Solight WO43 User manual

EN Solight WO43 Table Lamp Instructions For Use
Dear customer,
Thank you for buying our product. Carefully read through the following instructions and stick
to them so that the product serves you safely and to your full satisfaction. That way it will
not be used incorrectly and it won't get damaged. Prevent untrained handling of the device
and always adhere to the principles of use of electrical appliances. Carefully store the
instructions for use. Intended for use in the home or inside a room. Never expose to an
environment with a high humidity (for example a bathroom), and prevent the product from
coming into contact with liquid.
Contents of package:Table lamp with LCD display, charging adapter, and instructions for
use. If any of the components are missing contact your salesperson.
Specifications:
Input
DC5V/1A
Luminosity
300lm
Dimensions
145 x 145 x 330mm
Power
7W
Use:
When setting the angle of light always hold the body of the
lamp. The arm of the lamp can be moved at an angle of 180°.
Excess bending of the hinge can lead to damage being
caused.
Switch the lamp on by pressing the ON/OFF button with your
finger. The light intensity can be adjusted using the UP and
DOWN buttons. You can change the temperature of the light
by using the M button. There are 3 preset intensity levels: 1.
Warm white light, 2. Cold white light, and 3. Natural light.
Connect the input connector of the power source to the
input port of the table lamp. Then connect the charging
adapter to the electrical socket.
The body of the lamp can move at an angle of 90°; when
setting up the desired angle always hold the base of the
lamp.

Battery installation:
Setup of date and time:
In the time display mode (TIME icon) press the SET button on the rear side of the lamp. That
gets you into date and time setup mode. The order of setup is as follows: hours-minutes-
years-months-days-save and return to time display mode. By pressing the SET button you
move between individual settings. By using the Up and Down buttons you can set up the
desired values. In order to save the settings press the Mode button or don't press any
buttons for one minute. By pressing the Up button you switch between 12h mode and 24h
mode of time display.
Alarm setup:
In the time display mode press the Mode button. That gets you into alarm time display
mode (ALARM icon). By pressing the SET button you get into alarm setup mode. The order of
settings is as follows: hours-minutes-snooze ringing-melody-save and return to alarm time
display mode. By pressing the SET button you move between individual settings. By using
the Up and Down buttons you set up the desired time and melody. In alarm time display
mode the Up and Down buttons are used to switch on and switch off the alarm function (Zz
icon) and to postpone ringing. The alarm always runs for one minute and then the ringing
gets postponed to the set value. By pressing the Set button or any other button you can
switch the alarm off for 24 hours.
Setup of thermometer:
By pressing the Down button you can switch between °C and °F.
Note: The values displayed by the display of the lamp are indicative and may show
deviations compared to dedicated and calibrated instruments (thermometers, clocks, etc.).
These deviations, if any, are within ±1.8°C for a thermometer and approximately ±5
min/month for a clock. Deviations within these values are not grounds for complaint.
The light source of this luminaire is non-replaceable, at the end of its service life the entire
luminaire must be replaced and disposed of in a designated place. This product contains a
light source that for design reasons cannot be removed for verification and therefore the
entire product is considered a light source. The power cord cannot be replaced if damaged,
the unit must no longer be used.
Manufacturer:Solight Holding, s.r.o., Na Brně 1972, Hradec Králové 500 06, Czech Republic
Open battery
Remove insulation
Insert CR2032 button battery