Smeg SE995XT-5 User manual

33
Table of Contents
INSTRUCTIONS FOR THE USER: these provide recommendations for
use, a description of the controls and the correct procedures for cleaning
and maintaining the appliance
INSTRUCTIONS FOR THE INSTALLER: these are intended for the
qualified engineer who is to install, commission and test the appliance
1. PRECAUTIONS FOR USE................................................ 34
2. DISPOSAL INSTRUCTIONS -
OUR ENVIRONMENT POLICY ......................................... 35
3. SAFETY PRECAUTIONS.................................................. 36
4. GET TO KNOW YOUR OVEN .......................................... 37
5. BEFORE INSTALLATION ................................................. 38
6. DESCRIPTION OF FRONT PANEL CONTROLS............. 39
7. USING THE OVEN............................................................ 41
8. USING THE PIZZA FUNCTION ........................................ 42
9. USING THE TOAST FUNCTION ...................................... 43
10. ELECTRONIC PROGRAMMER........................................ 45
11. ACCESSORIES AVAILABLE ............................................ 48
12. COOKING TABLES........................................................... 50
13. CLEANING AND MAINTENANCE .................................... 53
14. EXTRAORDINARY MAINTENANCE ................................ 58
15. INSTALLING THE APPLIANCE ........................................ 61

34
Precautions for Use
1. PRECAUTIONS FOR USE
THIS MANUAL IS AN INTEGRAL PART OF THE APPLIANCE. TAKE GOOD CARE
OF IT AND KEEP IT TO HAND THROUGHOUT THE OVEN'S LIFE CYCLE.
WE URGE YOU TO READ THIS MANUAL AND ALL THE INFORMATION IT
CONTAINS CAREFULLY BEFORE USING THE APPLIANCE. INSTALLATION
MUST BE CARRIED OUT BY QUALIFIED STAFF IN COMPLIANCE WITH THE
RELEVANT REGULATIONS. THIS APPLIANCE IS INTENDED FOR HOUSEHOLD
USE AND COMPLIES WITH THE EEC DIRECTIVES CURRENTLY IN FORCE.
THE APPLIANCE IS BUILT TO PROVIDE THE FOLLOWING FUNCTION:
COOKING AND HEATING FOODS; ALL OTHER USES ARE TO BE
CONSIDERED IMPROPER.
THE MANUFACTURER DECLINES ALL LIABILITY FOR USES OTHER THAN
THOSE STATED ABOVE.
NEVER USE THIS APPLIANCE FOR HEATING ROOMS.
NEVER LEAVE PACKAGING RESIDUES UNATTENDED IN THE HOME.
SEPARATE THE VARIOUS PACKAGING MATERIALS BY TYPE AND CONSIGN
THEM TO THE NEAREST SEPARATE DISPOSAL CENTRE.
THIS APPLIANCE IS TAGGED UNDER EUROPEAN DIRECTIVE 2002/96/EC ON
WASTE ELECTRICAL AND ELECTRONIC EQUIPMENT (WEEE).
THIS DIRECTIVE CONTAINS THE REGULATIONS GOVERNING THE
COLLECTION AND RECYCLING OF DECOMMISSIONED APPLIANCES
THROUGHOUT THE EUROPEAN UNION.
NEVER OBSTRUCT THE OPENINGS AND SLITS PROVIDED FOR
VENTILATION AND HEAT DISPERSAL.
THE NAMEPLATE WITH THE TECHNICAL DATA, SERIAL NUMBER AND MARK
IS IN A VISIBLE POSITION ON THE OVEN DOOR FRAME.
THE NAMEPLATE MUST NEVER BE REMOVED.
NEVER USE METAL SCOURING PADS OR SHARP SCRAPERS;
THEY WILL DAMAGE SURFACES.
USE ORDINARY NON-ABRASIVE PRODUCTS WITH THE AID OF
WOODEN OR PLASTIC UTENSILS IF NECESSARY. RINSE
THOROUGHLY AND DRY WITH A SOFT CLOTH OR CHAMOIS
LEATHER.
DO NOT ALLOW SPILLS OF FOODS WITH HIGH SUGAR CONTENT
(E.G. JAM) TO DRY INSIDE THE OVEN. IF THEY DRY FOR TOO
LONG, THEY MIGHT DAMAGE THE ENAMEL COATING OF THE
INSIDE OF THE OVEN.

35
Disposal instructions
2. DISPOSAL INSTRUCTIONS -
OUR ENVIRONMENT POLICY
Our products are only packaged using non-pollutant, environment-friendly,
recyclable materials. We urge you to cooperate by disposing of the
packaging properly. Contact your local dealer or the competent local
organisations for the addresses of collection, recycling and disposal
facilities.
Never leave all or part of the packaging lying around. Packaging parts, and
especially plastic bags, may represent a suffocation hazard for children.
Your old appliance must also be disposed of properly.
Important: deliver the appliance to your local organisation authorised to
collect scrapped appliances. Proper disposal allows the intelligent
recovery of valuable materials.
Before scrapping your appliance it is important to remove doors and leave
shelves in position as for use, to ensure that children cannot accidentally
become trapped inside the oven during play. Also, cut the power supply
lead and remove it and the plug.

36
Safety precautions
3. SAFETY PRECAUTIONS
REFER TO THE INSTALLATION INSTRUCTIONS FOR THE SAFETY
REGULATIONS FOR ELECTRIC OR GAS APPLIANCES AND VENTILATION
FUNCTIONS.
IN YOUR INTEREST AND TO ENSURE YOUR SAFETY, BY LAW ALL ELECTRIC
APPLIANCES MUST ONLY BE INSTALLED AND SERVICED BY QUALIFIED
STAFF, IN ACCORDANCE WITH THE RELEVANT REGULATIONS.
OUR APPROVED INSTALLATION ENGINEERS GUARANTEE YOU A JOB WELL
DONE.
GAS OR ELECTRIC APPLIANCES MUST ALWAYS BE DISCONNECTED BY
SUITABLY SKILLED PEOPLE.
THE PLUG TO BE CONNECTED TO THE POWER SUPPLY LEAD AND THE
RELATIVE SOCKET MUST BE OF THE SAME TYPE AND COMPLY WITH THE
RELEVANT REGULATIONS.
THE POWER SUPPLY SOCKET MUST BE ACCESSIBLE EVEN AFTER THE
APPLIANCE HAS BEEN BUILT-IN.
NEVER DISCONNECT THE PLUG BY PULLING ON THE POWER SUPPLY
LEAD.
THE APPLIANCE MUST BE CONNECTED TO EARTH IN COMPLIANCE WITH
ELECTRICAL SYSTEM SAFETY REGULATIONS.
IMMEDIATELY AFTER INSTALLATION, CARRY OUT A QUICK TEST ON THE
APPLIANCE FOLLOWING THE INSTRUCTIONS PROVIDED LATER IN THIS
MANUAL. IF THE APPLIANCE FAILS TO OPERATE, DISCONNECT IT FROM
THE ELECTRICAL MAINS AND CONTACT YOUR NEAREST SERVICE CENTRE.
NEVER ATTEMPT TO REPAIR THE APPLIANCE.
NEVER PLACE INFLAMMABLE OBJECTS IN THE OVEN: IF IT SHOULD
ACCIDENTALLY BE SWITCHED ON, THIS MIGHT CAUSE A FIRE.
THE APPLIANCE BECOMES VERY HOT DURING USE. TAKE CARE NOT TO
TOUCH THE HEATING ELEMENTS INSIDE THE OVEN.
THE USE OF THIS APPLIANCE IS NOT PERMITTED TO PEOPLE (INCLUDING
CHILDREN) OF REDUCED PHYSICAL AND MENTAL ABILITY, OR LACKING IN
EXPERIENCE IN THE USE OF ELECTRICAL APPLIANCES, UNLESS THEY ARE
SUPERVISED OR INSTRUCTED BY ADULTS OR PEOPLE RESPONSIBLE FOR
THEIR SAFETY.
BEFORE THE APPLIANCE IS PUT INTO OPERATION, ALL THE PROTECTIVE
FILMS APPLIED ON THE OUTSIDE MUST BE REMOVED.
The manufacturer declines all responsibility for injury or damage caused by failure to
comply with the above regulations or deriving from tampering with even just one part
of the appliance and the use of non-original spare parts.

37
Instructions for the User
4. GET TO KNOW YOUR OVEN
DESCRIPTION OF OVENS
DESCRIPTION OF TOASTER
OVEN LIGHTS OVEN SHELF
RUNNERS
ROTISSERIE MOTOR
OVEN FAN CONTROL PANEL TOASTER DRAWER
PIZZA PLATE
LIFTING LEVER
PIZZA PLATE CAVITY
HEATING UNITS
TOASTER RACK SLOTS
TOASTER RACKS
CRUMB TRAY
TOASTER PILOT LIGHT
250 140
T
220
100
50
180
A
6
2
3
4
5
2
3
4

38
Instructions for the User
5. BEFORE INSTALLATION
Never leave packaging residues unattended in the home. Separate waste
packaging materials by type and consign them to the nearest separate
disposal centre.
The inside of the appliance should be cleaned to remove all manufacturing
residues. For further information about cleaning, see point "13.
CLEANING AND MAINTENANCE".
When the oven and toaster are used for the first time, they should be
heated (with no food inside) to the maximum temperature for long enough
to burn off any oily residues left by the manufacturing process, which might
contaminate foods with unpleasant smells.
Heat the toaster for the programmer maximum time setting (10 minutes).
After an interruption in the electricity supply, the programmer display
flashes at regular intervals. For setting instructions, see point "10.1 Setting
the time".

39
Instructions for the User
6. DESCRIPTION OF FRONT PANEL CONTROLS
All the appliance's control and monitoring devices are placed together on
the front panel. The table below provides the key to the symbols used.
FUNCTION SELECTOR KNOB
Turn the knob either way to select one
of the following functions:
PIZZA FUNCTION (ON SOME
MODELS ONLY)
BOTTOM HEATING ELEMENT
+ FAN (ON SOME MODELS
ONLY)
TOP + BOTTOM HEATING
ELEMENTS
BOTTOM + ROUND HEATING
ELEMENTS
GRILL ELEMENT + TOP
HEATING ELEMENT
ROUND HEATING ELEMENT
GRILL ELEMENT + FAN TOASTER INTERNAL
HEATING ELEMENTS
A
2
3
4
5

40
Instructions for the User
THERMOSTAT KNOB
The cooking temperature is selected by
turning the knob clockwise to the
required setting, between 50° and
250°C for normal settings and to the
symbol for the pizza oven setting.
THERMOSTAT LIGHT
Lights up to indicate that the oven is
heating up. Goes out when the set
temperature is reached. Flashes at
regular intervals to indicate that the
temperature inside the oven is being
kept constantly at the set level.
ELECTRONIC PROGRAMMER
This electronic device can be used to
programme alarms, cooking times and
oven on/off times. For more information,
see point “10. ELECTRONIC
PROGRAMMER”.
TOASTER PILOT LIGHT
Lights up to indicate that the toaster is
in operation. This light comes on
whenever the function selector knob is
turned to the toast function and goes
out when the knob is turned to zero, at
the end of the cooking time or in any
other function.

41
Instructions for the User
7. USING THE OVEN
7.1 Precautions and General Advice
All cooking operations must be carried out with the door closed.
When the oven and toaster are used for the first time, they should be
heated to the maximum temperature for long enough to burn off any oily
residues left by the manufacturing process, which might contaminate
foods with unpleasant smells.
During cooking, do not cover the bottom of the oven with aluminium
or tin foil, and do not place pans or trays on it; this may damage the
enamel coating. If you wish to use greaseproof paper, position it so
that it does not interfere with the hot air circulation inside the oven.
Oven accessories which may come into contact with foods are made from
materials compliant with directive 89/109/EEC of 21/12/88 and relevant
national regulations.
To avoid unpleasant contact with any steam inside
the oven, open the door in two stages: hold it half-
open (about 5 cm) for 4-5 seconds, then open it
completely. If you have to carry out any procedures
on foods, leave the door open for as short a time as
possible to prevent a drop in the oven temperature
which will impair the cooking results.
To prevent excessive amounts of condensation from forming on the
internal glass, food should not be left inside the oven for too long after
cooking.
7.2 Cooling fan system
The appliance is equipped with a cooling
system which comes into operation as
soon as a cooking function starts.
Operation of the fan generates a normal
air flow which comes out above the door
and may continue for a short time even
after the oven is turned off.
7.3 Inside lights
The oven lights come on when any function is set except for the (Toast)
function.

42
Instructions for the User
8. USING THE PIZZA FUNCTION
This appliance is equipped with a function specially developed for cooking
pizza with the special plate provided. This function is identified by the
symbol on the oven functions knob. To cook a pizza, proceed as described
below.
Set the oven functions knob on the
symbol and the thermostat knob
on the symbol.
Preheat with these settings until the
thermostat light goes out, then place
the pizza on the special plate using
the pizza shovel provided. It does not
normally take more than 3-4 minutes
to cook a pizza to perfection,
although this time may vary depending on the dough used or individual
taste.
8.1 Precautions for using the pizza plate
• Never use the pizza plate except as described above (for example,
never use it on gas or ceramic hobs, or on ovens not designed to take
this accessory).
• For conventional cooking operations, it is advisable to remove the
pizza plate and replace it with the bottom cover provided.
• If you like oil on your pizza, it is best to add it after removal from the
oven since oil stains on the pizza plate are unsightly and may reduce
its efficiency.
Never use any oven function if the pizza plate or cover is not in position.
8.2 To save energy
The pizza stone acts as a heat reservoir. This allows energy consumption
to be reduced, especially in cooking operations requiring medium-long
times. In these cases, simply switch the oven off 10-12 minutes before the
end of the cooking time. The heat gradually emitted by the refractory stone
will ensure that the cooking temperature is maintained.