
SA600 isour most cost-effective purifier yet.
About Smart Air
Smart Air is a social enterprise and certified
B-corp dedicatedto distributing cost-effective
air purifiers and providing open-source data and
science to combat the harms of air pollution.
Features
• Dual-inlet design for more clean air
• Double the filters, improving effectiveness while lowering cost
• Low noise design
• ‘Do Not Disturb’ mode for silent, distraction-free operation
• Child lock to keep your SA600 operating and prevents any purifier settings from
being changed
• Pre-filter, HEPA and carbon filters for all-round protection

Getting To Know Your SA600
Front Cover HEPA Filter
Activated Carbon FilterPre-filter
Purifier Body
Front View
Control Panel View
Power On/Off Button
‘Child Lock’ Button
Press this button 3 seconds to enter this mode.
To exit ‘Child Lock’ mode, press 3 seconds again.
Find out more about this mode (page 5).
Fan Speed Button
Press this button to adjust
fan speed: Low, Medium, High.
Filter Reset Indicator
This will flash when it is time to replace the
filter. Replace the filter according to the
instructions (page 6).

Turning On Your SA600
Follow these steps to start breathing cool, clean air with your SA600:
Step3: Press the Power On/Off button on the control panel to turn
on.
Step 1: Remove SA600 from the box.
Pull out the front cover of your SA600.
Removethebags from the filters.
Step2: Place your SA600 on a firm, level and flat floor & plug the
supplied power cord into an AC outlet.
The indicator lights on the buttons will light uponce connected to power the first time.
The SA600 defaults to a fan speed of ‘Low’.
1. For proper air flow, ensure the inlets (front
and back) are located at least 30cm (1 ft) from
any wall or item of furniture.
2. Air entersthe air purifier from the front
and back, make sure neither side is
blocked.

‘Child Lock’ Mode
Cleaning & Maintaining Your SA600
The SA600 should be cleaned at least once every month using a dry
and clean cloth. Depending on the environmental conditions, more
frequent cleaning may be required.
'Do Not Disturb' Mode
To save energy and reduce the impact of the SA600's lights on your
environment, the SA600 includes a built-in, automatic 'Do Not Disturb'
mode.
If the SA600's buttons are not touched for 3 minutes, all control lights
will turn off. The next time you touch any button on the SA600, the
lights will turn back on, showing you the previous purifier state. This
mode will not work when your filter needs replacing.
The ‘Child Lock’ mode locks the current purifier state and prevents any
purifier settings from being changed.
To enter ‘Child Lock’ mode, simply hold the ‘Child Lock’ button for 3
seconds. The ‘Child Lock’ light will then illuminate. In this mode,
pressing any button will not alter the purifier’s state. Pressing a button
will cause the ‘Child Lock’ light to flash continuously.
To exit ‘Child Lock’ mode, hold the button for 3 seconds and the light
will stop flashing.
Product No.: SA600
Dimensions: 350mm x 232mm x 510 mm
Recommended Coverage Area: ≤55㎡Power: 60W
Voltage: 100-240V~ / 50-60Hz
Noise (high): 53dB
Material: ABSPlastic
Net Weight: 6.9kg
MADE IN CHINA
Product Information
SA600 + H13HEPA + Carbon
CADR: 470m³/hr
Airflow: 480m³/hr
SA600 + H13HEPA
CADR: 500m³/hr
Airflow: 505m³/hr

Replacing The HEPA Filter
1. The filter reset indicator will flash
continuously when your filter needs
replacing:
2. Pull out the front cover then lift out the
Pre-filter, HEPA and/or Carbon filter.
5. After inserting the front cover back into your purifier, hold the filter
replacement indicator for 4s. This resets the filter replacement indicator.
Note: the filter indicator light will illuminate after your fan purifier
hasbeen running for approximately 1045 hours.
For more information on how this number varies based on your
usage, visit: https://smartairfilters.com/SA600-replacement
3. Remove your new HEPA filter from
its bag.
4. Insert your new HEPA/Carbon filter.
Ensure the arrow on the filter is in the
correct direction outwards.
The filter replacement indicator will
stop flashing once it has been
reset.
Hold for 4s

Read this manual in your language:
scan the QR code!
要更多语言吗？扫二维码！
QR кодыг уншуулсанаарта ашиглах
зааврыг өөрийнхэлээрунших боломжтой!
smartairfilters.com